High Performance of Post-Treated PEDOT:PSS Thin Films for Thermoelectric Power Generation Applications.

Thermoelectric materials capable of converting waste heat energy into electrical energy are enchanting for applications in wearable electronics and sensors by harvesting heat energy of the human body. Organic conducting polymers offer promise of thermoelectric materials for next-generation power sources of wearable devices due to their low cost in preparation, easy processing, low toxicity, low thermal conductivity, mechanical flexibility, light weight, and large area application. Generally, the pristine PEDOT:PSS film has low electrical conductivity, small Seebeck coefficient, and low thermal conductivity. The thermoelectric power factors of conducting polymers of p-type PEDOT:PSS films are considerably improved via synergistic effect by using ethylene glycol and reductants of EG/NaBH4 or EG/NaHCO3. As such, the charge carrier concentration of PEDOT:PSS films is tuned. The synergistic effect might lead to enhanced variation of density of states at the Fermi level and hence enhanced Seebeck coefficient. The resulting PEDOT:PSS films were characterized by atomic force microscopy (AFM), Raman spectroscopy, and XPS spectroscopy. The electrical conductivity and Seebeck coefficient were measured between 325 and 450 K. The carrier concentration and mobility were obtained by Hall measurements. The pristine thin film treated with 0.05 M EG/NaHCO3 solution exhibits the highest power factor of 183 µW m-1 K-2 at 450 K among these two series of films due to its significant enhanced Seebeck coefficient of 48 µV/K. The maximum output power of 121.08 nW is attained at the output voltage of 6.98 mV and the output current of 17.45 µA. The corresponding maximum power density is 98 µW/cm2 for a power generation device made of four pairs of p-leg (EG/NaHCO3 post-treated PEDOT:PSS) and n-leg (Cu0.6Ni0.4) on the polyamide substrate with the size of 4 mm × 20 mm for each leg.

Doubly resonant surface-enhanced Raman scattering on gold nanorod decorated inverse opal photonic crystals.

We present a novel type of surface-enhanced Raman scattering (SERS) substrate constituted of a 3-dimensinal polymeric inverse opal (IO) photonic crystal frame with gold nanorods (Au-NRs) decorating on the top layer. This substrate employs resonant excitation as well as constructive backward scattering of Raman signals to produce large enhancement of SERS output. For the incoming excitation, Au-NRs with appropriate aspect ratio were adopted to align their longitudinal localized surface plasmon band with the excitation laser wavelength. For the outgoing SERS signal, the spectral position of the photonic band gap was tuned to reflect Raman-scattered light constructively. This SERS substrate produces not only strong but also uniform SERS output due to the well control of Au-NRs distribution by the periodic IO structure, readily suitable for sensing applications.

Hybrid surface-enhanced Raman scattering substrate from gold nanoparticle and photonic crystal: maneuverability and uniformity of Raman spectra.

A novel hybrid surface-enhanced Raman scattering (SERS) substrate based on Au nanoparticles decorated inverse opal (IO) photonic crystal (PhC) is presented. In addition to the enhancement contributed from Au nanoparticles, a desired Raman signal can be selectively further enhanced by appropriately overlapping the center of photonic bandgap of the IO PhC with the wavelength of the Raman signal. Furthermore, the lattice structure of the IO PhC provides excellent control of the distribution of Au nanoparticles to produce SERS spectra with high uniformity. The new design of SERS substrate provides extra maneuverability for ultra-high sensitivity sensor applications.

Fluorescence single-molecule study of cobra phospholipase A2 action on a supported gel-phase lipid bilayer.

Previous nanoscale investigations of the gel-state membrane surface structure under the action of phospholipase A(2) (PLA(2)) suggest that single enzymes at work scoot on the membrane surface from the observed defects, which creates nanosized channels oriented along the lipid crystal-packing structure. To date, however, there have been no reports of direct observation of PLA(2) at the single-molecule level focusing on how the enzymes interact with the defects. Herein, we report a single-molecule fluorescence microscopy study on the action of enzymatically active rhodamine B-labeled cobra PLA(2) on a supported lipid membrane with visible packing defects on a glass substrate. Working with a gel-state phospholipid bilayer, the low-activity period (lag phase) of PLA(2) action is followed by the burst binding of PLA(2) molecules from aqueous solution on a few newly created active sites. These active sites are distinguished by a spatial resolution of approximately 40 nm, which is below the diffraction limit. The rate of active-site propagation as reflected by new PLA(2) binding on the membrane surface is estimated to be approximately 5 nm min(-1). This rate is about two orders of magnitude slower than the propagation rate of hydrolyzed channels estimated by AFM studies on bee venom PLA(2) on a similar membrane surface. This direct observation of PLA(2) molecules allows the visualization of different PLA(2) binding modes on the membrane surface and on the membrane boundary.

A new protein A assay based on Raman reporter labeled immunogold nanoparticles.

A unique, sensitive, highly specific, and photobleaching-resistant immunoassay system utilizing gold nanoparticles and surface-enhanced Raman scattering (SERS) is described. This new system, featuring a capability of bifunctional analysis, is manufactured by chemisorption of antibody immunoglobulin G (IgG) on gold nanoparticles (AuNP), followed by coupling the Raman-active reporter molecule, 5,5'-dithiobis(2-nitrobenzoic acid) (DTNB) to the surface of IgG-AuNP. The adsorbed DTNB molecules exhibit strong Raman signals via both electromagnetic and chemical enhancement. The narrow spectral widths and high photostability assure the system to be an excellent detection label. This SERS-based immunoassay is applied to the detection of protein A, which is a specific surface antigen of Staphylococcus aureus. A working curve is obtained by plotting the intensity of the SERS signal of symmetric NO(2) stretching of DTNB at 1,333 cm(-1) versus the concentration of the analyte (antigen). A dynamic range of two to three orders of magnitude and a detection limit of 1 pg/mL of protein A are achieved.