Study on the dose profile in CT-fluoroscopy.

This work aims to contribute to the description of the dose profile in Computed Tomography Fluoroscopy (CTF). Our approach uses a function model to fit the single slice dose profiles (SSDP) for any point inside the gantry of the CT unit, with special attention to points off the rotation axis. The function model was successfully tested with measurements performed using GafChromic film. The parameters of the SSDP at the rotation axis (isocenter) and at 8 cm and 16 cm off the isocenter were determined. The model allows an estimation of the slice thickness at the isocenter and for points at 8 cm and 16 cm off the isocenter. The differences between the slice thicknesses results in overestimation of the Computed Tomography Dose Index, CTDI, by values as high as 20% if the nominal slice thickness instead of the model estimated value is used. The results obtained in this work provided a good description of the dose profiles, which can be used in further studies such as comparisons with measurements performed with phantoms and patients.

Dose to the interventional radiologist in CTF-guided procedures.

The aim of this work was to assess the occupational dose received by an interventional radiologist (IR) during computed tomography fluoroscopy (CTF)-guided procedures; to identify the most exposed areas of the body including the hands and fingers; to suggest recommendations for individual monitoring; and to improve radiation safety of the practice. A total of 53 CTF-guided procedures were studied. Twelve whole-body dosimeters were worn by the IR in each procedure for the assessment of the personal dose equivalent, Hp(10), on the chest, waist, and back, both over and under the lead apron, as well as the personal dose equivalent, Hp(0.07), on both arms, knees, and feet. Special gloves with casings to fit extremity dosimeters were prepared to assess Hp(0.07) to the fingers. The measured chest dose values were higher than those on the waist and back; the dominant hand or the left side was the most exposed. In general, the ring, middle, and index fingers of the dominant hand were the most exposed (maximum in the 36-39 mSv range), while wrist dose was negligible compared to finger doses. Based on the results obtained the following recommendations are suggested: protective devices (lead aprons, thyroid shield, and goggles) should be worn; Hp(10) should be assessed at the chest level both above and below the lead apron; finger doses can be measured on the basis of each middle finger; the arm closer to the beam should be monitored; and finally, a wrist dosimeter will not provide useful information.

CHARACTERIZATION OF AN ACTIVE DOSEMETER ACCORDING TO IEC 61526:2010.

The active personal dosemeter, RaySafe i2, allows the measurement and record of Hp(10) in real time, every second, via wireless technology for real-time display on a portable computer and/or a local network. The system seems particularly attractive for individual monitoring at clinical facilities where high intensity and varying radiation fields may occur, as it enables the user to acknowledge and optimize the dose and dose rate values in real time for each procedure. Prior to its use, the system was characterized at the Metrology Laboratory of Ionizing Radiation of IST-LPSR aiming at the metrological characterization of the system in accordance with IEC 61526:2010 for metrological control purposes and to verify the technical specifications stated by the manufacturer.

Innovative methodology for intercomparison of radionuclide calibrators using short half-life in situ prepared radioactive sources.

PURPOSE: An original radionuclide calibrator method for activity determination is presented. The method could be used for intercomparison surveys for short half-life radioactive sources used in Nuclear Medicine, such as(99m)Tc or most positron emission tomography radiopharmaceuticals. METHODS: By evaluation of the resulting net optical density (netOD) using a standardized scanning method of irradiated Gafchromic XRQA2 film, a comparison of the netOD measurement with a previously determined calibration curve can be made and the difference between the tested radionuclide calibrator and a radionuclide calibrator used as reference device can be calculated. To estimate the total expected measurement uncertainties, a careful analysis of the methodology, for the case of(99m)Tc, was performed: reproducibility determination, scanning conditions, and possible fadeout effects. Since every factor of the activity measurement procedure can influence the final result, the method also evaluates correct syringe positioning inside the radionuclide calibrator. RESULTS: As an alternative to using a calibrated source sent to the surveyed site, which requires a relatively long half-life of the nuclide, or sending a portable calibrated radionuclide calibrator, the proposed method uses a source preparedin situ. An indirect activity determination is achieved by the irradiation of a radiochromic film using (99m)Tc under strictly controlled conditions, and cumulated activity calculation from the initial activity and total irradiation time. The irradiated Gafchromic film and the irradiator, without the source, can then be sent to a National Metrology Institute for evaluation of the results. CONCLUSIONS: The methodology described in this paper showed to have a good potential for accurate (3%) radionuclide calibrators intercomparison studies for(99m)Tc between Nuclear Medicine centers without source transfer and can easily be adapted to other short half-life radionuclides.

The effect of megavoltage radiation on polymeric materials to be used in biomedical devices.

For a number of biomedical applications, including the development of phantoms for quality control of radiotherapy treatments and dose determination, it is important to study the radiation response of the used materials, in order to distinguish the relevant dose distribution modifications from the artifacts caused by the phantom material when subjected to high dose irradiation. Beside the radiation response, those materials should have certain physical and chemical properties in order to be able to be used for the purposes described above, i.e., mechanical hardness and inelasticity, chemically stability and nonreactive, among others. In this work, a wide range of polymeric materials were irradiated under megavoltage radiation using a radiotherapy linear accelerator. The irradiated materials were imaged using transmission X-ray tomography to determine if some radiation induced electronic density change could result in altered Hounsfield units. Furthermore, Raman Spectroscopy and X-ray Diffraction (XRD) techniques were used before and after irradiation in order to study any structural modification induced by the radiation. In addition, a special phantom simulating a breast treatment with two tangential beams has been fabricated and tested.

Study of nuclear medicine practices in Portugal from an internal dosimetry perspective.

Nuclear medicine practices involve the handling of a wide range of pharmaceuticals labelled with different radionuclides, for diagnostic and therapeutic purposes. This work intends to evaluate the potential risks of internal contamination of nuclear medicine staff in several Portuguese nuclear medicine services and to conclude about the requirement of a routine internal monitoring. A methodology proposed by the International Atomic Energy Agency (IAEA), providing a set of criteria to determine the need, or not, for an internal monitoring programme, was applied. The evaluation of the risk of internal contaminations in a given set of working conditions is based on the type and amount of radionuclides being handled, as well as the safety conditions with which they are manipulated. The application of the IAEA criteria showed that 73.1% of all the workers included in this study should be integrated in a routine monitoring programme for internal contaminations; more specifically, 100% of workers performing radioimmunoassay techniques should be monitored. This study suggests that a routine monitoring programme for internal exposures should be implemented in Portugal for most nuclear medicine workers.

Preliminary assessment of the dose to the interventional radiologist in fluoro-CT-guided procedures.

A preliminary assessment of the occupational dose to the intervention radiologist received in fluoroscopy computerised tomography (CT) used to guide the collection of lung and bone biopsies is presented. The main aim of this work was to evaluate the capability of the reading system as well as of the available whole-body (WB) and extremity dosemeters used in routine monthly monitoring periods to measure per procedure dose values. The intervention radiologist was allocated 10 WB detectors (LiF: Mg, Ti, TLD-100) placed at chest and abdomen levels above and below the lead apron, and at both right and left arms, knees and feet. A special glove was developed with casings for the insertion of 11 extremity detectors (LiF:Mg, Cu, P, TLD-100H) for the identification of the most highly exposed fingers. The H(p)(10) dose values received above the lead apron (ranged 0.20-0.02 mSv) depend mainly on the duration of the examination and on the placement of physician relative to the beam, while values below the apron are relatively low. The left arm seems to receive a higher dose value. H(p)(0.07) values to the hand (ranged 36.30-0.06 mSv) show that the index, middle and ring fingers are the most highly exposed. In this study, the wrist dose was negligible compared with the finger dose. These results are preliminary and further studies are needed to better characterise the dose assessment in CT fluoroscopy.

Ethical issues related to professional exposure of pregnant women in the medical field: monitoring and limiting effective dose.

The International Commission on Radiological Protection recommendations for occupational exposed pregnant women do not imply necessarily the complete avoidance of work with radiation or radioactive materials. Instead, a careful review of the exposure conditions, once the pregnancy is declared, as part of the exercise of the ICRP optimisation principle (based in a teleological ethics point of view) is suggested. The dose limitation (following a deontological ethics point of view) of the fetus/embryo is, however, not clearly well established as happens in the case of workers or members of the public. Also, the justification of practices (to continue to work or not with radiation or radioactive materials) is not clearly addressed in most national or international recommendations. An analysis of this justification (bearing in mind both teleological and deontological ethics) is examined in this work having in mind the best interest of the child-to-be as well as other existing social and economical factors.

Syringe shape and positioning relative to efficiency volume inside dose calibrators and its role in nuclear medicine quality assurance programs.

A careful analysis of geometry and source positioning influence in the activity measurement outcome of a nuclear medicine dose calibrator is presented for (99m)Tc. The implementation of a quasi-point source apparent activity curve measurement is proposed for an accurate correction of the activity inside several syringes, and compared with a theoretical geometric efficiency model. Additionally, new geometrical parameters are proposed to test and verify the correct positioning of the syringes as part of acceptance testing and quality control procedures.

Single-acquisition method for simultaneous determination of extrinsic gamma-camera sensitivity and spatial resolution.

A new method for measuring simultaneously both the extrinsic sensitivity and spatial resolution of a gamma-camera in a single planar acquisition was implemented. A dual-purpose phantom (SR phantom; sensitivity/resolution) was developed, tested and the results compared with other conventional methods used for separate determination of these two important image quality parameters. The SR phantom yielded reproducible and accurate results, allowing an immediate visual inspection of the spatial resolution as well as the quantitative determination of the contrast for six different spatial frequencies. It also proved to be useful in the estimation of the modulation transfer function (MTF) of the image formation collimator/detector system at six different frequencies and can be used to estimate the spatial resolution as function of the direction relative to the digital matrix of the detector.

Low-frequency noise effects on the parotid gland of the Wistar rat.

BACKGROUND: Long-term low-frequency noise (LFN) (