Comparative kinematic analysis of the leading and trailing forelimbs of horses cantering on a turf and a synthetic surface.

REASONS FOR PERFORMING STUDY: The relationship between track surface properties and limb kinematics is poorly understood. Hoof orientation within the track surface has never been quantified under training conditions. Previously described kinematic and dynamic differences between leading and trailing forelimbs at the canter poorly correlate with epidemiological data regarding injuries. OBJECTIVES: To compare joint kinematics and hoof orientation in the leading and trailing forelimbs of horses cantering on turf and on a synthetic surface. STUDY DESIGN: Noninvasive experimental study. METHODS: The right forelimb of 5 horses was equipped with markers facing the main joints while markers and a dynamometric horseshoe were placed on the hoof. The horses were filmed with 2 high-speed cameras (1000 Hz) while cantering (30 km/h). Recordings were repeated at each lead and alternated on turf and on a synthetic surface. Joint angles and angles of the hoof and limb to the track were measured from the 2-dimensional coordinates of the markers. RESULTS: Elbow, carpus and fetlock were more maximally flexed during swing and had a larger range of motion throughout the stride in the leading forelimb. Maximal carpal extension during stance was also larger on this limb, which had a more toe-up orientation. Comparing surfaces, the limb was more oblique at landing, the range of motion of the hoof into the surface was larger, most kinematic events were delayed and fetlock and carpus extension velocities were smaller on the synthetic surface. CONCLUSIONS: The differences between limbs were more prominent than those between surfaces and the more toe-up orientation on the hoof of the leading forelimb suggests a different loading of that limb's joints and tendons. Differences between limbs may be important in the interpretation of lead changes in lame horses. While the synthetic surface appears to be less strenuous for the joints in the forelimbs, it was associated with changes in timing of the kinematic events of the stride.

Comparison of superficial digital flexor tendon loading on asphalt and sand in horses at the walk and trot.

The incidence of superficial digital flexor tendon (SDFT) injuries is one of the highest of all equine musculoskeletal conditions. Horses with SDFT injuries commonly show no improvement of lameness on soft ground, unlike those suffering from distal bone or joint lesions. The aim of this study was to compare the SDFT loading in five horses at the walk and trot on asphalt and sand using a non-invasive ultrasonic tendon force measurement device. Three horses were equipped with the ultrasonic device, whereas the other two horses were equipped with the ultrasonic device and a dynamometric horseshoe (DHS); the DHS was used to calibrate the measured values of tendon speed of sound (SOS) converted to tendon force, while a previously established ground reaction force pattern was used to calibrate SOS measurements for the other three horses. Although the horses tended to be slower on S, maximal tendon force was higher on sand than on asphalt at the trot (+6%); there was no significant difference between the two surfaces at the walk. The duration of tendon loading was longer on S (+5%) and the area under the tendon force-time curve was larger on S (+10%) at both walk and trot. SDFT loading is significantly affected by the ground surface and the observed increase in SDFT loading on sand compared with asphalt is consistent with clinical observations in horses with SDFT injuries.