Controlling and Tuning the Dispersion Properties of Calcined Kaolinite Particles in Various Organic Solvents via the Modification Method Using Triethoxyvinylsilane and 3-Mercaptopropionic Acid.

The surface of calcined kaolinite particles underwent chemical modification using Vinyltriethoxysilane (VTMS) and 3-mercaptopropionic acid (3-MPA). The grafting ratio of VTMS on the calcined kaolinite surface was adjusted by varying its quantity. FT-IR analysis revealed the initial grafting of VTMS onto the kaolinite surface, resulting in the formation of a C=C reactive site on the surface. Subsequently, an olefin click reaction with 3-MPA occurred, leading to the effective grafting of 3-MPA onto the kaolinite surface and the formation of an efficient coating. Thermal analysis indicated that the optimal grafting level was achieved at a modifier content V:K ratio of 0.5. The estimated grafting ratio of the modifier on the kaolinite surface was approximately 40% when V:K was 0.5. Water contact angle and dispersion experiments demonstrated that the surface properties of kaolinite were effectively controlled by this modification approach. At V:K = 0.3, the modified kaolinite particles exhibited good dispersion in both polar and non-polar solvents. In polar solvents, the average particle size of modified kaolinite was below 1100 nm, while in non-polar solvents, it did not exceed 5000 nm. Considering all aspects, a V:K ratio of 0.3 is recommended. Further investigation into the impact of adding 3-MPA on the surface properties of modified kaolinite particles based on V:K = 0.3 revealed that the hydrophilicity of the modified particles could be enhanced. However, it is advised to keep the maximum M:V ratio (3-MPA to kaolinite) at 1.0.

Surface Modification of Calcined Kaolinite for Enhanced Solvent Dispersion and Mechanical Properties in Polybutylene Adipate/Terephthalate Composites.

In order to regulate the surface properties of calcined kaolinite for the purpose of achieving uniform distribution within various polar dispersion media, 3-aminopropyltriethoxysilane and phenyl glycidyl ether were employed to chemically modify calcined kaolinite. The grafting rate, surface properties, and dispersion properties of calcined kaolinite particles in different polar organic media were changed by varying the dosage of the modifiers. FT-IR analysis confirmed successful surface modification, while thermogravimetric analysis indicated a maximum graft coverage of 18.44 µmol/m2 for the modified particles. Contact angle measurements and particle size distribution analyses demonstrated the effective adjustment of surface characteristics by the modifiers. Specifically, at a mass ratio of 1.0 of modifier to kaolinite particles, the modified particles exhibited a contact angle of around 125°, achieving uniform dispersion in different polarity media. Particle size distribution ranged from 1600 nm to 2100 nm in cyclohexane and petroleum ether, and from 900 nm to 1200 nm in dioxane, ethyl acetate, and DMF, showcasing a significant improvement in dispersion performance compared to unmodified particles. Concurrently, to improve the mechanical properties of PBAT, modified particles were incorporated into the PBAT matrix, and the effect of modified particle addition on the tensile strength and fracture tensile rate of the composites was investigated. The optimal amount of modified particles is 6 wt.%~8 wt.%. This article aims at synthesizing modifier molecules containing different hydrophilic and hydrophobic groups to chemically graft onto the surface of calcined kaolinite. The hydrophilic and hydrophobic groups on the modified particles can adapt to dispersed systems of different polarities and achieve good distribution within them. The modified particles are added to PBAT to achieve good compatibility and enhance the mechanical properties of the composite material.