Solubilities of Ethylene and Carbon Dioxide Gases in Lithium-Ion Battery Electrolyte.

During Li-ion battery operation, (electro)chemical side reactions occur within the cell that can promote or degrade performance. These complex reactions produce byproducts in the solid, liquid, and gas phases. Studying byproducts in these three phases can help optimize battery lifetimes. To relate the measured gas-phase byproducts to species dissolved in the liquid-phase, equilibrium proprieties such as the Henry's law constants are required. The present work implements a pressure decay experiment to determine the thermodynamic equilibrium concentrations between the gas and liquid phases for ethylene (C2H4) and carbon dioxide (CO2), which are two gases commonly produced in Li-ion batteries, with an electrolyte of 1.2 M LiPF6 in 3:7 wt/wt ethylene carbonate/ethyl methyl carbonate and 3 wt % fluoroethylene carbonate (15:25:57:3 wt % total composition). The experimentally measured pressure decay curve is fit to an analytical dissolution model and extrapolated to predict the final pressure at equilibrium. The relationship between the partial pressures and concentration of dissolved gas in electrolyte at equilibrium is then used to determine Henry's law constants of 2.0 × 104 kPa for C2H4 and k CO2 = 1.1 × 104 kPa for CO2. These values are compared to Henry's law constants predicted from density functional theory and show good agreement within a factor of 3.

Extracellular electron transfer across bio-nano interfaces for CO2 electroreduction.

Acetogenic bacteria represent a class of organisms capable of converting reducing equivalents and carbon dioxide into products with carbon-carbon bonds. Materials-based bio-electrochemical approaches are attractive for supplying biological organisms directly with grid-supplied electrons to convert carbon dioxide to value-added chemicals. Carbon nanotube-modified biocathodes have emerged as promising candidates for microbial electrosynthesis with high yields of carbon product formation, but a fundamental understanding of extracellular charge transfer at this electrode-biofilm interface is still lacking. Here, we utilize solid-state interfaces between semiconducting single-walled carbon nanotubes (s-SWCNT) and a model acetogenic bacterium for mechanistic studies of electro-catalytic CO2 conversion to acetate. Studies of bacteria/s-SWCNT interactions in a transistor-based device suggest direct extracellular electron transfer (EET) at the bio-nano interface. Deuterium isotope labeling experiments confirmed that the availability of electrochemically produced H2 as a redox mediator does not limit the efficiency of EET and CO2 electro-reduction for C. ljungdahlii biofilms, suggesting the primary reducing equivalents are the electrons delivered across the electrode/bacterium interface or involvement of biological redox mediators. Additional isotope labeling studies demonstrate high Faradaic efficiency for CO2 electro-reduction at the SWCNT/bacterium interface. These results provide important information about EET across the bacterium/material interface in a model biocathode.

Effect of Water Concentration in LiPF6-Based Electrolytes on the Formation, Evolution, and Properties of the Solid Electrolyte Interphase on Si Anodes.

A trace amount of water in an electrolyte is one of the factors detrimental to the electrochemical performance of silicon (Si)-based lithium-ion batteries that adversely affect the formation and evolution of the solid electrolyte interphase (SEI) on Si-based anodes and change its properties. Thus far, a lack of fundamental and mechanistic understanding of SEI formation, evolution, and properties in the presence of water has inhibited efforts to stabilize the SEI for improved electrochemical performance. Thus, we investigated the SEI formed in a Gen2 electrolyte (1.2 M LiPF6 in ethylene carbonate/ethyl methyl carbonate, 3:7 wt %, water content: <10 ppm) with and without additional water (50 ppm) at varying potentials (1.0, 0.5, 0.2, and 0.01 V vs Li/Li+). The impact of additional water on the morphological, (electro)chemical, and structural properties of SEI was studied using microscopic (atomic force microscopy and scanning spreading resistance microscopy) and spectroscopic (X-ray photoelectron spectroscopy, attenuated total reflection Fourier-transform infrared spectroscopy, and time-of-flight secondary ion mass spectrometry) techniques. The SEI exhibits both potential- and water concentration-dependent trends in its morphology and chemical composition. The presence of additional water in the electrolyte causes parasitic reactions, which onset at ∼1.0 V, resulting in a reduction of electrolyte components and result in the formation of an insulating, fluorophosphate-rich SEI. In addition, hydrolysis of LiPF6 creates hydrofluoric acid, which reacts with the surface oxide layer on the Si electrode, leading to a pitted and inhomogeneous SEI structure.

Structural Stabilization of P2-type Sodium Iron Manganese Oxides by Electrochemically Inactive Mg Substitution: Insights of Redox Behavior and Voltage Decay.

Layered P2-type Na0.8 Mn0.5 Fe0.5 O2 cathode material is a promising candidate for next-generation sodium-ion batteries due to the economical and environmentally benign characteristics of Mn and Fe. The poor cycling stability of the material, however, is still a problem that must be solved. To address the problem, electrochemically inactive Mg2+ was introduced into the structure by substituting some of the Fe ions. It was shown that Mg substitution led to a smoother voltage profile with improved cycling performance and rate capability. These observations were attributed to the suppressed structural changes during electrochemical processes. Detailed redox mechanisms, associated local structural changes, and phase transitions were investigated by X-ray absorption spectroscopy and X-ray diffraction. From the detailed analysis of electrochemical behaviors, it was also identified how the redox reactions and structural disordering occurred in the high- and low-voltage regions and how Mg substitution stabilized the structure.

Probing the Evolution of Surface Chemistry at the Silicon-Electrolyte Interphase via In Situ Surface-Enhanced Raman Spectroscopy.

We present a novel spectroscopic technique for in situ Raman microscopy studies of battery electrodes. By creating nanostructures on a copper mesh current collector, we were able to utilize surface-enhanced Raman spectroscopy (SERS) to monitor the evolution of the silicon anode-electrolyte interphase. The spectra show reversible Si peak intensity changes upon lithiation and delithiation. Moreover, an alkyl carboxylate species, lithium propionate, was detected as a significant SiEI component. Our experimental setup showed reproducible and stable performance over multiple cycles in terms of both electrochemistry and spectroscopy.

Polyimide dendrimers containing multiple electron donor-acceptor units and their unique photophysical properties.

A high-yielding synthesis of a series of polyimide dendrimers, including decacyclene- and perylene-containing dendrimer D6, in which two types of polyimide dyes are present, is reported. In these constructs, the branching unit is represented by trisphenylamine, and the solubilizing chains by N-9-heptadecanyl-substituted perylene diimides. The photophysical properties of the dendrimers have been studied by absorption, steady-state, and time-resolved emission spectroscopy and pump-probe transient absorption spectroscopy. Photoinduced charge-separated (CS) states are formed on the femtosecond timescale upon visible excitation. In particular, in D6, two different CS states can be formed, involving different subunits that decays independently with different lifetimes (ca. 10-100 ps).