RESUMEN
The drawbacks of common anodes in lithium-ion batteries (LIBs) and hybrid supercapacitors (HSCs), such as the high voltage plateau of Li4Ti5O12 (1.55 V vs. Li/Li+) and the moderate capacity of graphite (372 mAh-g-1), have established a need for better materials. Conversion materials, and in particular iron oxide and CaFe2O4 (CFO), have amassed recent attention as potential anode replacements. In this study, we evaluate the material and electrochemical effects of the solution combustion synthesis (SCS) of porous CFO across novel fuel-to-oxidizer ratios and calcination temperatures. We demonstrate that nearly doubling the amount of fuel used during synthesis increases capacities between 120 and 150% at high current densities (~ 1000 mA-g-1) and across 500 additional charging-discharging cycles, an effect brought on in part by enhanced compositional purity in these samples. However, in order to ensure long-term cyclic stability, it is necessary to also calcine porous CFO to 900 °C to enhance crystallite size, particle size and spacing, and compositional purity.
RESUMEN
BACKGROUND AND PURPOSE: Knowledge-based planning (KBP) is based on a model to estimate dose-volume histograms, configured using a library of historical treatment plans to efficiently create high quality plans. The aim was to report configuration and validation of KBP for Volumetric Modulated Arc Therapy of cervical cancer. MATERIALS AND METHODS: A KBP model was configured from the institutional database (n = 125), including lymph node positive (n = 60) and negative (n = 65) patients. KBP Predicted plans were compared with Clinical Plans (CP) and Re-plans (Predicted plan as a base-plan) to validate the model. Model quality was quantified using coefficient of determination R2, mean square error (MSE), standard two-tailed paired t-test and Wilcoxon signed rank test. RESULTS: Estimation capability of the model was good for the bowel bag (MSE = 0.001, R2 = 0.84), modest for the bladder (MSE = 0.008) and poor for the rectum (MSE = 0.02 R2 = 0.78). KBP resulted in comparable target coverage, superior organ sparing as compared to CP. Re-plans outperformed CP for the bladder, V30 (66 ± 11% vs 74 ± 11%, p < .001), V40 (48 ± 14% vs 52 ± 14%, p < .001), however sparing was modest for the bowel bag V30 (413 ± 191cm3 vs 445 ± 208cm3, p = .037) V40 (199 ± 105cm3 vs 218 ± 127cm3, p = .031). All plans were comparable for rectum, while KBP resulted in significant sparing for spinal cord, kidneys and femoral heads. CONCLUSION: KBP yielded comparable and for some organs superior performance compared to CP resulting in conformal and homogeneous target coverage. Improved organ sparing was observed when individual patient geometry was considered.
RESUMEN
One of the ways to mitigate the world energy crisis is to harvest clean and green energy from waste-heat, which is abundant, ubiquitous, and free. Energy harvesting of this waste-heat is one of the most encouraging methods to capture freely accessible electrical energy. Ferroelectric materials can be used to harvest energy for low power electronic devices, as they exhibit switchable polarization, excellent piezoelectric and pyroelectric properties. The most important characteristic of ferroelectric materials, in the context of energy harvesting, is their ability to generate electric power from a time-dependent temperature change. In this work, we grew highly c-axis oriented heterostructures of BaZr0.2Ti0.8O3 (barium zirconium titanate, BZT)/Ba0.7Ca0.3TiO3 (barium calcium titanate, BCT) on SrRuO3 (strontium ruthenate, SRO) and deposited on SrTiO3 (strontium titanate, STO) single crystalline substrate using pulsed laser deposition (PLD) technique. We investigated the structural, electrical, dielectric, and pyroelectric properties of the above-mentioned fabricated heterostructures. The wide range of θ-2θ X-ray diffraction (XRD) patterns only shows (00l) reflection peaks of heterostructures and the substrate which confirmed that the films are highly c-axis oriented. We are also capable to convert the low-grade waste-heat into electrical energy by measuring various temperature-dependent ferroelectric hysteresis loops of our nanostructure films via pyroelectric Ericsson cycles and the structures show an energy conversion density ~ 10,970 kJ/m3 per cycle. These devices exhibit a large pyroelectric current density of ~ 25 mA/m2 with 11.8 °C of temperature fluctuation and the corresponding pyroelectric coefficient of 3425 µC/m2K. Our research findings suggest that these lead-free relaxor-ferroelectric heterostructures might be the potential candidates to harvest electrical energy from waste low-grade thermal energy.
RESUMEN
An amendment to this paper has been published and can be accessed via a link at the top of the paper.
RESUMEN
Combining two materials in a nanoscale level can create a composite with new functionalities and improvements in their physical and chemical properties. Here we present a high-throughput approach to produce a nanocomposite consisting of metal nanoparticles and semiconductor oxide nanostructures. Volmer-Weber growth, though unfavorable for thin films, promotes nucleation of dense and isolated metal nanoparticles on crystalline oxide nanostructures, resulting in new material properties. We demonstrate such a growth of Au nanoparticles on SnO2 nanostructures and a remarkable sensitivity of the nanocomposite for detecting traces of analytes in surface enhanced Raman spectroscopy. Au nanoparticles with tunable size enable us to modify surface wettability and convert hydrophilic oxide surfaces into super-hydrophobic with contact angles over 150°. We also find that charge injection through electron beam exposure shows the same effect as photo-induced charge separation, providing an extra Raman enhancement up to an order of magnitude.
RESUMEN
The metal-to-insulator transition (MIT) closest to room temperature of 68-70 °C as shown by vanadium oxide (VO2), compared with other transition metal oxides, makes it a potential candidate for smart window coating. We have successfully fabricated a potential smart window device after the optimum design of a multilayered thin film structure made out of transparent conducting oxide (aluminum doped zinc oxide) and pure VO2 using pulsed laser deposition technique. This comprehensive study is based on two different configurations for multi-layered structure approach, with the intention to reduce the transition temperature, as well as to maintain the MIT properties that would strengthen the potential of the structure to be used for a smart window device. By creating a multi-layered structure, we were able to create a low powered device that can operate less than 15 V that leads to significant decline in the infrared transmission by a magnitude of over 40% and provided sufficient heat to trigger the MIT at a temperature around 60 °C, which is almost 10 °C lower than its bulk counterpart. This finding would positively impact the research on VO2 thin films, not only as smart windows but also for numerous other applications like bolometers, infrared detectors, Mott transistors and many more.
RESUMEN
Large area highly crystalline MoS2 and WS2 thin films were successfully grown on different substrates using radio-frequency magnetron sputtering technique. Structural, morphological and thermoelectric transport properties of MoS2, and WS2 thin films have been investigated systematically to fabricate high-efficient thermal energy harvesting devices. X-ray diffraction data revealed that crystallites of MoS2 and WS2 films are highly oriented in 002 plane with uniform grain size distribution confirmed through atomic force microscopy study. Surface roughness increases with substrate temperature and it plays a big role in electron and phonon scattering. Interestingly, MoS2 films also display low thermal conductivity at room temperature and strongly favors achievement of higher thermoelectric figure of merit value of up to 1.98. Raman spectroscopy data shows two distinct MoS2 vibrational modes at 380 cm-1 for E12g and 410 cm-1 for A1g. Thermoelectric transport studies further demonstrated that MoS2 films show p-type thermoelectric characteristics, while WS2 is an n-type material. We demonstrated high efficient pn-junction thermoelectric generator device for waste heat recovery and cooling applications.
RESUMEN
We grew lead-free BaZr0.2Ti0.8O3 (BZT)/Ba0.7Ca0.3TiO3 (BCT) epitaxial heterostructures and studied their structural, dielectric, ferroelectric and energy density characteristics. The BZT/BCT epitaxial heterostructures were grown on SrRuO3 (SRO) buffered SrTiO3 (STO) single crystal substrate by optimized pulsed laser deposition (PLD) technique. These high-quality nanostructures exhibit high dielectric permittivity (â¼1300), slim electric field-dependent polarization (P-E) curve with high saturation polarization (â¼100 µC/cm2) and low remnant polarization (â¼20 µC/cm2) through interface engineering to develop new lead-free ferroelectric system for energy storage devices. We observe an ultrahigh discharge and charge energy densities of 42.10 and 97.13 J/cm3, respectively, with high efficiency, which might be highly promising for both high power and energy storage electrical devices.
RESUMEN
Graphene Oxide (GO) based low cost flexible electronics and memory cell have recently attracted more attention for the fabrication of emerging electronic devices. As a suitable candidate for resistive random access memory technology, reduced graphene oxide (RGO) can be widely used for non-volatile switching memory applications because of its large surface area, excellent scalability, retention, and endurance properties. We demonstrated that the fabricated metal/RGO/metal memory device exhibited excellent switching characteristics, with on/off ratio of two orders of magnitude and operated threshold switching voltage of less than 1 V. The studies on different cell diameter, thickness, scan voltages and period of time corroborate the reliability of the device as resistive random access memory. The microscopic origin of switching operation is governed by the establishment of conducting filaments due to the interface amorphous layer rupturing and the movement of oxygen in the GO layer. This interesting experimental finding indicates that device made up of thermally reduced GO shows more reliability for its use in next generation electronics devices.
RESUMEN
We demonstrate that a nanostructured metal thin film can achieve enhanced transmission efficiency and sharp resonances and use a large-scale and high-throughput nanofabrication technique for the plasmonic structures. The fabrication technique combines the features of nanoimprint and soft lithography to topographically construct metal thin films with nanoscale patterns. Metal nanogratings developed using this method show significantly enhanced optical transmission (up to a one-order-of-magnitude enhancement) and sharp resonances with full width at half maximum (FWHM) of ~15 nm in the zero-order transmission using an incoherent white light source. These nanostructures are sensitive to the surrounding environment, and the resonance can shift as the refractive index changes. We derive an analytical method using a spatial Fourier transformation to understand the enhancement phenomenon and the sensing mechanism. The use of real-time monitoring of protein-protein interactions in microfluidic cells integrated with these nanostructures is demonstrated to be effective for biosensing. The perpendicular transmission configuration and large-scale structures provide a feasible platform without sophisticated optical instrumentation to realize label-free surface plasmon resonance (SPR) sensing.
Asunto(s)
Técnicas Biosensibles , Nanoestructuras/química , Resonancia por Plasmón de Superficie/métodos , Radiación Electromagnética , Análisis de Fourier , Metales/químicaRESUMEN
We have demonstrated a novel platform of quantum dots (QDs) core-shell conjugated graphene oxide (GO) biosensor for effective protein detection. The advantage in making core shell nanostructure allows preserving stable QDs, by improving quantum yield, and lowering the toxicity of the core. Both QDs and GO are efficient nanoparticle systems that can potentially be used for drug delivery, diagnosis, and biosensors scaffolds. However, our study indicates that the conjugation between these two nanoparticle systems makes their properties even more effective. The change in fluorescent intensity through fluorescence resonance energy transfer from quantum dots to GO produced a novel method for detection of the target and allows for the optimization of the recognition limit of Bovine serum albumin (BSA) due to efficient fluorescence resonance energy transfer as observed through time resolved relaxation spectroscopy. It is observed that the quenching of photoluminescence peak of QDs due to GO shell produced an applicable strategy and could be conveniently extended for detection of other biomolecules. We obtained significantly enhanced spectral signal through successful conjugation of GO with CdSe/CdS core shell, which can potentially be used for the detection of biomolecules with high sensitivity and selectivity. Our study underlines the efficiency of QD conjugated GO core shell in spectral detection of proteins even at very low concentration (0.25 mmol).
RESUMEN
Artificial and engineered nanostructures expand the degrees of freedom with which one can manipulate the intricate interplay of light and matter. Certain nanostructural arrangements in the excited state enable the efficient electromagnetic coupling of propagating light with localized fields. Here, we demonstrate that light transmitted through a nanostructured metal thin film without any apertures can be significantly enhanced. Distinct asymmetric Fano resonances are observed in the zero-order transmission spectra using an incoherent light source. The transmission efficiency surpasses that of a metal thin film with the same area and thickness at the resonance maxima. The transmission minima and the sharp resonance maxima bear a strong resemblance to the extraordinary optical transmission observed in sub-wavelength nanohole array structures The resonance wavelength closely matches the nanostructural periodicity. The sensitivity of the resonances to the surrounding medium and the transmission efficiency demonstrate the potential for use in energy harvesting, imaging, optical processing and sensing applications.
RESUMEN
We fabricated one-dimensional periodic multilayered metamaterial structures consisting of Ag and SiO2alternating layers. Optical responses, such as transmission and absorption, are consistent well within finite difference time domain (FDTD) simulations. Angle dependent real and imaginary dielectric permittivity reflection spectra demonstrate their operational capability in the visible wavelength region. This multilayer metamaterial can be converted into a photonic crystal by manipulating the thickness of SiO2 and we demonstrate that proper filling of SiO2/Ag layers the operating wavelength can be tuned to higher wavelength region. However, absolute value of transmission reduces with increasing number of multilayer pairs due to metal absorption.