Effects of Operating Mechanical Conditions and Polymer Networks of Nematic Elastomers on Photo-Induced Mechanical Performances.

Photoresponsive liquid-crystalline elastomers (LCEs) are promising candidates for light-controlled soft actuators. Photoinduced stress/strain originates from the changes in mechanical properties after light irradiation. However, the correlation between the photoinduced mechanical performance and in-use conditions such as stress/strain states and polymer network properties (such as effective crosslink density and dangling chain density) remains unexplored for practical applications. Here, isometric photo-induced stress or isotonic strain is investigated at different operating strains or stresses, respectively, on LCEs with polymer network variations, produced by different amounts of solvent during polymerization. As the solvent volume increases, the moduli and photoinduced stresses decrease. However, the photo-induced strain, fracture strain, fracture stress, and viscosity increase. The optical response performance initially increases with the operating strain/stress, peaks at a higher actuation strain/stress, and then, decreases depending on the polymer network. The maximum work densities, which also depend on the operating stress, are in the range of ≈200-300 kJm-3. These findings, highlighting the significant variations in the mechanical performance with the operating stress/strain ranges and amount of solvent used in the synthesis, are critical for designing LCE-based mechanical devices.

Photo-controllable azobenzene microdroplets on an open surface and their application as transporters.

The control of droplet motion is a significant challenge, as there has been no simple method for effective manipulation. Utilizing light for the control of droplets offers a promising solution due to its non-contact nature and high degree of controllability. In this study, we present our findings on the translational motion of pre-photomelted droplets composed of azobenzene derivatives on a glass surface when exposed to UV and visible light sources from different directions. These droplets exhibited directional and continuous motion upon light irradiation and this motion was size-dependent. Only droplets with diameters less than 10 µm moved with a maximum velocity of 300 µm min-1. In addition, the direction of the movement was controllable by the direction of the light. The motion is driven by a change in contact angle, where UV or visible light switched the contact angle to approximately 50° or 35°, respectively. In addition, these droplets were also found to be capable carriers for fluorescent quantum dots. As such, droplets composed of photoresponsive molecules offer unique opportunities for designing novel light-driven open-surface microfluidic systems.