On the nanoscale structural evolution of solid discharge products in lithium-sulfur batteries using operando scattering.

The inadequate understanding of the mechanisms that reversibly convert molecular sulfur (S) into lithium sulfide (Li2S) via soluble polysulfides (PSs) formation impedes the development of high-performance lithium-sulfur (Li-S) batteries with non-aqueous electrolyte solutions. Here, we use operando small and wide angle X-ray scattering and operando small angle neutron scattering (SANS) measurements to track the nucleation, growth and dissolution of solid deposits from atomic to sub-micron scales during real-time Li-S cell operation. In particular, stochastic modelling based on the SANS data allows quantifying the nanoscale phase evolution during battery cycling. We show that next to nano-crystalline Li2S the deposit comprises solid short-chain PSs particles. The analysis of the experimental data suggests that initially, Li2S2 precipitates from the solution and then is partially converted via solid-state electroreduction to Li2S. We further demonstrate that mass transport, rather than electron transport through a thin passivating film, limits the discharge capacity and rate performance in Li-S cells.

Correlating Structural Properties with Electrochemical Behavior of Non-graphitizable Carbons in Na-Ion Batteries.

We report on a detailed structural versus electrochemical property investigation of the corncob-derived non-graphitizable carbons prepared at different carbonization temperatures using a combination of structural characterization methodology unique to this field. Non-graphitizable carbons are currently the most viable option for the negative electrode in sodium-ion batteries. However, many challenges arise from the strong dependence of the precursor's choice and carbonization parameters on the evolution of the carbon matrix and its resulting electrochemistry. We followed structure development upon the increase in carbonization temperature with thorough structural characterization and electrochemical testing. With the increase of carbonization temperature from 900 to 1600 °C, our prepared materials exhibited a trend toward increasing structural order, an increase in the specific surface area of micropores, the development of ultramicroporosity, and an increase in conductivity. This was clearly demonstrated by a synergy of small- and wide-angle X-ray scattering, scanning transmission electron microscopy, and electron-energy loss spectroscopy techniques. Three-electrode full cell measurements confirmed incomplete desodiation of Na+ ions from the non-graphitizable carbons in the first cycle due to the formation of a solid-electrolyte interface and Na trapping in the pores, followed by a stable second cycle. The study of cycling stability over 100 cycles in a half-cell configuration confirmed the observed high irreversible capacity in the first cycle, which stabilized to a slow decrease afterward, with the Coulombic efficiency reaching 99% after 30 cycles and then stabilizing between 99.3 and 99.5%. Subsequently, a strong correlation between the determined structural properties and the electrochemical behavior was established.

On the Practical Applications of the Magnesium Fluorinated Alkoxyaluminate Electrolyte in Mg Battery Cells.

High-performance electrolytes are at the heart of magnesium battery development. Long-term stability along with the low potential difference between plating and stripping processes are needed to consider them for next-generation battery devices. Within this work, we perform an in-depth characterization of the novel Mg[Al(hfip)4]2 salt in different glyme-based electrolytes. Specific importance is given to the influence of water content and the role of additives in the electrolyte. Mg[Al(hfip)4]2-based electrolytes exemplify high tolerance to water presence and the beneficial effect of additives under aggravated cycling conditions. Finally, electrolyte compatibility is tested with three different types of Mg cathodes, spanning different types of electrochemical mechanisms (Chevrel phase, organic cathode, sulfur). Benchmarking with an electrolyte containing a state-of-the-art Mg[B(hfip)4]2 salt exemplifies an improved performance of electrolytes comprising the Mg[Al(hfip)4]2 salt and establishes Mg[Al(hfip)4]2 as a new standard salt for the future Mg battery research.

Characterization of Electrochemical Processes in Metal-Organic Batteries by X-ray Raman Spectroscopy.

X-ray Raman spectroscopy (XRS) is an emerging spectroscopic technique that utilizes inelastic scattering of hard X-rays to study X-ray absorption edges of low Z elements in bulk material. It was used to identify and quantify the amount of carbonyl bonds in a cathode sample, in order to track the redox reaction inside metal-organic batteries during the charge/discharge cycle. XRS was used to record the oxygen K-edge absorption spectra of organic polymer cathodes from different multivalent metal-organic batteries. The amount of carbonyl bond in each sample was determined by modeling the oxygen K-edge XRS spectra with the linear combination of two reference compounds that mimicked the fully charged and the fully discharged phases of the battery. To interpret experimental XRS spectra, theoretical calculations of oxygen K-edge absorption spectra based on density functional theory were performed. Overall, a good agreement between the amount of carbonyl bond present during different stages of battery cycle, calculated from linear combination of standards, and the amount obtained from electrochemical characterization based on measured capacity was achieved. The electrochemical mechanism in all studied batteries was confirmed to be a reduction of double carbonyl bond and the intermediate anion was identified with the help of theoretical calculations. X-ray Raman spectroscopy of the oxygen K-edge was shown to be a viable characterization technique for accurate tracking of the redox reaction inside metal-organic batteries.

Sulfur valence-to-core X-ray emission spectroscopy study of lithium sulfur batteries.

In this work, valence-to-core (VtC) Kß sulfur X-ray emission spectroscopy (XES) was used to perform quantitative analysis of different sulfur compounds produced in a lithium sulfur (Li-S) battery during discharge. The analysis is based on the theoretical sulfur Kß XES spectra obtained from ab initio quantum chemical calculations based on density functional theory. The emphasis is given to the Kß sulfur XES spectra of the polysulfide molecules (Li2Sx, x = 2,,8) produced electrochemically within the Li-S battery. Ab initio molecular dynamics calculations are used further to calculate also the Kß spectra of Li2Sx dissolved in a model solvent. Calculated spectra were directly compared with the experimental ones collected with a Johansson type tender XES spectrometer on laboratory synthesized Li2Sx reference standards and pre-cycled battery cathodes. These results demonstrate that sulfur VtC XES can be used effectively to quantitatively analyze electrochemical sulfur conversion, also in a smaller laboratory without the need for large scale synchrotron facilities.

Characterization of Li-S Batteries Using Laboratory Sulfur X-ray Emission Spectroscopy.

Application of laboratory-based X-ray analytical techniques that are capable of a reliable characterization of the chemical state of sulfur within bulk battery cathode in parallel with electrochemical characterization is essential for further development of lithium-sulfur batteries. In this work, MeV proton-induced X-ray emission (XES) sulfur measurements were performed in ex situ mode on laboratory-synthesized sulfur standards and precycled battery cathodes. The average sulfur charge was determined from the energy shift of the Kα emission line and from the spectral shape of the Kß emission spectrum. Finally, operando Kα XES measurements were performed to monitor reduction of sulfur within battery cathode during discharge. The experimental approach presented here provides an important step toward more routine laboratory analysis of sulfur-based battery systems and also other sulfur-neighboring low-Z bulk materials with emission energies in the tender X-ray range.

Modifying the Silver-Titania Nanocomposites with Carbonaceous Materials to Remove the Pollutants from Domestic Waste Water.

The aim of this study was to prepare and characterize nanostructured composites based of TiO2, carbonaceus materials (GN or GO) and Ag and the test their capacity to remove the pollutants from domestic wastewater. The composites were characterized by IR and UV-Vis spectroscopy, X-ray diffraction, electron microscopy and nitrogen adsorption-desorption measurements. The photocatalytic activity was measured from the experiment of salicylic acid (SA) degradation. The capacity to remove the pollutants from domestic wastewater was performed by considering the absorbance of residual solution at 200 nm. The non-calcined composites have high specific surface area (˜300 m²/g), but nitrogen adsorption-desorption isotherms showed a porous structure with closed pores. The porosity of the thermal treated composites is about 10 times less, but the pores are open. The salicylic acid was 94% degraded over all composites, showing their efficient photoactivity. A percent of 70% of pollutants were removed over the calcined composites with GN and ˜67% on those with GO. It was no statistically significant difference between the photocatalytical efficiency of GN- and GO-based composites. Even if the calcined composites have the specific surface area about 10 times lower, their lower gap energy, higher degree of crystallinity and photocatalytic activity make them efficient candidates for removal of pollutants from domestic waste water. The photodegradation mechanism occurred mostly by π-π interactions between GN/GO and pollutant molecules.

Redox Mechanisms in Li and Mg Batteries Containing Poly(phenanthrene quinone)/Graphene Cathodes using Operando ATR-IR Spectroscopy.

The redox reaction mechanism of a poly(phenanthrene quinone)/graphene composite (PFQ/rGO) was investigated using operando attenuated total reflection infrared (ATR-IR) spectroscopy during cycling of Li and Mg batteries. The reference phenanthrene quinone and the Li and Mg salts of the hydroquinone monomers were synthesized and their IR spectra were measured. Additionally, IR spectra were calculated using DFT. A comparison of all three spectra allowed us to accurately assign the C=O and C-O- vibration bands and confirm the redox mechanism of the quinone/Li salt of hydroquinone, with radical anion formation as the intermediate product. PFQ/rGO also showed exceptional performance in an Mg battery: A potential of 1.8 V versus Mg/Mg2+ , maximum capacity of 186 mAh g-1 (335 Wh kg-1 of cathode material), and high capacity retention with only 8 % drop/100 cycles. Operando ATR-IR spectroscopy was performed in a Mg/organic system, revealing an analogous redox mechanism to a Li/organic cell.

Probing electrochemical reactions in organic cathode materials via in operando infrared spectroscopy.

Organic materials are receiving an increasing amount of attention as electrode materials for future post lithium-ion batteries due to their versatility and sustainability. However, their electrochemical reaction mechanism has seldom been investigated. This is a direct consequence of a lack of straightforward and broadly available analytical techniques. Herein, a straightforward in operando attenuated total reflectance infrared spectroscopy method is developed that allows visualization of changes of all infrared active bands that occur as a consequence of reduction/oxidation processes. In operando infrared spectroscopy is applied to the analysis of three different organic polymer materials in lithium batteries. Moreover, this in operando method is further extended to investigation of redox reaction mechanism of poly(anthraquinonyl sulfide) in a magnesium battery, where a reduction of carbonyl bond is demonstrated as a mechanism of electrochemical activity. Conclusions done by the in operando results are complemented by synthesis of model compound and density functional theory calculation of infrared spectra.

Biomass-Derived Heteroatom-Doped Carbon Aerogels from a Salt Melt Sol-Gel Synthesis and their Performance in Li-S Batteries.

An ionothermal sol-gel strategy to synthesize hierarchically porous carbon aerogels doped with different heteroatoms is presented by using biomass precursors in a scalable process. Morphologically similar but chemically different materials are used to study the influence of heteroatoms in Li-S batteries. The materials show capacities as high as 1290 mAh g(-1) in the first cycle using 50 wt % S loading. Heteroatom doping reduces the capacity fading and the polarization throughout cycling. Zeta potential measurements reveal positive surface charges for heteroatom-doped carbons and indicate attractive interactions with polysulfides causing reduced fading. A polysulfide-selective sorption study reveals strongly different adsorption behavior depending on the carbon's chemical composition. Interestingly, the polysulfide fraction is also crucial. The results indicate that improved adsorption of long-chain polysulfides to doped carbons is related to improved capacity retention.