Bioinspired Cellulose Foam with Excellent Water Wicking and Flux Properties Prepared Using Ice Template.

The application and functionalization of cellulose has been attracting increased attention in academic and industrial studies because of its wide range of sources, short renewable cycle, and low environmental impact. In order to enhance the application field of cellulose and decrease the environmental pollution for organic solvent associated with its preparation, cellulose foam with a vertically hierarchically porous structure similar to wood was designed and fabricated successfully from a cellulose aqueous solution using an ice templated in this study. The cellulose foam prepared using a 3 wt % concentration possessed a uniform vertical hierarchically porous structure, which could provide a pathway for the flow of water or air based on the capillary effect. The highest water wicking rate and flux were 7.8184 mm·s-1 and 29.49 mL·min-1·g-1, respectively, for the porous foam prepared using a 3 wt % concentration. The mechanical testing experiment showed that the porous structure did not reduce the amount of stress that the sample could endure before being damaged. The compression strength increased with increasing cellulose concentration in solution. Therefore, the hierarchical structure formed in the prepared cellulose foam effectively improved the water flux behavior and provided a structural basis for future applications of cellulose scaffolds.

Small-diameter polyurethane vascular graft with high strength and excellent compliance.

In this study, a polyurethane vascular graft with excellent strength and compliance for clinical application was designed and fabricated by preparing three small-diameter vascular graft layers via the textile techniques of wet spinning and knitting. The polyurethane filament that was fabricated by wet spinning formed the inner layer. The polyurethane tubular fabric was used as the middle layer. The outer layer was prepared by spraying polyurethane solution. The three layers of the polyurethane vascular graft have uniform wall thickness, high strength, excellent compliance, and good puncture resistance compared with clinical poly(ethylene terephthalate) (PET) and expanded polytetrafluoroethylene (ePTFE) vascular graft. Therefore, these layers can have potential clinical applications in the replacement of the conventional artificial vascular graft prepared from PET and ePTFE.

Effect of temperature on the thermal property and crystallization behavior of poly (lactic acid) porous membrane prepared via phase separation induced by water microdroplets.

Poly (lactic acid) (PLA)-based porous membrane were fabricated through phase separation induced by water microdroplets at different ambient temperature to unravel the relationship between the physical properties (including thermal properties and crystallization) and preparation temperature. Cross-sectional scanning electron micrographs revealed that the thickness of the membrane decreases with increasing temperature between 25 °C and 100 °C. In the bilayer structure, each layer has a different morphology. Differential scanning calorimetry (DSC) and X-ray diffraction studies indicate that the preparation temperature influences the ratio between imperfect and perfect crystals in the membrane, leading to a bimodal melting peak in the DSC thermogram. The change in the initial decomposition temperature in the thermogravimetric analysis curve is weak, suggesting a negligible effect of the preparation temperature on the thermal stability of the membranes. Thus, PLA porous membranes can be prepared with better crystallinity by controlling the ambient temperature during the phase separation induced by water microdroplets.