Surgical outcomes of intraoperative O-arm versus C-arm fluoroscopy in occipitocervical fixation: a retrospective analysis.

PURPOSE: This study aims to compare the effect of using O-arm and C-arm fluoroscopy on the surgical outcomes of occipitocervical fixation. METHODS: The study included patients who underwent occipitocervical fixation using O-arm or C-arm between 2005 and 2021. Of 56 patients, 34 underwent O-arm-assisted surgery (O-group) and 22 underwent C-arm-assisted surgery (C-group). We assessed surgical outcomes, including operative time, intraoperative blood loss, perioperative complications, and bone union. RESULTS: Almost half of the patients had rheumatoid arthritis-related disorders in both groups. Sixteen cases (47.1%) in the O-group and 12 cases (54.5%) in the C-group were fixed from occipito (Oc) to C3, 12 cases (38.2%) in the O-group and 7 cases (31.8%) in the C-group from Oc to C4-7, 5 cases (14.7%) in the O-group, and 3 cases (13.6%) in the C-group from Oc to T2 (p = 0.929). There was no significant difference in operative time (p = 0.239) and intraoperative blood loss (p = 0.595) between the two groups. Dysphagia was the most common complication in both groups (O-group vs. C-group, 11.7% vs. 9.1%). Regarding implant-related complications, occipital plate dislodgement was observed in four cases (18.2%) in the C-group (p = 0.02). The bone union rate was 96.3% in the O-group and 93.3% in the C-group (P = 1). CONCLUSIONS: O-arm use is associated with a reduced rate of occipital plate dislodgment and has a similar complication incidence compared with C-arm-assisted surgery and does not prolong operative time despite the time needed for setting and scanning. Accordingly, an O-arm is safe and useful for occipitocervical fixation surgery.

Nonresponder Considerations for Romosozumab Treatment.

Romosozumab can increase bone mineral density (BMD) in patients with osteoporosis, but some patients do not respond to it. This study aimed to identify risk factors for being a nonresponder to romosozumab treatment. This retrospective observational study included 92 patients. Romosozumab (210 mg) was subcutaneously administered to the participants every 4 weeks over 12 months. We excluded patients who previously underwent treatment for osteoporosis to assess the impact of romosozumab alone. We evaluated the proportion of patients who did not respond to romosozumab treatment to the lumbar spine and hip with increased BMD. Nonresponders were defined as those with a bone density change of < 3% after 12 months of treatment. We compared demographics and biochemical markers between responders and nonresponders. We found that 11.5% of patients were nonresponders at the lumbar spine, and 56.8% were nonresponders at the hip. A risk factor for nonresponse at the spine was low type I procollagen N-terminal propeptide (P1NP) values at 1 month. The cutoff value for P1NP at month 1 was 50 ng/ml. We found that 11.5% and 56.8% of patients experienced no significant improvement in the lumbar spine and hip BMD, respectively. Clinicians should use nonresponse risk factors to inform decisions about romosozumab treatment for patients with osteoporosis.

Mathematical modeling of septic shock based on clinical data.

BACKGROUND: Mathematical models of diseases may provide a unified approach for establishing effective treatment strategies based on fundamental pathophysiology. However, models that are useful for clinical practice must overcome the massive complexity of human physiology and the diversity of patients' environmental conditions. With the aim of modeling a complex disease, we choose sepsis, which is highly complex, life-threatening systemic disease with high mortality. In particular, we focused on septic shock, a subset of sepsis in which underlying circulatory and cellular/metabolic abnormalities are profound enough to substantially increase mortality. Our model includes cardiovascular, immune, nervous system models and a pharmacological model as submodels and integrates them to create a sepsis model based on pathological facts. RESULTS: Model validation was done in two steps. First, we established a model for a standard patient in order to confirm the validity of our approach in general aspects. For this, we checked the correspondence between the severity of infection defined in terms of pathogen growth rate and the ease of recovery defined in terms of the intensity of treatment required for recovery. The simulations for a standard patient showed good correspondence. We then applied the same simulations to a patient with heart failure as an underlying disease. The model showed that spontaneous recovery would not occur without treatment, even for a very mild infection. This is consistent with clinical experience. We next validated the model using clinical data of three sepsis patients. The model parameters were tuned for these patients based on the model for the standard patient used in the first part of the validation. In these cases, the simulations agreed well with clinical data. In fact, only a handful parameters need to be tuned for the simulations to match with the data. CONCLUSIONS: We have constructed a model of septic shock and have shown that it can reproduce well the time courses of treatment and disease progression. Tuning of model parameters for each patient could be easily done. This study demonstrates the feasibility of disease models, suggesting the possibility of clinical use in the prediction of disease progression, decisions on the timing of drug dosages, and the estimation of time of infection.

Blood metal ion concentrations in metal-on-metal total hip arthroplasty.

INTRODUCTION: The hip placement with a metal-on-metal (MOM) bearing has been used for both surface replacement and total hip arthroplasty (THA). Use of MOM bearing for hip replacement reduces the wear compared to conventional bearings. METHODS: We prospectively assessed 30 patients who underwent unilateral MOM THA. A control group of 30 patients who underwent metal-on-polyethylene THA using the implants as the other group, except for bearing, were accessed. Blood samples were collected preoperatively and at 3- , 6- , 9- , 12- , 15- , 18- , and 24-month intervals. Changes in mean blood metal ion concentration were compared between the MOM and metal-on-polyethylene groups. RESULTS: A statistically significant positive correlation was observed between blood cobalt and chromium concentrations in all of the patients. The mean blood ion concentrations of the MOM were significantly higher than those of the metal-on-polyethylene. A statistically significant negative correlation was found between maximum blood cobalt concentration and cup version angle. The maximum blood chromium concentrations in the patients who had larger cup version angles were more likely to decrease. CONCLUSIONS: We considered that cup version angle is one of the factors that have the greatest effect on blood metal ion concentration, and the target cup version angle that did not induce an increase in blood metal ion concentrations was approximately 20°.

Usefulness of measuring acetabular anterior coverage using a tomosynthesis imaging system.

PURPOSE: The purpose of this study was to compare the usefulness of measuring acetabular anterior coverage by tomosynthesis and false profile (FP) radiography. METHODS: 70 hips in 35 patients who were diagnosed with early stage osteoarthritis of the hip, and 60 hips from 30 healthy volunteers were analysed. Plain FP radiographs were taken, and vertical-centre-anterior margin (FP-VCA) angles were measured. Acetabular anterior coverage was measured in the natural standing position using a tomosynthesis imaging system in the sagittal plane. As with FP radiography, we measured vertical-centre-anterior margin (TS-VCA) angles. RESULTS: The median values of the FP-VCA angle, and TS-VCA angle were 43.8°, 54.4°, respectively. The TS-VCA angle was significantly larger than the FP-VCA angle. For FP radiographs, the intraobserver intraclass correlation coefficient (ICC) was 0.68, and the interobserver ICC was 0.79. For tomosynthesis sagittal images, the intraobserver ICC was 0.85, and the interobserver ICC was 0.92. There was a strong positive correlation between the TS-VCA angle and the FP-VCA angle. When the FP-VCA angle was 25°, the TS-VCA angle was 35° in regression analysis. CONCLUSIONS: Measuring acetabular anterior coverage using sagittal plane tomosynthesis correlates well with FP radiography. Regardless of the presence of acetabular deformities, tomosynthesis demonstrated high reproducibility, simple posture setting, low effective doses, and high versatility. A cut-off value of 35° was useful for the detection of developmental dysplasia of the hip joint using the TS-VCA angle.

Low parathyroid hormone levels in patients who underwent/would undergo hemodialysis result in bone graft failure after posterolateral fusion.

STUDY DESIGN: Case series. OBJECTIVE: To reveal the association between levels of parathyroid hormone (PTH) and outcome of bone fusion in patients who underwent/would undergo hemodialysis. SUMMARY OF BACKGROUND DATA: Among the different bone lesions observed in patients who underwent/would undergo hemodialysis, adynamic bone disease is regarded as a factor associated with bone graft failure because of severely reduced bone turnover. Although PTH levels reflect the pathological findings of bone lesions in patients who underwent/would undergo hemodialysis, the relationship between PTH levels and the outcome of bone fusion in patients who underwent/would undergo hemodialysis has not been investigated. METHODS: Patients who underwent/would undergo hemodialysis (n = 48) with lumbar spine lesion underwent posterolateral spinal fusion with instrumentation. The outcome of bone fusion was assessed radiographically 12 months after surgery, and sensitivity and specificity were determined using preoperative PTH levels as the standard. RESULTS: A significant difference in PTH levels was observed between the good fusion (mean, 235.4 pg/mL) and poor fusion (mean, 100.0 pg/mL) groups. The intersection of the sensitivity and specificity plots, generated using preoperative PTH levels, was 150 pg/mL, and the area under the receiver operating characteristic curve was 0.72. CONCLUSION: Low PTH levels are a risk factor for bone graft failure in patients who underwent/would undergo hemodialysis. Accordingly, PTH level can be a useful predictor of the outcome of bone fusion. LEVEL OF EVIDENCE: 4.