Determination of quinolones and fluoroquinolones in hospital sewage water by off-line and on-line solid-phase extraction procedures coupled to HPLC-UV.

In this work, the development of two solid-phase extraction procedures (off-line and on-line formats) for the identification and quantification of several (fluoro)quinolones in hospital sewage water by HPLC-UV is described. Both procedures are based on the use of C18 and anion exchange (SAX) sorbents for the preconcentration and clean-up steps, respectively, and all variables influencing both steps were optimised. In the off-line format, after its pH was adjusted to 2.5, sample was preconcentrated on a C18 cartridge and eluted with 4 mL of methanol/ammonia (94/6). The methanolic extract must be diluted up to 10 mL with water to allow quantitative retention of the analytes on the SAX cartridge. In the on-line format, the addition of 2.5% of NH4Cl to the sewage water sample (pH = 2.5) was necessary to increase the breakthrough volumes of the analytes in the C18 precolumn. Quantitative transfer of the (fluoro)quinolones from the C18 precolumn to the SAX precolumn was accomplished by pumping 2 mL of a mixture methanol/water (40/60, pH = 9.2) at 2 mL min(-1). Elution of the analytes from the SAX precolumn by means of the chromatographic mobile phase required the inclusion of an additional isocratic step at the beginning of the gradient program. Both off-line and on-line solid phase extraction procedures coupled to HPLC-UV were applied to the analysis of a sewage water sample collected in the sewer system at the output of the St Dimphna Hospital (Geel, Belgium). The fluoroquinolone ciprofloxacin was found in this sample and quantified at 5.8 +/- 0.4 microg L(-1) (off-line method) and 5.6 +/- 0.5 microg L(-1) (on-line method). The analysis of spiked samples containing the seven (fluoro)quinolones studied provided quantitative recoveries in all cases with low RSD values (from 6 to 12%), and all the analytes could be identified by means of their UV spectra with match factors varying from 950 to 985 depending on the (fluoro)quinolone.

Determination of macrolide antibiotics in porcine and bovine urine by high-performance liquid chromatography coupled to coulometric detection.

A high-performance liquid chromatography method coupled to coulometric detection has been applied for the determination, in a single run, of up to eight macrolide antibiotics (erythromycin [ERY], tylosin [TYL], tilmicosin [TILM], spiramycin 2 [SPI 2], spiramycin 3 [SPI 3], josamycin [JOS], kitasamycin [KIT], and rosamicin [ROS]) in spiked porcine and bovine urine. Quantification was performed using matrix-matched calibration with roxithromycin (ROX) as the internal standard. The detection limits for each drug were below 3.5 ng injected (equivalent to an initial concentration below 0.07 mg L(-1)) for porcine urine and below 5 ng injected (equivalent to an initial concentration below 0.10 mg L(-1)) for bovine urine. Recoveries from urine samples spiked at three different concentrations within the linear range were not significantly dependent on concentration. The entire procedure provides average macrolide recoveries ranging from 69.7 to 96.6% for bovine urine and from 75.5 and 96.1% for porcine urine.

Capillary zone electrophoresis of metal-binding proteins in formic acid with UV- and mass spectrometric detection using cationic transient capillary isotachophoresis for preconcentration.

A capillary zone electrophoresis (CZE) method with preceding cationic transient capillary isotachophoresis (tCITP-CZE) was developed for uncoated fused-silica capillaries to analyze metal-binding proteins (MBPs) of clinical relevance. UV detection was followed by mass spectrometry (MS). Optimization was done with model proteins of properties similar to relevant human MBPs. Using 1.0 mol x L(-1) formic acid (pH 1.78) as electrolyte resulted in up to 165000 plates m(-1) in CZE and 230000 plates m(-1) in combination with tCITP and analysis time was less than 5 min in uncoupled mode. Cationic tCITP with 125 mmol x L(-1) ammonium formate, buffered to pH 4.00, as leading electrolyte improved sample loadability considerably in comparison with sample stacking without impairing resolution. Following systematic optimization of the electrospray ionization process (ESI) the coupled system ((tCITP)-CZE-UV-ESI-MS) was tested with protein model mixtures and human MBPs. Repeatability of migration times was < 0.64% in pure CZE mode and in tCITP-CZE mode and < 0.83% in CZE-ESI-MS coupled mode. Mass accuracy was < 0.015%. Limits of detection were found to be in the range 50-160 fmol.

Determination of haemoglobin A(1c) by liquid chromatography using a new cation-exchange column.

The use of a new cation-exchange column, ProPac SCX-10, for the determination of haemoglobin A(1c) (HbA(1c)) by high-performance liquid chromatography is described. After optimization of the analytical method for the separation of the various isoforms of haemoglobin with the ProPac SCX-10 column, the method was applied to the determination of HbA(1c) in blood from 59 volunteers. Three of the 59 had previously been diagnosed as diabetics. Interference studies for carbamylation, acetylation and pre-HbA(1c) were carried out via "in-vitro" experiments. No interference due to carbamylation was observed at the urea values normally found in uremic patients undergoing dialysis. No interference from pre-HbA(1c) was detected either. The method is able to separate haemoglobin A (alpha(2)beta(2)), haemoglobin S (haemoglobin from sickle cell anaemia patients) and haemoglobin A(2) (alpha(2)delta(2)) without interference. The method of Hampel was applied to detect outliers. A value of 3.29+/-0.44% (2sigma) for HbA(1c) was obtained in the analysis of 56 blood samples from non-diabetics. This average value is lower than that reported by most of the methods currently used in routine analyses.

Development of a capillary zone electrophoresis-electrospray ionisation tandem mass spectrometry method for the analysis of fluoroquinolone antibiotics.

The applicability of a capillary zone electrophoresis-electrospray ionisation tandem mass spectrometric (CZE-ESI-MS-MS) method for the separation of nine fluoroquinolones was investigated. Method optimisation involved systematic trouble-shooting starting with the type and duration of capillary pre-washing and conditioning, the choice of both the CE run buffer, MS sheath liquid, CE run potential, ESI spray voltage, sheath gas flow-rate, MS capillary voltage and CE capillary and MS capillary temperatures. Another extremely important factor was found to be the degree to which the CE capillary protrudes into the ESI chamber as well as whether or not sheath gas and spray voltage are employed during the CE injection or not. The importance of the latter has, to our knowledge, not been addressed elsewhere. Nine fluoroquinolones have been separated and detected in a single run by this technique.

Multiresidue determination of (fluoro)quinolone antibiotics in swine kidney using liquid chromatography-tandem mass spectrometry.

New antibiotics were recently developed, among which are the (fluoro)quinolones. This paper presents an analytical method which allows the determination of 11 (fluoro)quinolones in swine kidneys: norfloxacin, ofloxacin, cinoxacin, oxolinic acid, nalidixic acid, flumequine, enrofloxacin, enoxacin, ciprofloxacin, danofloxacin and marbofloxacin. The procedure involves a rapid and efficient pre-treatment by solid-phase extraction (recoveries 83-98%), followed by the sensitive and selective determination of all compounds in a single run using LC-ESI-MS-MS. Multiple reaction monitoring (MRM) was used for selective detection of each (fluoro)quinolone. Quinine was selected as internal standard. The accuracy of the method, expressed as recovery, was between 89 and 109%; the repeatability had a maximum RSD lower than 15%. The limits of detection (LOD) were much lower than the respective Maximum Residue Limits (MRL)/4.