RESUMEN
Injection molding technology is widely utilized across various industries for its ability to fabricate complex-shaped components with exceptional dimensional accuracy. However, challenges related to injection quality often arise, necessitating innovative approaches for improvement. This study investigates the influence of surface roughness on the efficiency of conformal cooling channels produced using additive manufacturing technologies, specifically Direct Metal Laser Sintering (DMLS) and Atomic Diffusion Additive Manufacturing (ADAM). Through a combination of experimental measurements, including surface roughness analysis, scanning electron microscopy, and cooling system flow analysis, this study elucidates the impact of surface roughness on coolant flow dynamics and pressure distribution within the cooling channels. The results reveal significant differences in surface roughness between DMLS and ADAM technologies, with corresponding effects on coolant flow behavior. Following that fact, this study shows that when cooling channels' surface roughness is lowered up to 90%, the reduction in coolant media pressure is lowered by 0.033 MPa. Regression models are developed to quantitatively describe the relationship between surface roughness and key parameters, such as coolant pressure, Reynolds number, and flow velocity. Practical implications for the optimization of injection molding cooling systems are discussed, highlighting the importance of informed decision making in technology selection and post-processing techniques. Overall, this research contributes to a deeper understanding of the role of surface roughness in injection molding processes and provides valuable insights for enhancing cooling system efficiency and product quality.
RESUMEN
The ever-present risk of surgical items being retained represents a real medical peril for the patient and potential liability issues for medical staff. Radiofrequency scanning technology is a very good means to substantially reduce such accidents. Radiolucent medical-grade polyvinyl chloride (PVC) used for the production of medical items is filled with radiopaque agents to enable X-ray visibility. The present study proves the suitability of bismuth oxychloride (BiOCl) and documents its advantages over the classical radiopaque agent barium sulfate (BaSO4). An addition of BiOCl exhibits excellent chemical and physical stability (no leaching, thermo-mechanical properties) and good dispersibility within the PVC matrix. As documented, using half the quantity of BiOCl compared to BaSO4 will provide a very good result. The conclusions are based on the methods of rotational rheometry, scanning electron microscopy, dynamic mechanical analysis, atomic absorption spectroscopy, and the verification of zero leaching of BiOCl out of a PVC matrix. X-ray images of the studied materials are presented, and an optimal concentration of BiOCl is evaluated.
RESUMEN
Post-process thermal treatment of electrospun fibers obtained from poly(ethylene oxide) (PEO) water and methanol solutions was examined. PEO fibers from methanol solution showed larger diameters as observed by scanning electron microscopy. Fibers both from water and methanol solutions exhibited a significant dimensional stability and surface cracking during the specific exposure time after thermal treatments at 40, 50, and 60 °C. Changes in crystallinity after the thermal treatment were studied by wide-angle X-ray diffraction. The kinetics of secondary crystallization were positively influenced by the as-processed level of the amorphous phase and temperature of thermal treatment. Samples treated at 60 °C were degraded by thermooxidation within the time.
RESUMEN
Two types of ionic liquids, 1-ethyl-3-methylimidazolim acetate and 1-ethyl-3-methylimidazolium lactate, were employed for the direct processing of pine wood into microfibers. The concentration of 5 wt.% of wood in ionic liquids was rated as the most appropriate for electrospinning. The fibers were electrospun into the collector water bath. The final structure varied from individual microfibers to fiber bundles. It was demonstrated that 1-ethyl-3-methylimidazolium lactate is a powerful solvent and provides the direct transformation of pristine pine wood into the non-wovens.