Reduction of cervical vertebra ghost images in panoramic radiography using vertical dual exposure.

PURPOSE: To evaluate the image quality of vertical dual-exposure panoramic radiography (PR), which merges two PR images taken at different focus heights to reduce ghost images of cervical vertebrae (CV) and intervertebral spaces (IVS) in the incisor region. METHODS: PR images of an aluminum block, a CV phantom and a human head phantom were taken at 0 mm and merged with and subtracted from PR images taken at other heights (0, 5, 10, 15, and 20 mm) to create new images, e.g., Merg0 + 15 mm and Sub0 - 10 mm. The subtracted images were analyzed subjectively according to the uniformity on the line profile. Merged images were evaluated subjectively by six raters to determine the influence of the ghost images. RESULTS: Objective evaluation revealed a positional shift in the ghost images according to the height of the focus for both phantoms. In the subjective evaluation, the normal PR (Merg0 + 0 mm) showed the worst score, indicating strong influence of CV and IVS ghost images. CONCLUSION: The vertical dual-exposure PR method, which merges PR images taken at the normal position and a higher X-ray focus, can reduce CV and IVS ghost images in the incisor region.

Vertical magnification correction in vertical dual-exposure panoramic radiography.

PURPOSE: To clarify the magnification error caused by the degree of tilt of the incisor and the elevation of the X-ray focus position, and the verification effect of magnification correction when performing vertical dual-exposure panoramic radiography. METHODS: Panoramic radiographic images of a phantom embedding 26 steel balls were taken at different heights (0, 5, 10, 15, and 20 mm) and tilt angles (0°, 10°, 20°, and 30°) to evaluate vertical magnification in each condition. Error and correlation coefficients in the vertical magnifications were calculated between the measured and theoretical magnification values. RESULTS: The more the steel ball phantom was tilted, the more the images of the uppermost steel balls were laterally stretched. In the vertical direction, image magnification also influenced the tilt angle of the object in the incisal region. The range of error in vertical magnification was -0.35-0.30%. The Spearman's rank correlation coefficient between the measured and theoretical magnification value was 0.983. CONCLUSION: Vertical magnification correction has the potential to improve image quality when merging panoramic radiographs in vertical dual-exposure panoramic radiography.

Correction of intraoral radiography with dual imaging plates using enlargement of the horizontal direction with division into 12 blocks.

PURPOSE: The dual imaging plate (DIP) method, which synthesizes intraoral radiographs from a front imaging plate (FIP) and a back imaging plate (BIP), produces adequate image quality and allows the radiation dose to be reduced. However, there are slight errors in superimposition and alignment between the FIP and BIP. The aim of this study was to establish positional correction in the DIP method and evaluate the effect. METHODS: Six sets of two imaging plates were used for imaging a mesh plate and a porcine mandible phantom. Subtraction images between FIP and BIP images were synthesized in four steps: correcting horizontal and vertical direction, rotation, enlargement ratio, and enlargement ratio into 12 blocks. Variance of the pixel value on the subtraction images at each step was compared to evaluate the alignment of FIP and BIP images. RESULTS: The variance of the pixel values in the subtraction images was gradually and significantly decreased by each step of image processing (P < 0.01), indicating that the degree of alignment of FIP and BIP images improved during the image processing. CONCLUSION: The present study revealed that it is possible to synthesize more precise DIP images using an additional four-step image processing technique.

Reduction of scratch or dirt artifacts on intraoral radiographs using dual imaging plates in image processing.

OBJECTIVES: Artifacts including scratches and dirt artifacts on the digital intraoral radiographs finally contribute to making inaccurate diagnoses. The aim of this study was to reduce the incidence of artifacts using dual imaging plates (DIPs) in imaging processing. METHODS: Conventional X-rays were taken of a porcine mandible embedded in acrylic resin using a DIP which consists of a front IP (FIP) and a back IP (BIP) with some scratches and dirt. The two images of the FIP and BIP were then synthesized and averaged to obtain a conventional DIP image. The following image processing method was used to make a DIP with artifact reduction (DIP+AR) image. A subtraction image of the FIP and BIP was constructed and the standard deviation (SD) was calculated. If the pixel value was over 3SD on the subtraction images, the pixel value of the DIP was swapped with the value on the opposite side of the non-artifact pixel. The conventional and DIP+AR images were also subjectively evaluated. RESULTS: Image processing to create a DIP+AR image was able to reduce the number of artifacts. Medians of number of artifacts evaluated were 2.00 [interquartile range (IQR), 2.50] in DIP images and 0.67 (IQR, 1.29) in DIP+AR images, indicating a significant reduction of number of artifacts in DIP+AR images. CONCLUSIONS: DIP+AR image processing can reduce the incidence of artifacts caused by scratches and dirt, and could extend the lifespan of the IP and contribute accurate diagnosis in oral radiology.

Preliminary evaluation of dual imaging plate intraoral radiography.

PURPOSE: This study evaluated the contrast-to-noise ratio (CNR), spatial resolution, and subjective quality of dual imaging plates (DIP) intraoral radiography. METHODS: The DIP and conventional single IP (CSIP) methods both used YCR DT-1 imaging plates (Yoshida Co.). The DIP, comprising a front IP (FIP) and back IP (BIP), was constructed. DIP images were synthesized from the FIP and BIP images. An aluminum step phantom was used to measure the CNR. A line pair gauge was used to measure the spatial imaging resolution. A phantom comprising a porcine mandible embedded in acrylic resin was used for subjective evaluation. RESULTS: The CNR of the DIP image was 32% higher than that of the FIP image. The spatial resolution achieved using the FIP, DIP, and CSIP was highly comparable except above 4 line pairs/mm, where that of the CSIP was highest. In subjective evaluation, the noise in the DIP images was significantly lower than in those obtained using the FIP and CSIP. CONCLUSION: The CNR of the DIP was higher than that of the FIP. The decrease in spatial resolution of the DIP was limited. The subjective image quality of the DIP was higher than that of the FIP.

Newly developed mastication activity reduction procedure rapidly induces abnormal atrophic change of the mandibular condyle in young and elder experimental animal models.

This study was performed to develop a new rat model of reduced masticatory activity in order to assess the effect of this reduction on the morphology of the temporomandibular joint (TMJ) over time. Female rats were used, and ovariectomy was performed to simulate aged/postmenopausal status. Twenty-four SD rats aged 6 weeks were divided into four groups: ovariectomy/sham procedure (Ov/S); ovariectomy/reduced masticatory activity (Ov/RMA); non-Ov/S (NO/S); and non-Ov/RMA (NO/RMA). The RMA procedure involved grinding down the edges of the upper and mandibular incisors by about 3 mm and supplying the rats with a powdered diet. The bilateral TMJ was examined by micro-computed tomography at 0, 1, 2, 4, 6, and 8 weeks after the start of RMA. Condylar width was greater in the NO/S group than in the Ov/S group after the 2nd week, showing that ovariectomy reduced the width of the condyle. After the 2nd week, significant differences in condylar width were apparent between the NO/S and NO/RMA groups, and between the Ov/S and Ov/RMA groups. This RMA procedure appeared to provide a good model of reduced masticatory activity. The present findings in female rats suggest that reduction of appropriate mastication activity in the growth period results in poor growth of the mandibular condyle and immediately induces atrophy of the mandibular condyle under conditions simulating aged/postmenopausal status.

Diagnostic reliability of 3.0-T MRI for detecting osseous abnormalities of the temporomandibular joint.

We compared the diagnostic reliability of 3.0-T magnetic resonance imaging (MRI) for detection of osseous abnormalities of the temporomandibular joint (TMJ) with that of the gold standard, cone-beam computed tomography (CBCT). Fifty-six TMJs were imaged with CBCT and MRI, and images of condyles and fossae were independently assessed for the presence of osseous abnormalities. The accuracy, sensitivity, and specificity of 3.0-T MRI were 0.88, 1.0, and 0.73, respectively, in condyle evaluation and 0.91, 0.75, and 0.95 in fossa evaluation. The McNemar test showed no significant difference (P > 0.05) between MRI and CBCT in the evaluation of osseous abnormalities in condyles and fossae. The present results indicate that 3.0-T MRI is equal to CBCT in the diagnostic evaluation of osseous abnormalities of the mandibular condyle.

Micro-CT observation of in vivo temporal change in mandibular condyle morphology in BMAL1 knockout mice.

Brain and muscle Arnt-like protein-1 (BMAL1) knockout mice exhibit accelerated aging, abnormal glucose metabolism, and impaired adipocyte differentiation, among other phenotypes, which are effects associated with the BMAL1 gene. No study has investigated temporal changes in the deformation of the mandibular condyle and the presence of calcification in areas surrounding the mandibular condyle. In a study of 12 C57/BL strain mice under inhalation anesthesia, we collected images of the mandibular condyle at 6 weeks after birth and then every 5 weeks from 10 to 25 weeks after birth. At 25 weeks, deformation of the mandibular condyle was seen in 8 of 12 joints in BMAL1 knockout mice and in 2 of 12 joints in wild-type mice. At 20 and 25 weeks, deformation in areas surrounding the mandibular condyle, which are known to undergo calcification, was seen in 2 of 12 joints in BMAL1 knockout mice and in 0 of 12 joints in wild-type mice. BMAL1 knockout mice exhibited premature aging of the mandibular condyle, which suggests that circadian rhythms affect mandibular condyle morphology.

Diverse calcification patterns of ameloblastic fibro-odontoma on radiographic examination.

The occurrence of ameloblastic fibro-odontoma (AFO) in the oral region is unusual and accounts for 1-3% of all odontogenic tumors. AFO presents mixed radiopaque patterns within the lesion with diverse findings; therefore, it is important to compare this tumor with other odontogenic tumors that radiographically present with calcified bodies. Herein, we observed the calcification patterns within the lesion in seven AFO cases (five males, two females; mean age, 8.3 years; age range, 4-13 years). Periapical and panoramic radiographs were obtained from all seven cases. Five cases underwent conventional computed tomography (CT) scanning, and one underwent cone beam CT. Classification of the calcifications primarily involved the following two characteristics on the X-rays: appearance and location of the lesions. All seven cases were located in the molar regions of the mandible in association with impacted teeth. The calcification patterns of these AFOs were mixed or inhomogeneous within the lesion with various findings, including complex odontoma-like calcifications. However, the patterns differed between panoramic radiography and CT in some cases. The radiolucent lesions in AFO demonstrated varying calcification patterns and were associated with impacted teeth on the CT images.(J Oral Sci 58, 533-537, 2016).

Discrepancy of coronal morphology between mandibular condyle and fossa is related to pathogenesis of anterior disk displacement of the temporomandibular joint.

OBJECTIVE: To evaluate whether morphological discrepancy between the mandibular condyle and fossa of the temporomandibular joint (TMJ) is related to disk displacement on magnetic resonance imaging (MRI). STUDY DESIGN: This study included 61 patients with unilateral internal derangement based on both MRI and clinical examination. Coronal morphologies of the condyle and fossa were divided into four groups based on Öberg's classification. According to the coronal morphology of the condyle and fossa, all joints were dichotomized into either harmonized group or a discrepancy group (e.g., angled condyle and concave fossa). The incidence of discrepancy and the relationship of the discrepancy to other findings on MRI were statistically evaluated. RESULTS: The discrepancy had a significantly higher incidence on the affected side. The discrepancy correlated with incidence of disk deformity on the affected side. CONCLUSION: Morphological discrepancy between the condyle and fossa is related to development of anterior disk displacement in the TMJ.

Influence of metal artifacts on in vivo micro-CT for orthodontic mini-implants.

This study aimed to show the effects of metal artifacts on the in vivo micro-CT of mini-implants by measuring bone volume. We drilled a hole in the cortical bone of a rat tibia and embedded a titanium orthodontic mini-implant (diameter, 1.5 mm) in the hole. Twelve individually weighed hydroxyapatite grains (HA grains) were placed around the implant either by one dentist (method 1) or separately by 12 dentists (method 2). In vivo micro-CT was used to scan the model after placement of each grain to measure increases and decreases in bone volume voxel number. The subtracted bone voxel volume increased with HA weight in both methods. Simple linear regression analysis showed a significant correlation between weight and volume in both methods (method 1: regression coefficient: 516.502, P < 0.05; method 2: regression coefficient: 4837.432, P < 0.05). Metal artifacts did not appear to influence measurements of bone volume, although further studies are required to determine the effect of thicker implants.