RESUMEN
In this study, low-cost tubular ceramic membranes were fabricated by using waste slag and natural raw materials in order to decrease the manufacturing carbon footprints. The effects of incorporation of phosphorus slag (PS) and blast furnace slag (BFS) in the mullite-zeolite membrane body were investigated. The structural characteristics of the fabricated membranes were evaluated using X-ray diffraction (XRD), field emission-scanning electron microscopy (FESEM), atomic force microscopy (AFM), contact angle, porosity and average pore size analyses. Thermal and mechanical stability were studied by thermogravimetric analysis (TGA) and three-point bending test, respectively. The oily wastewater treatment tests revealed that an increase in the slag percentage from 0 to 30% leads to enhancing the permeate flux from 99 l m-2 h-1 to 349 l m-2 h-1 for PS-based tubular membrane and to 244 l m-2 h-1 for BFS-based tubular membrane under 1 bar applied. The chemical oxygen demand (COD) removal percentage of all membranes was reported almost 99% for oily wastewater feed with a COD concentration of 612 mg l-1. In addition, the investigation of membrane fouling mechanisms was carried out using Hermia models indicating that the best correlation with the experimental data is observed for the complete pore blocking model. This study presents experimental foundations aimed at enhancing the performance of affordable slag-based membranes, thus fostering their applicability in engineering contexts.