RESUMEN
Fiber-coupled microdisks are a promising platform for enhancing the spontaneous emission from color centers in diamond. The measured cavity-enhanced emission from the microdisk is governed by the effective volume (V) of each cavity mode, the cavity quality factor (Q), and the coupling between the microdisk and the fiber. Here we observe room temperature photoluminescence from an ensemble of nitrogen-vacancy centers into high Q/V microdisk modes, which when combined with coherent spectroscopy of the microdisk modes, allows us to elucidate the relative contributions of these factors. The broad emission spectrum acts as an internal light source facilitating mode identification over several cavity free spectral ranges. Analysis of the fiber taper collected microdisk emission reveals spectral filtering both by the cavity and the fiber taper, the latter of which we find preferentially couples to higher-order microdisk modes. Coherent mode spectroscopy is used to measure Q â¼ 1 × 105 - the highest reported values for diamond microcavities operating at visible wavelengths. With realistic optimization of the microdisk dimensions, we predict that Purcell factors of â¼50 are within reach.
RESUMEN
Manipulating the composition of a mixed alkylthiol self-assembled monolayer (SAM) modified gold surface using both electrochemical and electroless methods is demonstrated. Through the use of fluorophore labeled thiolated DNA and in situ fluorescence microscopy with a gold single crystal bead electrode, a procedure was developed to study and quantify the selective desorption of an alkylthiolate SAM. This method enabled a self-consistent measurement of the removal of the SAM from the 111 surface compared to the 100 surface region at various potentials. A 20-fold increase in the electrochemical removal and replacement of the SAM from the 111 surface over the 100 surface was realized at -0.8 V/AgAgCl. A related procedure was developed for the solution-based electroless removal of the SAM using NaBH4 achieving a similar selectivity at the same potential. Unfortunately, in the electroless process fine control over the reducing potential was difficult to achieve. In addition, working in the presence of O2 complicates the solution potential measurement due to depolarization by the reduction of O2, resulting in a less clear relationship between selectivity and measured solution potential. Interestingly, the electrochemical method was not disturbed by the presence of O2. In preparation for work with Au nanorods, electrochemical measurements were performed in electrolyte that included 1 mM CTAB and was found to not interfere with this method. Preliminary results are promising for using this methodology for treatment of acid-terminated alkylthiol modified Au nanorods.