Mechanochemical hydroquinone regeneration promotes gold salt reduction in sub-stoichiometric conditions of the reducing agent.

Bottom-up mechanochemical synthesis (BUMS) has been demonstrated to be an efficient approach for the preparation of metal nanoparticles (NPs), protected by surface agents or anchored on solid supports. However, there are limitations, such as precise size and morphological control, due to a lack of knowledge about the mechanically induced processes of NP formation under milling. In this article, we further investigate the BUMS of AuNPs. Using SiO2 as a solid support, we studied the effect of typical reducing agents, namely NaBH4, L-ascorbic acid, and hydroquinone (HQ), on the conversion of a AuIII source. XANES showed that HQ is the strongest reducing agent under our experimental conditions, leading to the quantitative conversion of gold salt in a few minutes. Interestingly, even when HQ was used in sub-stoichiometric amounts, AuIII could be reduced to ratios higher than 85% after two minutes of milling. Investigations into the byproducts by 1H NMR and GC-FID/MS enabled the identification HQ regeneration and the formation of its derivatives. We mainly focused on benzoquinone (BQ), which is the product of the oxidation of HQ as it reduces the gold salt. We could demonstrate that HQ is regenerated from BQ exclusively under milling and acidic conditions. The regenerated HQ and other HQ-chlorinated molecules could then reduce gold-oxidized species, leading to higher conversions and economy of reactants. Our study highlights the intriguing and complex mechanisms of mechanochemical systems, in addition to fostering the atom and energy economy side of mechanochemical means to produce metal nanoparticles.

Biofragmentation of Polystyrene Microplastics: A Silent Process Performed by Chironomus sancticaroli Larvae.

Polystyrene (PS) is one of the main synthetic polymers produced around the world, and it is present in the composition of a wide variety of single-use objects. When released into the environment, these materials are degraded by environmental factors, resulting in microplastics. We investigated the ability of Chironomus sancticaroli (Diptera, Chironomidae) to promote the fragmentation of PS microspheres (24.5 ± 2.9 µm) and the toxic effects associated with exposure to this polymer. C. sancticaroli larvae were exposed to 3 different concentrations of PS (67.5, 135, and 270 particles g-1 of dry sediment) for 144 h. Significant lethality was observed only at the highest concentration. A significant reduction in PS particle size as well as evidence of deterioration on the surface of the spheres, such as grooves and cracks, was observed. In addition, changes in oxidative stress biomarkers (SOD, CAT, MDA, and GST) were also observed. This is the first study to report the ability of Chironomus sp. to promote the biofragmentation of microplastics. The information obtained demonstrates that the macroinvertebrate community can play a key role in the degradation of plastic particles present in the sediment of freshwater environments and can also be threatened by such particle pollution.

An Overview on the Development of Electrochemical Capacitors and Batteries - part II.

In the second part of the review on electrochemical energy storage, the devolvement of batteries is explored. First, fundamental aspects of battery operation will be given, then, different materials and chemistry of rechargeable batteries will be explored, including each component of the cell. In negative electrodes, metallic, intercalation and transformation materials will be addressed. Examples are Li or Na metal batteries, graphite and other carbonaceous materials (such as graphene) for intercalation of metal-ions and transition metal oxides and silicon for transformation. In the positive electrode section, materials for intercalation and transformation will be reviewed. The state-of-the-art on intercalation as lithium cobalt oxide and nickel containing oxides will be approached for intercalation materials, whereas sulfur and metal-air will also be explored for transformation. Alongside, the role of electrolyte will be discussed concerning performance and safety, with examples for the next generation devices. Finally, a general future perspective will address both electrochemical capacitors and batteries.

An Overview on the Development of Electrochemical Capacitors and Batteries - Part I.

The Nobel Prize in Chemistry 2019 recognized the importance of Li-ion batteries and the revolution they allowed to happen during the past three decades. They are part of a broader class of electrochemical energy storage devices, which are employed where electrical energy is needed on demand and so, the electrochemical energy is converted into electrical energy as required by the application. This opens a variety of possibilities on the utilization of energy storage devices, beyond the well-known mobile applications, assisting on the decarbonization of energy production and distribution. In this series of reviews in two parts, two main types of energy storage devices will be explored: electrochemical capacitors (part I) and rechargeable batteries (part II). More specifically, we will discuss about the materials used in each type of device, their main role in the energy storage process, their advantages and drawbacks and, especially, strategies to improve their performance. In the present part, electrochemical capacitors will be addressed. Their fundamental difference to batteries is explained considering the process at the electrode/electrolyte surface and the impact in performance. Materials used in electrochemical capacitors, including double layer capacitors and pseudocapacitive materials will be reviewed, highlighting the importance of electrolytes. As an important part of these strategies, synthetic routes for the production of nanoparticles will also be approached (part I).