Light Scattering of Electrospinning Jet with Internal Structures by Flow-Induced Phase Separation.

Herein, the direct morphological evidence of the extension-induced phase-separated structures in the electrospinning jet observed by high-speed video imaging and by light scattering technique is reported. Model solutions of poly(vinyl alcohol) (PVA)/water are electrospun. Two types of internal structures, that is, long strings and short ellipsoids, are found. A light scattering model is derived for the Vv scattering configuration to account for the scattered intensities contributed from the liquid jet itself and those from the internal structures. For the severely stretching jet of PVA/water, the Vv intensity profile is dominant by the internal structures to mask the scattering contribution from the jet itself. Moreover, the Hv intensity profile reflects the anisotropy of the oriented chains parallel to the jet axis. For the 7 wt% solution, the derived extension rate in the vicinity of the Taylor cone apex is about 3420 s-1 , which is higher than the Rouse relaxation rate measured by rheometer. It is concluded that extension-induced phase separation of the single-phase PVA solution is likely to occur in Taylor-cone apex to trigger the self-assembly process for producing strings (and/or bulges) in the flowing jet, which eventually transform to become the nanofibers, after solvent removal, to be collected on the grounded collector.

Robust deep brain stimulation functional MRI procedures in rats and mice using an MR-compatible tungsten microwire electrode.

PURPOSE: To develop a series of robust and readily adoptable protocols for the application of deep brain stimulation (DBS)-functional MRI (fMRI) in rodents. METHODS: DBS-fMRI procedures were conducted in rat and mouse under varying anesthetic conditions (isoflurane in rat and mouse, α-chloralose in rat). A homemade two-channel tungsten microwire electrode was used to minimize magnetic susceptibility artifacts, and was targeted to the ventral posteromedial (VPM) thalamus for DBS-fMRI scanning procedures. RESULTS: Compared with a commercially available MR-compatible electrode, the tungsten microwire generated greatly reduced magnetic-susceptibility artifacts. In the rat, VPM-DBS using the microwire electrode resulted in robust positive blood-oxygen-level-dependent signal changes in somatosensory cortex that were relatively independent of anesthetic type. In the mouse, VPM-DBS similarly generated large, positive neurovascular responses in somatosensory cortex that were detected using cerebral blood volume measurements. CONCLUSION: Collectively, this work describes reasonable and easily adoptable procedures for conducting DBS-fMRI studies in rodent models. The protocols developed herein may be extended to study DBS effects under numerous experimental conditions and at varying stimulation targets.

Conductive nanogel-interfaced neural microelectrode arrays with electrically controlled in-situ delivery of manganese ions enabling high-resolution MEMRI for synchronous neural tracing with deep brain stimulation.

Chronic brain stimulation has become a promising physical therapy with increased efficacy and efficiency in the treatment of neurodegenerative diseases. The application of deep brain electrical stimulation (DBS) combined with manganese-enhanced magnetic resonance imaging (MEMRI) provides an unbiased representation of the functional anatomy, which shows the communication between areas of the brain responding to the therapy. However, it is challenging for the current system to provide a real-time high-resolution image because the incorporated MnCl2 solution through microinjection usually results in image blurring or toxicity due to the uncontrollable diffusion of Mn2+. In this study, we developed a new type of conductive nanogel-based neural interface composed of amphiphilic chitosan-modified poly(3,4 -ethylenedioxythiophene) (PMSDT) that can exhibit biomimic structural/mechanical properties and ionic/electrical conductivity comparable to that of Au. More importantly, the PMSDT enables metal-ligand bonding with Mn2+ ions, so that the system can release Mn2+ ions rather than MnCl2 solution directly and precisely controlled by electrical stimulation (ES) to achieve real-time high-resolution MEMRI. With the integration of PMSDT nanogel-based coating in polyimide-based microelectrode arrays, the post-implantation DBS enables frequency-dependent MR imaging in vivo, as well as small focal imaging in response to channel site-specific stimulation on the implant. The MR imaging of the implanted brain treated with 5-min electrical stimulation showed a thalamocortical neuronal pathway after 36 h, confirming the effective activation of a downstream neuronal circuit following DBS. By eliminating the susceptibility to artifact and toxicity, this system, in combination with a MR-compatible implant and a bio-compliant neural interface, provides a harmless and synchronic functional anatomy for DBS. The study demonstrates a model of MEMRI-functionalized DBS based on functional neural interface engineering and controllable delivery technology, which can be utilized in more detailed exploration of the functional anatomy in the treatment of neurodegenerative diseases.

SPIO nanoparticle-stabilized PAA-F127 thermosensitive nanobubbles with MR/US dual-modality imaging and HIFU-triggered drug release for magnetically guided in vivo tumor therapy.

Nanobubbles can serve as promising, next-generation theranostic platforms for ultrasound (US) and magnetic resonance (MR) imaging, and combined magnetic targeting (MT) and high-intensity focused ultrasound (HIFU)-triggered drug release for tumor therapy. Nanobubble-based dual contrast enhancement agents encapsulated with perfluoropentane and stabilized with superparamagnetic iron oxide (SPIO) nanoparticles have been synthesized through a single-step emulsion process from thermosensitive F127 and polyacrylic acid (PAA). Both US and MR imaging contrast can be optimized by varying the shell thickness and SPIO-embedded concentration. The US contrast can be enhanced from a mean gray value of 62 to 115, and the MR r2 value can be enhanced from 164 to 208 (s(-1)mM (-1)Fe) by increasing the SPIO concentration from 14.1 to 28.2mg/mL, respectively. In vivo investigations of SPIO-embedded nanobubbles in excised tumors under external MT revealed that the US and MR signals change quantitatively compared to the same site without MT. This combined strategy enables the nanobubbles to enhance both passive targeting (increasing the permeability by HIFU) and physical MT of chemotherapeutic drugs to tumors. The integration of functionalities makes this nanobubble system a powerful and viable new tool to achieve simultaneous in vivo tumor imaging and efficacious cancer therapy.

Design and fabrication of a polyimide-based microelectrode array: application in neural recording and repeatable electrolytic lesion in rat brain.

The design and testing of a new microelectrode array, the NCTU (National Chiao Tung University) probe, was presented. Evaluation results showed it has good biocompatibility, high signal-to-noise ratio (SNR: the root mean square of background noise to the average peak-to-peak amplitude of spikes) during chronic neural recordings, and high reusability for electrolytic lesions. The probe was a flexible, polyimide-based microelectrode array with a long shaft (14.9 mm in length) and 16 electrodes (5 microm-thick and 16 microm in radius); its performance in chronic in vivo recordings was examined in rodents. To improve the precision of implantation, a metallic, impact-resistant layer was sandwiched between the polyimide layers to strengthen the probe. The three-dimensional (3D) structure of electrodes fabricated by electroplating produced rough textures that increased the effective surface area. The in vitro impedance of electrodes on the NCTU probe was 2.4+/-0.52 MOmega at 1 kHz. In addition, post-surgical neural recordings of implanted NCTU probes were conducted for up to 40 days in awake, normally behaving rats. The electrodes on the NCTU probe functioned well and had a high SNR (range: 4-5) with reliable in vivo impedance (<0.7 MOmega). The electrodes were also robust enough to functionally record events, even after the anodal current (30 microA, 10s) was repeatedly applied for 60 times. With good biocompatibility, high and stable SNR for chronic recording, and high tolerance for electrolytic lesion, the NCTU probe would serve as a useful device in future neuroscience research.