RESUMEN
Carbon dross, a hazardous solid waste generated during aluminum electrolysis, contains large amounts of soluble fluoride ions for the main components of the electrolyte (such as Na3AlF6 and NaF). Response surface methodology (RSM) was used to investigate the mechanism for fluoride ion leaching from carbon dross via water leaching, acid leaching and alkali leaching, and the kinetic and thermodynamic principles of the leaching process were revealed. The RSM predicted the optimum conditions of water leaching, alkali leaching and acid leaching, and the conditions are as follows: temperature, 50 °C; shaking speed, 213 r·min-1; particle size, 0.075 mm; shaking speed, 194 r·min-1; liquid-solid ratio, 12.6 mg·L-1; sodium hydroxide concentration, 1.53 mol·L-1; liquid-solid ratio, 25.0 mg·L-1; sulfuric acid concentration, 2.00 mol·L-1; and temperature, 60 °Cï¼and actual results which were almost consistent with the predicted results were gained. The fluoride ions in the alkaline and acid leaching solutions were mainly the dissociation products of fluorides such as Na3AlF6, Na5Al3F14 and CaF2, as indicated by thermodynamics calculations. In particular, the fluoride compounds dissolved in alkali solution were Na3AlF6, Na5Al3F14, AlF3, ZrF4, K3AlF6, while the acid solution could dissolve only Na3AlF6 and CaF2. The leaching kinetics experiments showed that the leaching rate fit the unreacted shrinking core model [1-2/3α-(1-α)2/3 =kt] and that the leaching process was controlled by internal diffusion. This study provides theoretical guidance for the removal of soluble fluoride ions from carbon dross and will also assist in the separation of electrolytes from carbon dross. ENVIRONMENTAL IMPLICATION: Carbon dross, a hazardous waste generated during the aluminum electrolysis production process, contains a large amount of soluble fluoride. Improper storage will lead the fluoride ions pollution in soil, surface water or groundwater under the direct contact between carbon dross and rainfall, snow or surface runoff. The influence of wind will cause carbon dross dust to pollute further areas. With the human body long-term contact with fluoride ion contaminated soil or water, human health will be seriously harmed.
RESUMEN
In recent years, significant efforts have been made to study changes in the levels of air pollutants at regional and urban scales, and changes in bioaerosols during air pollution events have attracted increasing attention. In this study, the bacterial structure of PM2.5 was analysed under different environmental conditions during hazy and non-hazy periods in Guilin. A total of 32 PM2.5 samples were collected in December 2020 and July 2021, and the microbial community structures were analysed using high-throughput sequencing methods. The results show that air pollution and climate change alter the species distribution and community diversity of bacteria in PM2.5, particularly Sphingomonas and Pseudomonas. The structure of the bacterial community composition is related to diurnal variation, vertical height, and urban area and their interactions with various environmental factors. This is a comprehensive study that characterises the variability of bacteria associated with PM2.5 in a variety of environments, highlighting the impacts of environmental effects on the atmospheric microbial community. The results will contribute to our understanding of haze trends in China, particularly the relationship between bioaerosol communities and the urban environment. Supplementary Information: The online version contains supplementary material available at 10.1007/s10453-022-09777-0.
RESUMEN
Discharging waste water from the bauxite desilication process will bring potential environmental risk from the residual ions and organic compounds, especially hydrolyzed polyacrylamide. Characterization of the microbial community diversity in waste water plays an important role in the biological treatment of waste water. In this study, eight waste water samples from five flotation plants in China were investigated. The microbial community and functional profiles within the waste water were analyzed by a metagenomic sequencing method and associated with geochemical properties. The results revealed that Proteobacteria and Firmicutes were the dominant bacterial phyla. Both phylogenetical and clusters of orthologous groups' analyses indicated that Tepidicella, Paracoccus, Pseudomonas, and Exiguobacterium could be the dominant bacterial genera in the waste water from bauxite desilication process for their abilities to biodegrade complex organic compounds. The results of the microbial community diversity and functional gene compositions analyses provided a beneficial orientation for the biotreatment of waste water, as well as regenerative using of water resources. Besides, this study revealed that waste water from bauxite desilication process was an ideal ecosystem to find novel microorganisms, such as efficient strains for bio-desilication and bio-desulfurization of bauxite.
Asunto(s)
Microbiota , Purificación del Agua , Óxido de Aluminio , Aguas Residuales , Bacterias/genética , Microbiota/genéticaRESUMEN
Guilin, a famous tourist city, is located in northeast Guangxi Province of Southwest China. However, recently, abnormal haze events occurred frequently in the winter. To characterize inorganic elements in PM2.5 and associated sources during a winter haze episode, 30 samples were collected from 6 sites in Guilin from December 16 to 20, 2016, and 24 inorganic elements were measured using an inductively coupled plasma mass spectrometer. The results showed that the sum of 24 inorganic elements varied from 5.47 ± 0.45 to 9.26 ± 0.73 µg m-3, and accounting for 6.81% ± 13.35% to 8.63% ± 15.05% of PM2.5 at all sites. Among them, crustal elements, including K, Ca, Na, Mg, Al, Fe, and Ti contributed approximately 82% ± 6%-90% ± 3%. Cluster results combined the coefficient of divergence and hierarchical cluster for inorganic elements and the sites showed that YS designated as the background site had obvious spatial heterogeneity, specially, mass concentration, and Igeo (index of geoaccumulation) values of Ni, Cr, Mo, and Ba were higher than those at the other five sites, which indicating that PM2.5 in Guilin was significantly affected by interregional transport. The results of source apportionment showed that Al, Ti, B, Fe, Ca, Mg, and Cr were derived from road and building dust, whereas Sb, As, and Hg originated from coal combustion, Co and V from vehicle emission (such as diesel and gasoline combustion), and other metals (Zn, Pb, Mn, Ba, Cu, Ni, Se, Cd, Mo, Tl, K, and Na) from coal combustion and industrial processes.
Asunto(s)
Contaminantes Atmosféricos/análisis , Monitoreo del Ambiente/métodos , Metales/análisis , Material Particulado/análisis , Emisiones de Vehículos/análisis , China , Ciudades , Carbón Mineral/análisis , Polvo/análisis , Industrias , Estaciones del Año , Análisis EspacialRESUMEN
A 5-day PM2.5 sampling campaign was conducted during a typical haze episode from December 16 to 20, 2016, at five urban sites and one background site in Guilin, a famous tourist city in Southern China. A total of 30 PM2.5 samples were collected, and water-soluble inorganic ions (WSII) (SO42-, NO3-, NH4+, Ca2+, K+, Cl-, Na+, and Mg2+) were determined using ion chromatography. Correlation analysis, principal component analysis, and coefficient of divergence were applied to identify the formation mechanisms of secondary inorganic ions, potential sources, and spatial distribution of WSII. The average mass concentrations of PM2.5 at each sampling site were 71.6-127.85 µg m-3, which were more than the National Ambient Air Quality Standard (GB3095-2012, GradeII (35 µg m-3)) in China. SO42- NO3-, and NH4+ were the major WSII, accounting for 34.43-40.59% of PM2.5 mass. NO3-/SO42- ratio revealed that stationary sources-induced PM2.5 was still remarkable. Cl-/Na+ ratio and their strong correlation (r = 0.824) indicated that atmospheric transport from outside urban region played an effective role during the haze episode. Spatial variations of WSII are not pronounced at five urban sites except the background site. High relative humidity and O3 contributed to evidently influence the transformation of SO2 to SO42- but not obvious to NOx oxidation. Finally, the major sources of WSII are identified as the mixture of sea salt, coal combustion, biomass burning, vehicle exhaust and agricultural emissions (66.892%), and fugitive sources (19.7%).
Asunto(s)
Contaminantes Atmosféricos/análisis , Contaminación del Aire/análisis , Monitoreo del Ambiente/métodos , Material Particulado/análisis , Emisiones de Vehículos/análisis , Aerosoles , China , Carbón Mineral/análisis , Iones/análisis , Estaciones del Año , Análisis Espacial , Agua/químicaRESUMEN
A novel and simple two-step solution approach to prepare ZnO thin film consisted of 3D flower-like superstructure was demonstrated. The uniform, nano-dimensional scale and sphere-like ZnO crystals were first prepared on the borosilicate glass substrate in mild solution at 95 degrees C for 3 h, then introduced into 0.02 mol L(-1) hexamethylenetetramine (HMT, C6H12N4) aqueous solution and heated at the same temperature for 3 d. The obtained ZnO thin films were characterized by XRD, SEM and photoluminescence. The results indicated that the thin film with 3D flower-like superstructure possessed high crystallinity, high surface-volume ratio microstructure and excellent photoluminescence property. It is a potential way to prepare nano-structured materials by the mentioned simple and novel two-step solution synthesis process.
RESUMEN
ZnO nanorods and nanodisks were synthesized by solution process using zinc chloride as starting material. The morphology of ZnO crystal changed greatly depending on the concentrations of Zn(2+) ion and ethylene glycohol (EG) additive in the solution. The effect of thermal treatment on the morphology was investigated. Photocatalytic activities of plate-like Zn(5)(OH)(8)Cl(2) . H(2)O and rod-like ZnO were characterized. About 18% of 1 ppm NO could be continuously removed by ZnO particles under UV light irradiation.