Ratiometric Imaging Using a Single Dye Enables Simultaneous Visualization of Rac1 and Cdc42 Activation.

Biosensors that report endogenous protein activity in vivo can be based on environment-sensing fluorescent dyes. The dyes can be attached to reagents that bind selectively to a specific conformation of the targeted protein, such that binding leads to a fluorescence change. Dyes that are sufficiently bright for use at low, nonperturbing intracellular concentrations typically undergo changes in intensity rather than the shifts in excitation or emission maxima that would enable precise quantitation through ratiometric imaging. We report here mero199, an environment-sensing dye that undergoes a 33 nm solvent-dependent shift in excitation. The dye was used to generate a ratiometric biosensor of Cdc42 (CRIB199) without the need for additional fluorophores. CRIB199 was used in the same cell with a FRET sensor of Rac1 activation to simultaneously observe Cdc42 and Rac1 activity in cellular protrusions, indicating that Rac1 but not Cdc42 activity was reduced during tail retraction, and specific protrusions had reduced Cdc42 activity. A novel program (EdgeProps) used to correlate localized activation with cell edge dynamics indicated that Rac1 was specifically reduced during retraction.

Multicolor monitoring of dysregulated protein kinases in chronic myelogenous leukemia.

The Bcr-Abl and Lyn protein tyrosine kinases have been separately linked to the emergence of imatinib resistance in patients with chronic myelogenous leukemia. We have developed fluorescent sensors for these kinases that are enzymatically and photophysically distinct, allowing us to simultaneously, yet separately, visualize the tyrosine kinase activities of both Abl and Lyn. Multicolor monitoring revealed that an imatinib-resistant cell line (MYL-R) displays a remarkable 13-fold enhancement in Lyn kinase activity relative to its imatinib-sensitive counterpart (MYL). By contrast, both cell lines display nearly identical Abl activities. The upregulation of Lyn kinase phosphotransferase activity in MYL-R cells is linked to an overexpression of the Lyn B isoform. Furthermore, MYL-R cells possess a 4-fold higher level of activated Lyn and 5-fold lower level of autoinhibited Lyn than MYL cells. Finally, studies with an activating SH2 ligand revealed that Lyn from imatinib-resistant MYL-R cells is primed and active, whereas Lyn from imatinib-sensitive cells is dependent upon phosphorylated SH2 ligands for activity.

Simultaneous fluorescent monitoring of proteasomal subunit catalysis.

The proteasome, a multicatalytic protease, displays distinct chymotrypsin-like, caspase-like, and trypsin-like activities at three different subunits of the multimeric complex. Fluorescent substrates for each of these active sites have been described. However, since the fluorescent properties of these substrates are very similar, it is not possible to simultaneously monitor catalysis of two or more activities. We have developed a long wavelength (lambda(ex) = 600 nm, lambda(em) = 700 nm) fluorescent substrate for the chymotrypsin-like active site via a combinatorial library strategy. This peptide-based substrate is a highly selective proteasomal chymotrypsin-like sensor, as assessed by a series of proteasomal active site mutants in yeast cell lysates. A corresponding caged analog of the sensor has been prepared, which is resistant to proteolysis until activated by 349 nm light. The latter affords the opportunity to assess proteasomal activity with a high degree of temporal control. The distinct photophysical properties of the sensor allow the chymotrypsin-like activity to be simultaneously monitored during caspase-like or trypsin-like catalysis. We have found that chymotrypsin-like activity is enhanced in the presence of the trypsin-like substrate but reduced in the presence of caspase-like substrate. Furthermore, the chymotrypsin-like sensor hinders the activity of both the caspase- and trypsin-like active sites. Coincident monitoring of two catalytic active sites furnishes two-thirds coverage of total proteasomal activity, which should provide the means to address if and how the distinct active sites of the proteasome influence one another during catalysis.

A biosensor of S100A4 metastasis factor activation: inhibitor screening and cellular activation dynamics.

S100A4, a member of the S100 family of Ca2+-binding proteins, displays elevated expression in malignant human tumors compared with benign tumors, and increased expression correlates strongly with poor patient survival. S100A4 has a direct role in metastatic progression, likely due to the modulation of actomyosin cytoskeletal dynamics, which results in increased cellular motility. We developed a fluorescent biosensor (Mero-S100A4) that reports on the Ca2+-bound, activated form of S100A4. Direct attachment of a novel solvatochromatic reporter dye to S100A4 results in a sensor that, upon activation, undergoes a 3-fold enhancement in fluorescence, thus providing a sensitive assay for use in vitro and in vivo. In cells, localized activation of S100A4 at the cell periphery is observed during random migration and following stimulation with lysophosphatidic acid, a known activator of cell motility and proliferation. Additionally, a screen against a library of FDA-approved drugs with the biosensor identified an array of phenothiazines as inhibitors of myosin-II associated S100A4 function. These data demonstrate the utility of the new biosensor both for drug discovery and for probing the cellular dynamics controlled by the S100A4 metastasis factor.

Experimental and DFT studies: novel structural modifications greatly enhance the solvent sensitivity of live cell imaging dyes.

Structural modifications of previously reported merocyanine dyes (Toutchkine, A.; Kraynov, V.; Hahn, K. J. Am. Chem. Soc. 2003, 125, 4132-4145) were found to greatly enhance the solvent dependence of their absorbance and fluorescence emission maxima. Density functional theory (DFT) calculations have been performed to understand the differences in optical properties between the new and previously synthesized dyes. Absorption and emission energies were calculated for several new dyes using DFT vertical self-consistent reaction field (VSCRF) methods. Geometries of ground and excited states were optimized with a conductor-like screening model (COSMO) and self-consistent field (SCF) methods. The new dyes have enhanced zwitterionic character in the ground state and much lower polarity in the excited state, as shown by the DFT-VSCRF calculations. Consistently, the position of the absorption bands are strongly blue-shifted in more polar solvent (methanol compared to benzene), as predicted by the DFT spectral calculations. Inclusion of explicit H-bonding solvent molecules within the quantum model further enhances the predicted shifts and is consistent with the observed spectral broadening. Smaller but significant spectral shifts in polar versus nonpolar solvent are predicted and observed for emission bands. The new dyes show large fluorescence quantum yields in polar hydrogen-bonding solvents; qualitatively, the longest bonds along the conjugated chain at the excited S1 state minimum are shorter in the more polar solvent, inhibiting photoisomerization. The loss of photostability of the dyes is a consequence of the reaction with and electron transfer to singlet oxygen, starting oxidative dye cleavage. The calculated vertical ionization potentials of three dyes I-SO, AI-SO(4), and AI-BA(4) in benzene and methanol are consistent with their relative photobleaching rates; the charge distributions along the conjugated chains for the three dyes are similarly predictive of higher reaction rates for AI-SO(4) and AI-BA(4) than for I-SO. Time-dependent DFT calculations were also performed on AI-BA(4); these were less accurate than the VSCRF method in predicting the absorption energy shift from benzene to methanol.

Simple one-pot preparation of water-soluble, cysteine-reactive cyanine and merocyanine dyes for biological imaging.

A simple one-pot-procedure for preparation of protein-reactive, water-soluble merocyanine and cyanine dyes has been developed. The 1-(3-ammoniopropyl)-2,3,3-trimethyl-3H-indolium-5-sulfonate bromide (1) was used as a common starting intermediate. The method allows easy preparation of dyes with chloro- and iodoacetamide side chains for covalent attachment to cysteine. By placing a sulfonato group directly on the dye fluorophore system, dyes with high fluorescence quantum yields in water were generated. Both iodo- and chloroacetamido derivatives were shown to be useful in protein labeling. Less reactive chloroacetamides will be preferential for selective labeling of the most reactive cysteines.

Merocyanine dyes with improved photostability.

Merocyanine dyes have proven valuable for live cell fluorescence imaging applications, but many structures have been limited by rapid photobleaching. We show that photostability is substantially enhanced for merocyanines having a cyano group at a specific position in the central polymethine chain. Evidence is presented that this is due to reduction in reactivity of the dyes with singlet oxygen. These results point toward cyano-substitution as a general strategy for improving dye performance in imaging applications.

Activation of endogenous Cdc42 visualized in living cells.

Signaling proteins are tightly regulated spatially and temporally to perform multiple functions. For Cdc42 and other guanosine triphosphatases, the subcellular location of activation is a critical determinant of cell behavior. However, current approaches are limited in their ability to examine the dynamics of Cdc42 activity in living cells. We report the development of a biosensor capable of visualizing the changing activation of endogenous, unlabeled Cdc42 in living cells. With the use of a dye that reports protein interactions, the biosensor revealed localized activation in the trans-Golgi apparatus, microtubule-dependent Cdc42 activation at the cell periphery, and activation kinetics precisely coordinated with cell extension and retraction.

A theoretical study of the UV/visible absorption and emission solvatochromic properties of solvent-sensitive dyes.

Using the density-functional vertical self-consistent reaction field (VSCRF) solvation model, incorporated with the conductor-like screening model (COSMO) and the self-consistent reaction field (SCRF) methods, we have studied the solvatochromic shifts of both the absorption and emission bands of four solvent-sensitive dyes in different solutions. The dye molecules studied here are: S-TBA merocyanine, Abdel-Halim's merocyanine, the rigidified amino-coumarin C153, and Nile red. These dyes were selected because they exemplify different structural features likely to impact the solvent-sensitive fluorescence of "push-pull", or merocyanine, fluorophores. All trends of the blue or red shifts were correctly predicted, comparing with the experimental observations. Explict H-bonding interactions were also considered in several protic solutions like H2O, methanol and ethanol, showing that including explicit H-bonding solvent molecule(s) in the calculations is important to obtain the correct order of the excitation and emission energies. The geometries, electronic structures, dipole moments, and intra- and intermolecular charge transfers of the dyes in different solvents are also discussed.

Solvent-sensitive dyes to report protein conformational changes in living cells.

Covalent attachment of solvent-sensitive fluorescent dyes to proteins is a powerful tool for studying protein conformational changes, ligand binding, or posttranslational modifications. We report here new merocyanine dyes that make possible the quantitation of such protein activities in individual living cells. The quantum yield of the new dyes is sharply dependent on solvent polarity or viscosity, enabling them to report changes in their protein environment. This is combined with other stringent requirements needed in a live cell imaging dye, including appropriate photophysical properties (excitation >590 nm, high fluorescence quantum yield, high extinction coefficient), good photostability, minimal aggregation in water, and excellent water solubility. The dyes were derivatized with iodoacetamide and succinimidyl ester side chains for site-selective covalent attachment to proteins. A novel biosensor of Cdc42 activation made with one of the new dyes showed a 3-fold increase in fluorescence intensity in response to GTP-binding by Cdc42. The dyes reported here should be useful in the preparation of live cell biosensors for a diverse range of protein activities.

Facile synthesis of thiol-reactive Cy3 and Cy5 derivatives with enhanced water solubility.

The cyanine dyes Cy3 and Cy5 have proven valuable in numerous applications involving conjugation with proteins. Practical syntheses of lysine-selective, succinimidyl ester derivatives of these dyes have been published, and succinimidyl esters are commercially available. However, the published syntheses of cysteine-selective derivatives produce relatively low yields from expensive starting materials, or produce molecules with marginal water solubility for protein labeling. We report here facile syntheses (four steps, >50% overall yield) of iodoacetamide, sulfhydryl-reactive derivatives of the Cy3 and Cy5 fluorophores. These novel derivatives have good water solubility (>2.5 mM) and bear only one reactive side chain, reducing possible protein cross-linking encountered with previous derivatives.

Live-cell fluorescent biosensors for activated signaling proteins.

A new generation of live-cell fluorescent biosensors enables us to go beyond visualization of protein movements, to quantify the dynamics of many different protein activities. Alternate approaches can report post-translational modifications, ligand interactions and conformational changes, revealing how the location and subtle timing of protein activity controls cell behavior.