Differential cytotoxic effects on odontoblastic cells induced by self-adhesive resin cements as a function of the activation protocol.

OBJECTIVES: To evaluate the cytotoxic effects of exposing odontoblast cells to a variety of commercial self-adhesive cements polymerized using different activation modes. METHODS: Five cements: MaxCem Elite (MAX), Bifix SE (BSE), G-Cem LinkAce (GCE), Clearfil SA Luting (CAS), and RelyX U200 (U200) were mixed, dispensed into molds, and distributed in groups, according to polymerization protocols: immediate photoactivation; delayed photoactivation (10min self-curing plus light-activation); and chemical activation (no light exposure). Immortalized rat odontoblast cells (MDPC-23) were cultured. Cell viability was assessed by Trypan Blue staining and total cell death was assessed by annexin V-APC/7-AAD double staining and flow cytometry. Volatilized compounds from polymerized specimens of cements were evaluated by gas chromatography/mass spectrometry (GC-MS). Data was analyzed with 2-way ANOVA/Tukey tests (α=0.05). RESULTS: Exposure to all of the cements tested significantly reduced the cell viability, irrespective of the activation protocol (p<0.05). The least harmful cements were CSA and U200. Total death of cells significantly increased when exposed to BSE, GCE, and MAX, especially when chemically activated (p<0.05). Characteristic apoptotic cells increased after exposure to cements, mainly for MAX, regardless of the activation mode. Chemical activation of MAX also induced necrosis. Moreover, GCE and MAX exhibited higher percentages of late apoptotic/dead cells. Chromatograms revealed 28 compounds released from the cements tested, some of them with known carcinogenic effects. Selection of self-adhesive cements and polymerization protocols affect the cytotoxicity and cell viability of odontoblastic cells. CLINICAL SIGNIFICANCE: Despite the simplified cementation protocol, care is needed when cementing indirect restorations with self-adhesive cements, especially on recently exposed dentin. This category of material may cause differential cytotoxic effects and should be considered when selecting a cement. This is particularly true in clinical cases of light attenuation, where the polymerization depends on chemical activation, inducing higher cytotoxic damages when using some of the cements tested.

Electrospray ionization mass spectrometry fingerprinting of perfumes: Rapid classification and counterfeit detection.

A fast procedure to classify perfumes and identify counterfeit samples is described. Dilution of a few microL of the sample in a 1:1 methanol/water solution is followed by detection of its major polar components via direct infusion electrospray ionization mass spectrometry (ESI-MS) in the positive ion mode. As proof-of-principle cases, three famous brands of perfumes were used. The ESI+-MS fingerprints of authentic samples were very characteristic, showing distinctive sets of polar markers for each sample. Principal component analysis (PCA) placed samples of the three perfume brands in well-defined groups. Counterfeit samples were also clearly detected owing to contrasting ESI-MS fingerprints, with PCA placing these samples far away from the authentic samples.