Effect of Ultra-High Pressure Homogenization (UHPH) and Conventional Thermal Pasteurization on the Volatile Composition of Tiger Nut Beverage.

Tiger nut beverages are non-alcoholic products that are characterized by their pale color and soft flavor. Conventional heat treatments are widely used in the food industry, although heated products are often damaging to their overall quality. Ultra-high pressure homogenization UHPH) is an emerging technology that extends the shelf-life of foods while maintaining most of their fresh characteristics. The present work deals with the comparison of the effect of conventional thermal homogenization-pasteurization (H-P, 18 + 4 MPa at 65 °C, 80 °C for 15 s.) and UHPH (at 200 and 300 MPa, and inlet temperature of 40 °C), on the volatile composition of tiger nut beverage. Headspace-solid phase microextraction (HS-SPME) was used for detecting volatile compounds of beverages, which were then identified by gas chromatography-mass spectrometry (GC-MS). A total of 37 different volatile substances were identified in tiger nut beverages, which were primarily grouped into the aromatic hydrocarbons, alcohols, aldehydes and terpenes chemical families. Stabilizing treatments increased the total amount of volatile compounds (H-P > UHPH > R-P). H-P was the treatment that produced the most changes in the volatile composition of RP, while treatment at 200 MPa had a minor impact. At the end of their storage, these products were also characterized by the same chemical families. This study evidenced the UHPH technology as an alternative processing of tiger nut beverages production that minimally modifies their volatile composition.

Acid and Rennet Coagulation Properties of A2 Milk.

This study investigated the acid and rennet milk coagulation properties of A2 milk (ß-casein (CN) A2A2 genotype), in comparison to a control milk (blend of A2A1/A1A1/A2A2 genotypes). Acid and rennet coagulation were evaluated using the Optigraph® system, measuring the coagulation time, aggregation rate, and gel density or curd firmness. The acidification kinetics were monitored using a CINAC® system, evaluating the time to reach pH 4.6, the acidification rate, the maximum acidification rate, the time required to reach it, and the latency time. The water-holding capacity of acid milk gels and the potential yield, total solids, and syneresis of enzymatic gels were also evaluated. Some variables were highly influenced by the farm factor, showing the importance of the effect of extrinsic parameters. Acid and enzymatic coagulation times were not affected in either milk. The A2 milk presented higher acid gel density and latency time than the control milk. Although the differences in water-holding capacity were not statistically significant, the A2 milk presented lower values, related with the higher gel density. The A2 milk also showed higher rennet aggregation rate and curd firmness than the control milk. Potential yield and syneresis were higher in the A2 milk, which is in accordance with the higher firmness of curd. Coagulation results and gel and curd properties indicate that it is possible to manufacture acid and rennet coagulation dairy products from A2 milk with no major differences when compared with a control milk.

The Effect of Salt Reduction and Partial Substitution of NaCl by KCl on Physicochemical, Microbiological, and Sensorial Characteristics and Consumers' Acceptability of Semi-Hard and Hard Lactose-Free Cow's Milk Cheeses.

Increasing consumer demand for healthier foods prompts the development of cheeses reduced in salt. The aim of his study was to assess the effect of reducing the level of sodium chloride (NaCl) and their partial substitution by potassium chloride (KCl) on the biochemical, microbiological, and sensorial characteristics and consumer's acceptability of semi-hard and hard lactose-free cow's milk cheeses. To improve the possible lower salty taste or the development of bitter taste, the addition to yeast extract, as a flavor enhancer, was also checked. Different brining times and brine conditions were tested to obtain a reduction of >25% of salt with respect to conventional cheese. Reduced-salt cheeses were elaborated by reducing half the salting time used in conventional cheeses, and a ratio of 60 Na+:40 K+ was used to reduce Na concentration in substituted cheeses. The results obtained in this study show that the reduction of salt by both methods in semi-hard and hard lactose-free cheeses could be an alternative for the production of healthier and sensorial acceptable cheeses, without significantly affecting their physicochemical characteristics. The addition of yeast extract, as a flavor enhancer, increased the free amino acids (FAAs) levels but decreased the acceptability of cheeses.

Levels of Aflatoxin M1 in Breast Milk of Lactating Mothers in Monterrey, Mexico: Exposure and Health Risk Assessment of Newborns.

The present study aimed to determine the presence of the aflatoxin M1 (AFM1) in breast milk samples from 123 nursing women and the degree of exposure of infants to this toxin, in the metropolitan area of Monterrey, Nuevo Leon state (northeast Mexico). Upon analysis, 100% of the samples were found to be contaminated with the toxin at an average concentration of 17.04 ng/L, with a range of 5.00 to 66.23 ng/L. A total of 13.01% of the breast milk samples exceeded the regulatory limit of 25 ng/L for AFM1 concentration, set by the European Union. The estimated daily intake for AFM1 and the carcinogenic risk index were also determined in the 0- to 6-, 7- to 12-, 13- to 24-, and 25- to 36-month-old age groups. The AFM1 intake through breast milk ranged from 1.09 to 20.17 ng/kg weight/day, and was higher than the tolerable daily intake, indicating a carcinogenic risk for infants in the age groups of 0- to 24-months old. This evidence demonstrates a susceptibility of breast milk to AFM1 contamination that may suggest a carcinogenic risk for the breastfed infants in Monterrey city, Nuevo Leon state, and the need to control the presence of aflatoxins in foods eaten by nursing mothers.

Aflatoxin M1 Determination in Infant Formulae Distributed in Monterrey, Mexico.

The occurrence of aflatoxin M1 (AFM1) in infant formulae commercialized in the metropolitan area of Monterrey (Nuevo León, Mexico) was determined by using immunoaffinity column clean-up followed by HPLC determination with fluorimetric detection. For this, 55 infant formula powders were classified in two groups, starter (49 samples) and follow-on (6 samples) formulae. Eleven of the evaluated samples (20%) presented values above the permissible limit set by the European Union for infant formulae (25 ng/L), ranging from 40 to 450 ng/L. The estimated daily intake (EDI) for AFM1 was determined employing the average body weight (bw) of the groups of age in the ranges of 0-6 and 6-12 months, and 1-2 years. The results evidenced high intake values, ranging from 1.56 to 14 ng/kg bw/day, depending on the group. Finally, with the EDI value, the carcinogenic risk index was determined, presenting a high risk for all the evaluated groups. Based on these results, it is a necessary extra effort by the regulatory agencies to reduce the AFM1 presence in infant formulae consumed in Mexico.

Ultra-high pressure homogenisation of milk: technological aspects of cheese-making and microbial shelf life of a starter-free fresh cheese.

Fresh cheeses from pasteurised (80 °C for 15 s), homogenised-pasteurised (15 + 3 MPa at 60 °C; 80 °C for 15 s) or ultra-high pressure homogenised milks (300 MPa and inlet temperature of 30 °C) were produced in order to evaluate different technological aspects during cheese-making and to study their microbial shelf life. Although the coagulation properties of milk were enhanced by ultra-high pressure homogenisation (UHPH), the cheese-making properties were somewhat altered; both conventional homogenisation and UHPH of milk provoked some difficulties at cutting the curd due to crumbling and improper curd matting due to poor cohesion of the grains. Cheese-milk obtained by UHPH showed a higher microbiological quality than milk obtained by conventional treatments. Starter-free fresh cheeses made from UHPH-treated milk showed less syneresis during storage and longer microbiological shelf-life than those from conventionally treated milk samples.

Effects of high-pressure treatment on free fatty acids release during ripening of ewes' milk cheese.

The free fatty acid (FFA) profile of high pressure treated ewes' milk cheeses were studied to assess the effect of pressure treatment on cheese lipolysis. Cheeses were treated at 200, 300, 400 or 500 MPa (2P to 5P) at two stages of ripening (after 1 and 15 days of manufacturing; P1 and P15) and FFA were assayed at 1, 15 and 60 d ripening. On the first day of ripening, 3P1-cheeses showed levels of FFA twice that of the control cheeses. However, no significant differences were found between 3P1 and control cheeses at 60 d ripening. On the contrary, 4P1 and 5P1-cheeses had the lowest total FFA levels. The point at which pressure treatment was applied influenced the FFA profile of cheeses; cheeses pressurized at pressures<400 MPa on the first day of ripening were more similar to untreated cheeses than their homologues treated at 15 d.

Changes in the volatile composition of a semihard ewe milk cheese induced by high-pressure treatment of 300 MPa.

The effect of high-pressure (HP) treatment (300 MPa, 10 min) on the volatile profile of semihard ewe milk cheeses was investigated. The HP treatment was applied at two different stages of ripening (1 and 15 days; 3P1 and 3P15) and microbiota, proteolysis indexes (soluble nitrogen and total free amino acid content), and volatile compounds were assayed at 15, 60, 90, and 150 days of ripening. The intensity of odor and aroma of cheeses was also assayed. 3P1 cheeses presented the highest content of free amino acids and were characterized by the lowest amounts of aldehydes, ketones, short-chain free fatty acids, and terpenes and higher levels of ethanol and ethyl esters. 3P15 cheeses were characterized by the highest content of short-chain free fatty acids and pyruvaldehyde and the lowest abundance of secondary alcohols and were more similar to control cheeses than those HP-treated on the first day. Intensities of odor and aroma were not significantly influenced by the HP treatment. However, the panellists found some differences in 3P1 as compared with control and 3P15 cheeses in what they perceived as lower odor and aroma quality.