Real-Time Synthetic Aperture Radar Imaging with Random Sampling Employing Scattered Power Mapping.

A novel image-reconstruction method is proposed for the processing of data acquired at random spatial positions. The images are reconstructed and updated in real time concurrently with the measurements to produce an evolving image, the quality of which is continuously improving and converging as the number of data points increases with the stream of additional measurements. It is shown that the images converge to those obtained with data acquired on a uniformly sampled surface, where the sampling density satisfies the Nyquist limit. The image reconstruction employs a new formulation of the method of scattered power mapping (SPM), which first maps the data into a three-dimensional (3D) preliminary image of the target on a uniform spatial grid, followed by fast Fourier space image deconvolution that provides the high-quality 3D image.

Interconnect for Dense Electronically Scanned Antenna Array Using High-Speed Vertical Connector.

We present the design and the performance evaluation of a new interconnect for large-scale densely packed electronically scanned antenna arrays that utilize a high-speed digital board-to-board vertical connector. The application targets microwave tissue, imaging in the frequency range from 3 GHz to 8 GHz. The tissue-imaging arrays consist of hundreds of active antenna elements, which require low-reflection, low-loss, and low-crosstalk connections to their respective receiving and transmitting circuits. The small antenna size and the high array density preclude the use of coaxial connectors, which are also expensive and mechanically unreliable. Modern board-to-board high-speed connectors promise bandwidths as high as 12 GHz, along with high pin density, mechanical robustness, and low cost. However, their compatibility with the various transmission lines leading to/from the miniature printed antenna elements and microwave circuitry is not well studied. Here, we focus on the design of the transitions from coplanar waveguide transmission lines to/from a high-speed vertical connector. The performance of the interconnect is examined through electromagnetic simulations and measurements. Comparison is carried out with the expensive sub-miniature push-on sub-micro coaxial connectors commonly used in miniature radio-frequency electronics. The results demonstrate that high-speed vertical connectors can provide comparable performance in the UWB frequency range.

Ka Band Holographic Imaging System Based on Linear Frequency Modulation Radar.

Millimeter wave (MMW) technology is expanding rapidly into security screening for dangerous items concealed under clothing. It uses safe non-ionizing radiation and penetrates clothing well. We present a new planar system at Ka band for the three-dimensional simultaneous imaging of both sides of an inspected person where the images are produced in real time by a recently proposed generalized holographic reconstruction algorithm. Low-cost linear frequency modulation (LFM) radar technology is used along with a simple but efficient method for system calibration. Experimental characterization of the spatial resolution and the sensitivity of the system prototype has been carried out. It is established that the achieved spatial resolution is 6 mm or better if the item is not obscured by clothing and it may deteriorate to 7 mm depending on the clothing hiding the item. The spatial sensitivity is confirmed to be at least 2 mm.

Active Sensor for Microwave Tissue Imaging with Bias-Switched Arrays.

A prototype of a bias-switched active sensor was developed and measured to establish the achievable dynamic range in a new generation of active arrays for microwave tissue imaging. The sensor integrates a printed slot antenna, a low-noise amplifier (LNA) and an active mixer in a single unit, which is sufficiently small to enable inter-sensor separation distance as small as 12 mm. The sensor’s input covers the bandwidth from 3 GHz to 7.5 GHz. Its output intermediate frequency (IF) is 30 MHz. The sensor is controlled by a simple bias-switching circuit, which switches ON and OFF the bias of the LNA and the mixer simultaneously. It was demonstrated experimentally that the dynamic range of the sensor, as determined by its ON and OFF states, is 109 dB and 118 dB at resolution bandwidths of 1 kHz and 100 Hz, respectively.

Three-dimensional near-field microwave holography for tissue imaging.

This paper reports the progress toward a fast and reliable microwave imaging setup for tissue imaging exploiting near-field holographic reconstruction. The setup consists of two wideband TEM horn antennas aligned along each other's boresight and performing a rectangular aperture raster scan. The tissue sensing is performed without coupling liquids. At each scanning position, wideband data is acquired. Then, novel holographic imaging algorithms are implemented to provide three-dimensional images of the inspected domain. In these new algorithms, the required incident field and Green's function are obtained from numerical simulations. They replace the plane (or spherical) wave assumption in the previous holographic methods and enable accurate near-field imaging results. Here, we prove that both the incident field and Green's function can be obtained from a single numerical simulation. This eliminates the need for optimization-based deblurring which was previously employed to remove the effect of realistic non-point-wise antennas.

Nonradiating electromagnetic sources in a nonuniform medium.

Nonradiating electromagnetic sources are sources whose field is identically zero outside of their volume. They are undetectable unless the observation point is in direct contact with them. They are the basis of the theory of source equivalence, which studies the field invariance with respect to source transformations. In this work, we focus on the equivalent source transformations in a nonuniform medium and the implications in the theory of the electromagnetic vector potentials. We identify three types of nonradiating sources. Subsequently, we define the mathematical transformations of the sources, which preserve the field outside of their support (source invariance). We give complimentary expressions, which preserve the field inside the source support as well. We show that the nonuniqueness of the electromagnetic potentials is due to the nonunique solution to the inverse problem. The well known field gauge invariance follows from its source invariance. Also, the gauge-invariant transformation appears to be just one possibility in an infinite set of field-invariant vector-potential representations all related to the respective equivalent source transformations.