An evaluation of the Nd:YAG laser in periodontal pocket therapy.

The aim of this study was to determine whether the Nd:YAG laser energies of 50 and 80 mJ at 10 pulses per second (pps) were capable of improving the clinical parameters associated with periodontal disease. These energy settings were chosen as previous work indicated that higher values would damage root surfaces and that 80 mJ had an in-vitro bactericidal effect. Eighty periodontally affected sites in teeth scheduled for extraction from 11 patients with adult periodontitis were randomly placed in one of the following four treatment groups: 1. laser treatment at 50 mJ, 10 pps for 3 minutes; 2. laser treatment at 80 mJ, 10 pps for 3 minutes; 3. scaling and 4. untreated control. Probing depth, bleeding on probing (BOP), plaque index, gingival index and gingival crevicular fluid (GCF) volume were measured at baseline and week 6. Baseline subgingival microbiological samples were collected, then repeated immediately after treatment and at week 6 to assess the total anaerobic colony forming units (CFU). Only the scaling group showed a significant reduction in pocket depth and BOP (P < 0.001). The microbial samples taken immediately after scaling and laser at 80 mJ and 10 pps treatments showed a significant reduction in total CFU compared with the baseline (P < 0.01), which was sustained only in the scaling group until week 6. Electron microscopy did not reveal any heat damage on the root surfaces. This study demonstrated that application of Nd:YAG laser pulses of 50 mJ and 80 mJ failed to improve the clinical and microbiological parameters of periodontal disease.

Factors associated with shear bond strength of composite resin to human enamel.

The preparation of enamel surfaces before etching by removing 0.5 mm of surface tooth structure is common-place in modern restorative dentistry. This study was designed to measure and compare the shear bond strength of composite resin bonded to prepared and unprepared enamel using various proprietary bonding systems. The analysed results failed to show significant differences between the shear bond strengths of the prepared and unprepared enamel specimens. Conditioning enamel surfaces for 60 seconds using 2.5% nitric acid where the solution was allowed to desiccate, resulted in significantly lower bond strengths compared to the other regimes. A correlation of the etchant pH with the mean shear bond strength of the adhesive systems to enamel was observed. The surface topography of the etched enamel surfaces correlated moderately well with the bond strengths obtained.

An anatomic study of local infiltration analgesia in total knee arthroplasty.

BACKGROUND: Local infiltration analgesia (LIA) is a relatively novel technique developed for effective pain control following total knee arthroplasty (TKA), reducing requirements for epidural or parenteral postoperative analgesia. This study investigated the anatomical spread of an LIA used in TKA to identify the nerve structures reached by the injected fluid. METHODS: Six fresh-frozen cadaveric lower limbs were injected according to a standardised LIA technique with a solution of latex and India ink to enable visualisation. Wounds were closed and limbs placed flat in a freezer at -20°C for two weeks. Limbs were then either sliced or dissected to identify solution locations. RESULTS: Solution was found from the proximal thigh to the middle of the lower leg. The main areas of concentration were the popliteal fossa, the anterior aspect of the femur and the subcutaneous tissue of the anterior aspect of the knee. There was less solution in the lower popliteal fossa. The solution was found to reach the majority of nerves, with good infiltration of nerves supplying the knee. CONCLUSIONS: These results support the positive clinical outcomes with this LIA technique. However, the lack of infiltration into the lower popliteal fossa suggests more fluid or a different injection point could be used. The solution reaching the extensor muscles of the lower leg is likely to have no beneficial analgesic effect for a TKA patient. The LIA technique is already used in clinical practice following total knee arthroplasty. Results from this study show there may be scope to optimise the injection sites in LIA technique.

The effect of an Nd-YAG pulsed laser on the cleaning of the root canal and the formation of a fused apical plug.

A Neodymium-yttrium aluminium garnet (Nd-YAG) pulsed laser was used in vitro to determine whether various laser energy levels from 0.75 W to 1.7 W at 15 pulses s(-1) (pps) were able to (i) remove debris from the walls of prepared root canals (ii) remove pulpal tissue from unprepared canals and (iii) create a fused apical plug from dentine chips, hydroxyapatite (HAP) or low-fusing dental porcelain. Single-rooted teeth were sectioned at the amelocemental junction and the crowns discarded. The root canals of 50 teeth were prepared chemomechanically and allocated to four groups of 10 teeth for laser treatment. One group was left unlased as a control. After lasing, the teeth were split longitudinally, stained and examined for residual debris. Results showed that there was no statistically significant difference between the groups (P<0.05). A further 20 teeth were not prepared and lased in the coronal one-third of the root canal at different energy levels; five teeth were not lased. The teeth were split and examined as previously. The results showed that lasing cleaned the coronal part of the root canal almost completely of pulpal tissue. In the final part of the study laser energy was applied to dentine chips, HAP and low-fusing porcelain in an attempt to produce a fused apical plug. The laser was unable to melt the dentine chips but some hardening of HAP occurred when combined with blue food-colouring, with or without glycerine, at energy levels of 1.0 W, at 15 pps for 30 s. Superficial hardening of low-fusing porcelain occurred at 1.0 W, 15 pps for 30 s.

An evaluation of the effects of an Nd:YAG laser on subgingival calculus, dentine and cementum. An in vitro study.

The aim of this study was to evaluate the effects of Nd:YAG laser treatment on subgingival calculus, cementum and dentine, in vitro at different power settings and durations. The study included 2 experiments. In the 1st experiment, 32 extracted teeth with calculus were divided into 8 laser treatment groups. Each tooth was treated on 2, 3 or 4 sites. In the 2nd experiment, 3 extracted cementum covered teeth and 3 extracted root planed teeth with exposed dentine were selected. 1 surface of each tooth was subjected to 8 different laser treatments. In both experiments, all specimens were assessed using scanning electron microscopy. Micrographs were taken from each treated site at x 100 and x 750 magnifications. An arbitrary scale (from 0 to 3) was used to score the degree of damage caused by the laser. Generally, the laser caused greater damage on calculus than either cementum or dentine. Linear regression analysis showed that higher total energy input caused a greater mean damage score on calculus (R2 = 66%, p < 0.001). 3-way analysis of variance showed that for calculus, the power setting, number of pulses per second and the duration of exposure contributed independently to the mean damage score in an additive way. Cementum specimens were not affected by treatment 1 (50 mJ, 10 pps, 1 s), treatment 2 (50 mJ, 10 pps, 5 s), and treatment 5 (50 mJ, 20 pps, 1 s). Dentine specimens were not affected by treatment 1 (50 mJ, 10 pps, 1 s).(ABSTRACT TRUNCATED AT 250 WORDS)