Interaction mechanism of chitosan oligomers in pure water with cell membrane models studied by SFG vibrational spectroscopy.

Chitosan is a versatile and biocompatible cationic antimicrobial polymer obtained from sustainable sources that is effective against a wide range of microorganisms. Although it is soluble only at low pH, chitosan oligomers (ChitO) are soluble in pure water and thus more appropriate for antibacterial applications. Although there is a vast literature on chitosan's antimicrobial activity, the molecular details of its interaction with biomembranes remain unclear. Here we investigate these molecular interactions by resorting to phospholipid Langmuir films (zwitterionic DPPC and anionic DPPG) as simplified membrane models (for mammalian and bacterial membranes, respectively), and using SFG vibrational spectroscopy to probe lipid tail conformation, headgroup dynamics and interfacial water orientation. For comparison, we also investigate the interactions of another simple cationic antimicrobial polyelectrolyte, poly(allylamine) hydrochloride - PAH. By forming the lipid films over the polyelectrolyte solutions, we found that both have only a very small interaction with DPPC, but PAH adsorption is able to invert the interfacial water orientation (membrane potential). This might explain why ChitO is compatible with mammalian cells, while PAH is toxic. In contrast, their interaction with DPPG films is much stronger, even more so for ChitO, with both insertion within the lipid film and interaction with the oppositely charged headgroups. Again, PAH adsorption inverts the membrane potential, while ChitO does not. Finally, ChitO interaction with DPPG is weaker if the antimicrobial is injected underneath a pre-assembled Langmuir film, and its interaction mode depends on the time interval between end of film compression and ChitO injection. These differences between ChitO and PAH effects on the model membranes highlight the importance of molecular structure and intermolecular interactions for their bioactivity, and therefore this study may provide insights for the rational design of more effective antimicrobial molecules.

Molecular ordering of layer-by-layer polyelectrolyte films studied by sum-frequency vibrational spectroscopy.

The molecular arrangement in organic thin films is crucial for their increasing technological applications. Here, we use vibrational spectroscopy by sum-frequency generation (SFG) to study the ordering of polyelectrolyte layers adsorbed on silica for all steps of layer-by-layer (LbL) self-assembly. In situ measurements during adsorption and rinsing showed that the adsorbed polymer has a disordered conformation and confirmed surface charge overcompensation upon polyelectrolyte adsorption by probing the interfacial electric field. In dry films, the polymer chains acquired a net orientational ordering, which was affected, however, by the adsorption of subsequent layers. Such a detailed characterization may allow the control of LbL film structure and functionality with unprecedented power.

Molecular view of the interaction between iota-carrageenan and a phospholipid film and its role in enzyme immobilization.

Proteins incorporated into phospholipid Langmuir-Blodgett (LB) films are a good model system for biomembranes and enzyme immobilization studies. The specific fluidity of biomembranes, an important requisite for enzymatic activity, is naturally controlled by varying phospholipid compositions. In a model system, instead, LB film fluidity may be varied by covering the top layer with different substances able to interact simultaneously with the phospholipid and the protein to be immobilized. In this study, we immobilized a carbohydrate rich Neurospora crassa alkaline phosphatase (NCAP) in monolayers of the sodium salt of dihexadecylphosphoric acid (DHP), a synthetic phospholipid that provides very condensed Langmuir films. The binding of NCAP to DHP Langmuir-Blodgett (LB) films was mediated by the anionic polysaccharide iota-carrageenan (iota-car). Combining results from surface isotherms and the quartz crystal microbalance technique, we concluded that the polysaccharide was essential to promote the interaction between DHP and NCAP and also to increase the fluidity of the film. An estimate of DHP:iota-car ratio within the film also revealed that the polysaccharide binds to DHP LB film in an extended conformation. Furthermore, the investigation of the polysaccharide conformation at molecular level, using sum-frequency vibrational spectroscopy (SFG), indicated a preferential conformation of the carrageenan molecules with the sulfate groups oriented toward the phospholipid monolayer, and both the hydroxyl and ether groups interacting preferentially with the protein. These results demonstrate how interfacial electric fields can reorient and induce conformational changes in macromolecules, which may significantly affect intermolecular interactions at interfaces. This detailed knowledge of the interaction mechanism between the enzyme and the LB film is relevant to design strategies for enzyme immobilization when orientation and fluidity properties of the film provided by the matrix are important to improve enzymatic activity.

Molecular ordering in layer-by-layer polyelectrolyte films studied by sum-frequency vibrational spectroscopy: the effects of drying procedures.

Sum-Frequency Vibrational Spectroscopy (SFVS) has been used to investigate the effect of nitrogen-flow drying on the molecular ordering of Layer-by-Layer (LbL) films of poly(allylamine hydrochloride) (PAH) alternated with poly(styrene sulfonate) (PSS). We find that films dried by spontaneous water evaporation are more ordered and homogeneous than films dried by nitrogen flow. The latter are quite inhomogeneous and may have regions with highly disordered polymer conformation. We propose that drying by spontaneous water evaporation reduces the effect of drag by the drying front, while during nitrogen-flow drying the fast evaporation of water "freezes" the disordered conformation of adsorbed polyelectrolyte molecules. These findings are important for many applications of LbL films, since device performance usually depends on film morphology and its molecular structure.

Amperometric detection of lactose using ß-galactosidase immobilized in layer-by-layer films.

A direct, low-cost method to determine the concentration of lactose is an important goal with possible impact in various types of industry. In this study, a biosensor is reported that exploits the specific interaction between lactose and the enzyme ß-galactosidase (ß-Gal) normally employed to process lactose into glucose and galactose for lactose-intolerant people. The biosensor was made with ß-Gal immobilized in layer-by-layer (LbL) films with the polyelectrolyte poly(ethylene imine) (PEI) and poly(vinyl sufonate) (PVS) on an indium tin oxide (ITO) electrode modified with a layer of Prussian Blue (PB). With an ITO/PB/(PEI/PVS)1(PEI/ß-Gal)30 architecture, lactose could be determined with an amperometric method with sensitivity of 0.31 µA mmol(-1) cm(-2) and detection limit of 1.13 mmol L(-1), which is sufficient for detecting lactose in milk and for clinical exams. Detection occurred via a cascade reaction involving glucose oxidase titrated as electrolytic solution in the electrochemical cell, while PB allowed for operation at 0.0 V versus saturated calomel electrode, thus avoiding effects from interfering species. Sum-frequency generation spectroscopy data for the interface between the LbL film and a buffer containing lactose indicated that ß-Gal lost order, which is the first demonstration of structural effects induced by the molecular recognition interaction with lactose.

Vibrational spectroscopy for probing molecular-level interactions in organic films mimicking biointerfaces.

Investigation into nanostructured organic films has served many purposes, including the design of functionalized surfaces that may be applied in biomedical devices and tissue engineering and for studying physiological processes depending on the interaction with cell membranes. Of particular relevance are Langmuir monolayers, Langmuir-Blodgett (LB) and layer-by-layer (LbL) films used to simulate biological interfaces. In this review, we shall focus on the use of vibrational spectroscopy methods to probe molecular-level interactions at biomimetic interfaces, with special emphasis on three surface-specific techniques, namely sum frequency generation (SFG), polarization-modulated infrared reflection absorption spectroscopy (PM-IRRAS) and surface-enhanced Raman scattering (SERS). The two types of systems selected for exemplifying the potential of the methods are the cell membrane models and the functionalized surfaces with biomolecules. Examples will be given on how SFG and PM-IRRAS can be combined to determine the effects from biomolecules on cell membrane models, which include determination of the orientation and preservation of secondary structure. Crucial information for the action of biomolecules on model membranes has also been obtained with PM-IRRAS, as is the case of chitosan removing proteins from the membrane. SERS will be shown as promising for enabling detection limits down to the single-molecule level. The strengths and limitations of these methods will also be discussed, in addition to the prospects for the near future.

Cholesterol mediates chitosan activity on phospholipid monolayers and Langmuir-Blodgett films.

The polysaccharide chitosan has been largely used in many biological applications as a fat and cholesterol reducer, bactericide agent, and wound healing material. While the efficacy for some of such uses is proven, little is known about the molecular-level interactions involved in these applications. In this study, we employ mixed Langmuir and Langmuir-Blodgett (LB) films of negatively charged dimyristoyl phosphatidic acid (DMPA) and cholesterol as cell membrane models to investigate the role of cholesterol in the molecular-level action of chitosan. Chitosan does not remove cholesterol from the monolayer. The interaction with chitosan tends to expand the DMPA monolayer due to its interpenetration within the film. On the other hand, cholesterol induces condensation of the DMPA monolayer. The competing effects cause the surface pressure isotherms of mixed DMPA-cholesterol films on a chitosan subphase to be unaffected by the cholesterol mole fraction, due to distinct degrees of chitosan penetration into the film in the presence of cholesterol. By combining polarization-modulated infrared reflection absorption spectroscopy (PM-IRRAS) and sum-frequency generation spectroscopy (SFG), we showed that chitosan induces order into negatively charged phospholipid layers, whereas the opposite occurs for cholesterol. In conclusion, chitosan has its penetration in the film modulated by cholesterol, and electrostatic interactions with negatively charged phospholipids, such as DMPA, are crucial for the action of chitosan.