Optical and scintillation properties of hybrid manganese(II) bromides with formamidinium and acetamidinium cations.

In recent years, hybrid manganese(II) halides (HMHs) have attracted wide attention due to their impressive optical properties, low toxicity, and facile synthetic processibility. Being effective reabsorption-free phosphors, these compounds demonstrate the potential to be used as low-cost solution-processable scintillators. However, most of the HMHs studied to date contain bulk organic cations and, as a result, are characterized by low density and low X-ray stopping power. For this reason, we studied manganese(II) bromides with compact organic cations such as formamidinium (FA+) and acetamidinium (AcA+). In particular, we synthesized four new phases, two of which are characterized by octahedral coordination of manganese ions ((FA)MnBr3 and (AcA)MnBr3) and red emission, whereas the other two have tetrahedrally coordinated Mn2+ ions ((FA)3MnBr5 and (AcA)2MnBr4) and green emission. Photoluminescence (PL) and radioluminescence measurements demonstrated high PL quantum yields and reasonable scintillation light yields of acetamidinium-based compounds. In addition, unlike most known HMH-based scintillators, the discovered materials have a relatively high density due to the small fraction of the volume occupied by organic cations, so their X-ray attenuation coefficients are comparable to the well-known oxide scintillators.

Solution-Processed OLED Based on a Mixed-Ligand Europium Complex.

An approach to increase the efficiency of europium-based OLEDs was proposed through the formation of a mixed-ligand complex. The design of a series of europium complexes, together with an optimization of the solution deposition, including the host selection, as well as the variation of the solvent and deposition parameters, resulted in a noticeable increase in OLED luminance. As a result, the maximum luminance of the Eu-based OLED reached up to 700 cd/m2, which is one of the highest values for an Eu-based solution-processed OLED. Finally, its stability was investigated.

Polymeric Nanoparticles with Embedded Eu(III) Complexes as Molecular Probes for Temperature Sensing.

Three novel luminescent Eu(III) complexes, Eu1-Eu3, have been synthesized and characterized with CHN analysis, mass-spectrometry and 1H NMR spectroscopy. The complexes display strong emission in dichloromethane solution upon excitation at 405 and 800 nm with a quantum yield from 18.3 to 31.6%, excited-state lifetimes in the range of 243-1016 ms at 20 °C, and lifetime temperature sensitivity of 0.9%/K (Eu1), 1.9%/K (Eu2), and 1.7%/K (Eu3). The chromophores were embedded into biocompatible latex nanoparticles (NPs_Eu1-NPs_Eu3) that prevented emission quenching and kept the photophysical characteristics of emitters unchanged with the highest temperature sensitivity of 1.3%/K (NPs_Eu2). For this probe cytotoxicity, internalization dynamics and localization in CHO-K1 cells were studied together with lifetime vs. temperature calibration in aqueous solution, phosphate buffer, and in a mixture of growth media and fetal bovine serum. The obtained data were then averaged to give the calibration curve, which was further used for temperature estimation in biological samples. The probe was stable in physiological media and displayed good reproducibility in cycling experiments between 20 and 40 °C. PLIM experiments with thermostated CHO-K1 cells incubated with NPs_Eu2 indicated that the probe could be used for temperature estimation in cells including the assessment of temperature variations upon chemical shock (sample treatment with mitochondrial uncoupling reagent).

Eu(tta)3DPPZ-based organic light-emitting diodes: spin-coating vs. vacuum-deposition.

The effect of the emission layer deposition method on the characteristics of OLEDs was studied on the example of the europium mixed-ligand complex Eu(tta)3DPPZ (tta: 2-thenoyltrifluoroacetone, DPPZ: dipyrido[3,2-a:2'c,3'c-c]phenazine). The maximum brightnesses of both OLEDs almost coincided, though OLED based on the spin-coated layer operated at lower voltages. The reason for that was the higher density and smoothness of the solution-processed layer.

Luminescent organic dyes containing a phenanthro[9,10-D]imidazole core and [Ir(N

A family of diimine (N^N) and cyclometalating (N^C) ligands based on a phenanthro-imidazole aromatic system: 2-pyridyl-1H-phenanthro[9,10-d]imidazole (N^N); 2-R-1-phenyl-1H-phenanthro[9,10-d]imidazole, R = phenyl (N^C4), 3-iodophenyl (N^C5) and 4-nitrophenyl (N^C6) were prepared. It was found that N^C4 and N^C5 show π-π* fluorescence typical of aromatic systems of this sort, whereas the donor-acceptor architecture of N^C6 leads to strong emission solvatochromism and acidochromism, indicating the charge transfer character of the fluorescence observed. Six iridium(iii) complexes (1-6) [Ir(N^C#)2(N^N)]+, where # = 1-6 and N^C1 = 2-phenylpyridine, N^C2 = 2-(benzo[b]thiophen-2-yl)pyridine, and N^C3 = methyl 2-phenylquinoline-4-carboxylate, were also synthesized and characterized. The complexes obtained display moderate to bright phosphorescence with quantum yields up to 46% in degassed solution. The photophysical characteristics of 1-6 were studied in detail. DFT and TD DFT calculations were used for the assignment of electronic transitions responsible for the absorption and emission of these compounds. The variations in the cyclometalating ligand structure give rise to rich photophysics of the complexes obtained. It was found that the orbitals of both N^C and N^N ligands make a major contribution to the formation of emissive excited states and a delicate balance between the energy of the ligands' frontier orbitals determines the emission character.