RESUMEN
A single crystal of SrTiO3doped with 0.5 wt% niobium (Nb-STO) was irradiated with 200 MeV Au32+ions at grazing incidence to characterize the irradiation-induced hillock chains. Exactly the same hillock chains are observed by using atomic force microscopy (AFM) and scanning electron microscopy (SEM) to study the relation between irradiation-induced change of surface topography and corresponding material property changes. As expected, multiple hillocks as high as 5-6 nm are imaged by AFM observation in tapping mode. It is also found that the regions in between the adjacent hillocks are not depressed, and in many cases they are slightly elevated. Line-like contrasts along the ion paths are found in both AFM phase images and SEM images, indicating the formation of continuous ion tracks in addition to multiple hillocks. Validity of preexisting models for explaining the hillock chain formation is discussed based on the present results. In order to obtain new insights related to the ion track formation, cross-sectional transmission electron microscopy (TEM) observation was performed. The ion tracks in the near-surface region are found to be relatively large, whereas buried ion tracks in the deeper region are relatively small. The results suggest that recrystallization plays an important role in the formation of small ion tracks in the deep region, whereas formation of large ion tracks in the near-surface region is likely due to the absence of recrystallization. TEM images also show shape deformation of ion tracks in the near-surface region, suggesting that material transport towards the surface is the reason for the absence of recrystallization.
RESUMEN
As surface-only materials, freestanding 2D materials are known to have a high level of contamination-mostly in the form of hydrocarbons, water, and residuals from production and exfoliation. For well-designed experiments, it is of particular importance to develop effective cleaning procedures, especially since standard surface science techniques are typically not applicable. We perform ion spectroscopy with highly charged ions transmitted through freestanding atomically thin materials and present two techniques to achieve clean samples, both based on thermal treatment. Ion charge exchange and energy loss are used to analyze the degree of sample contamination. We find that even after cleaning, heavily contaminated spots remain on single layer graphene. The contamination coverage, however, clusters in strand-like structures leaving large clean areas. We present a way to discriminate clean from contaminated areas with our ion beam spectroscopy if the heterogeneity of the surface is increased sufficiently enough. We expect a similar discrimination to be necessary in most other experimental techniques.
RESUMEN
The impact of individual slow highly charged ions (HCI) on alkaline earth halide and alkali halide surfaces creates nano-scale surface modifications. For different materials and impact energies a wide variety of topographic alterations have been observed, ranging from regularly shaped pits to nanohillocks. We present experimental evidence for the creation of thermodynamically stable defect agglomerations initially hidden after irradiation but becoming visible as pits upon subsequent etching. A well defined threshold separating regions with and without etch-pit formation is found as a function of potential and kinetic energies of the projectile. Combining this novel type of surface defects with the previously identified hillock formation, a phase diagram for HCI induced surface restructuring emerges. The simulation of the energy deposition by the HCI in the crystal provides insight into the early stages of the dynamics of the surface modification and its dependence on the kinetic and potential energies.
RESUMEN
The individual impacts of slow (300 eV/amu) highly charged Xe ions induce nanometer sized pitlike structures on the KBr (001) surface. The volume of these structures shows a strong dependence on the ions potential energy. Total potential sputter yields from atomically flat (001) terraces are determined by imaging single ion impact sites. The dependence of the sputter yield on the ions initial charge state combined with structure formation at low and high-fluence irradiations indicates that agglomeration of defects into complex centers plays a major role in the desorption process induced by the potential energy.