Feasibility of supercritical CO2 treatment for controlling biofouling in the reverse osmosis process.

Physical cleaning and/or chemical cleaning have been generally used to control biofouling in the reverse osmosis (RO) process. However, conventional membrane cleaning methods to control biofouling are limited due to the generation of by-products and the potential for damage to the RO membranes. In this study, supercritical carbon dioxide (SC CO(2)) treatment, an environmentally friendly technique, was introduced to control biofouling in the RO process. SC CO(2) (100 bar at 35°C) treatment was performed after biofouling was induced on a commercial RO membrane using Pseudomonas aeruginosa PA01 GFP as a model bacterial strain. P. aeruginosa PA01 GFP biofilm cells were reduced on the RO membrane by >8 log within 30 min, and the permeate flux was sufficiently recovered in a laboratory-scale RO membrane system without any significant damage to the RO membrane. These results suggest that SC CO(2) treatment is a promising alternative membrane cleaning technique for biofouling in the RO process.

Ring-opening polymerization of L-lactide and preparation of its microsphere in supercritical fluids.

The ring-opening polymerization of L-lactide initiated by stannous octoate was carried out in supercritical chlorodifluoromethane (scR22) at various reaction conditions (time and temperature) and reactant concentrations (initiator, monomer, and solvent). The monomer conversion increased to ca. 70% on increasing the reaction time to 1 h. The molecular weight of the poly(L-lactide) (PLLA) product also increased to ca. 160,000 g x mol(-1) over the same period. Increasing reaction temperature from 90 to 130 degrees C resulted in increased monomer conversion and PLLA molecular weight. A series of polymerizations conducted at various 1-dodecanol and stannous octoate concentrations suggested that stannous octoate does not act as an initiator by itself, and that the tin-alkoxide formed from 1-dodecanol and stannous octoate serves as the initiating species in scR22. While enhancements of the monomer conversion and PLLA molecular weight were observed with increasing monomer concentration, the chlorodifluoromethane concentration had the opposite on both. After the polymerization, PLLA microspheres were prepared in situ by using a continuous supercritical antisolvent process without residual organic solvent and monomer to yield highly purified microspheres for environmental and biomedical applications.

Evaluation of hot compressed water pretreatment and enzymatic saccharification of tulip tree sawdust using severity factors.

Tulip tree sawdust was pretreated using hot compressed water with different pretreatment severities (LogR0, 3.05-5.01) by varying reaction temperatures (180-220°C) and residence time (1-30 min). It is found that the chemical composition and physicochemical properties of the pretreated products can be characterized and correlated with severity. Removal of most of the xylan and other hemicellulosic sugars from the raw material was observed at a severity of 4.5. Thus, the residual solids were recovered with increased cellulose and lignin contents. Nearly complete glucan conversion was achieved after 48 h of hydrolysis with 10 FPU/g of wet residual solid obtained above a severity of 4.8. The characteristics of the pretreated solids according to the pretreatment severity were strongly related with the glucose yield. The removal of structural barriers to the enzyme attack was the dominant factor affecting enzyme accessibility to the substrate.

Impact of bleaching on subcritical water- and Formosolv-pretreated tulip tree to enhance enzyme accessibility.

A novel method was developed for fractionating cellulose microfibrils from forest residue (tulip tree sawdust) to enhance cellulose digestibility, particularly at minimum enzyme loadings. This method involved three main stages: selective hemicellulose solubilization by subcritical water (SCW) pretreatment, delignification of the SCW-pretreated solids using the Formosolv process, and deformylation/bleaching of the cellulose pulp with alkaline hydrogen peroxide solution. This process produced nearly 98% white cellulose microfibrils with 23-fold higher conversion to glucose as compared to the raw substrate after 72 h of enzymatic hydrolysis. This study showed that cellulose swelling had the greatest effect on the enzymatic hydrolysis efficiency of delignified pulp obtained by the Formosolv process.

Comparison of the laryngeal view during intubation using Airtraq and Macintosh laryngoscopes in patients with cervical spine immobilization and mouth opening limitation.

BACKGROUND: For patients suspicious of cervical spine injury, a Philadelphia cervical collar is usually applied. Application of Philadelphia cervical collar may cause difficult airway. The aim of this study was to evaluate the laryngeal view and the success rate at first intubation attempt of the Airtraq and conventional laryngoscopy in patients with simulated cervical spine injury after application of a Philadelphia cervical collar. METHODS: Anesthesia was induced with propofol, remifentanil, and rocuronium. After a Philadelphia cervical collar applied, patients were randomly assigned to tracheal intubation with an Airtraq (Group A, n = 25) or with conventional laryngoscopy (Group L, n = 25). Measurements included intubation time, success rate of first intubation attempt, number of intubation attempts, and percentage of glottic opening (POGO) score. Mean blood pressure and heart rate were also recorded at baseline, just before and after intubation. RESULTS: The success rate of the first attempt in Group A (96%) was significantly greater than with the Group L (40%). POGO score was significantly greater in Group A (84 ± 20%) than in Group L (6 ± 11%). The duration of successful intubation at first tracheal intubation attempt and hemodynamic changes were not significantly different between the two groups. CONCLUSIONS: The Airtraq offers a better laryngeal view and higher success rate at first intubation attempt in patients who are applied with a Philadelphia cervical collar due to suspicion of cervical spine injury.

Preparation of cefpodoxime proxetil fine particles using supercritical fluids.

Fine particles of cefpodoxime proxetil (CPD) were prepared using an Aerosol Solvent Extraction System (ASES) with supercritical CO(2). The resulting primary particles were approximately 0.1-0.2microm in size and were almost spherical in shape. The secondary particles were approximately 0.2-0.6microm in size and had irregular shapes. The larger particle size and irregular shapes were due to the agglomeration of the primary particles. The effects of solvent type, CO(2)-to-CPD solution weight ratio, and CPD solution concentration on the extent of agglomeration were investigated. As a result, the use of ethyl acetate and acetone as solvents also reduced the degree of agglomeration. The degree of agglomeration was reduced with the use of a high CO(2)-to-solution weight ratio, and a low solution concentration. In particular, spherical particles, approximately 0.1-0.4microm in size, were obtained when a 10.0wt% CPD solution was used. As a result of dissolution study, almost 90% of the processed CPD had dissolved within 10min. The recovery yield of the CPD powder reached approximately 80% using a membrane filter.

Estimation of the length of the nares-vocal cord.

The nasal route is preferred for fiberoptic intubation. Placing a lubricated endotracheal tube through the nostril can guide the fiberoptic scope towards the larynx. It would be helpful for optimal visualization of the vocal cord when the scope is passed through the endotracheal tube if the length of nares-vocal cord (NV length) could be predicted and the tip of the endotracheal tube could be placed close to the vocal cord. In this study we measured the NV length and examined the relationship between the NV length and various external measurements. Using a fiberoptic scope, the NV lengths were measured in 50 male and 45 female patients scheduled to undergo elective surgery under general anesthesia. In addition, the distances from the lateral border of the nares to tragus of the ear (NE distance) and to the angle of the mandible (NM distance) were measured. The age, height, and weight of all the patients were recorded. The NV length of the males was 18.3 +/- 0.8 cm, and that of the females was 16.3 +/- 0.7 cm. The relationship between the NV length and body height (P < 0.001, r = 0.755) and the NE distance (P < 0.001, r = 0.636) showed a significant correlation but NM distance did not (P = 0.075). The length of the NV cord can be predicted using the body height or the NE distance.