Gastric emptying rate before and after orthodontic treatment examined with the [13C] breath test: A pilot study.

INTRODUCTION: Orthodontic patients with malocclusion have significantly lower masticatory and gastrointestinal digestive function than persons with normal occlusion. Although several studies have suggested that masticatory function is improved after orthodontic treatment, the relationship between such improvement and change in gastrointestinal symptoms has not been quantitatively evaluated. In this study, we aimed to investigate the change in masticatory function and the gastric emptying rate in patients with malocclusion, before and after orthodontic treatment. METHODS: Seven women with malocclusion, before (pretreatment group) and after orthodontic treatment (posttreatment group), and 7 healthy dentate female volunteers (control group) underwent a 13C-acetate breath test (13CO2) with a liquid meal and the color changeable gum test, along with completing the frequency scale for symptoms of gastroesophageal reflux and a questionnaire on food intake. Between-group differences were evaluated. RESULTS: The pretreatment group had significantly longer maximum 13CO2 exhalation time and lower masticatory function, quantified using a higher red-color value on the gum test and the questionnaire on food intake, than did the posttreatment and control groups. No significant differences were identified between the posttreatment and the control groups. CONCLUSIONS: We provide evidence of improvement of masticatory function after orthodontic treatment, which was associated with a faster rate of gastric emptying.

Computational Fluid Dynamic Study of Nasal Respiratory Function Before and After Bimaxillary Orthognathic Surgery With Bone Trimming at the Inferior Edge of the Pyriform Aperture.

PURPOSE: This study aimed to evaluate the influence of maxillary impaction orthognathic surgery on nasal respiratory function and the efficacy of bone trimming at the inferior edge of the pyriform aperture. MATERIALS AND METHODS: The participants were 10 patients (3 male and 7 female patients) with mandibular prognathism who underwent bimaxillary orthognathic surgery with maxillary impaction. The surgical procedures performed were Le Fort I osteotomy with bone trimming at the inferior edge of the pyriform aperture and bilateral sagittal split osteotomy. Three-dimensional models of the nasal cavity were reconstructed from preoperative and postoperative computed tomography images. Furthermore, we remodeled the nasal valve region based on the postoperative models by adding a 1-mm and 2-mm stenosis to investigate the effects of bone trimming at the inferior edge of the pyriform aperture on the pressure effort. The 3-dimensional models were simulated with computational fluid dynamics, and the results of the pressure effort and the cross-sectional area (CSA) were compared for the anterior, middle, and posterior parts of the nasal cavity. The Wilcoxon signed rank test and Spearman rank correlation coefficients were used for statistical comparisons (P < .05). RESULTS: In the preoperative and postoperative models, there were considerable correlations between the CSA and the pressure effort in each part of the nasal cavity. The postoperative pressure effort showed a tendency to decrease and the CSA showed a tendency to increase in each part of the nasal cavity. In four 2-mm stenosis models, the pressure effort in the anterior nasal cavity was larger than the preoperative pressure effort and the CSA of the anterior nasal cavity was smaller than the preoperative CSA. CONCLUSIONS: Bone trimming at the inferior edge of the pyriform aperture appears to be useful for avoiding nasal respiratory complications with maxillary impaction.

An anatomic study of the attachments on the condylar process of the mandible: muscle bundles from the temporalis.

PURPOSE: The aim of this study was to evaluate anatomically the relationship between bone and muscles by detailed observation of the bone shape and the structure of muscles to facilitate an understanding of the function of the muscles involved in jaw movement. METHODS: 36 specimens of 24 Japanese cadavers were examined. The insertion areas were marked using a radiopaque marker and examined by micro-computed tomography. For morphological observation, we used 101 condylar processes. In addition, we made histological sections in some specimens to observe the detailed attachments of the muscle. RESULTS: Based on the micro-CT images and dissection findings, the lateral pterygoid muscle was found to be most frequently inserted into the anterior impression and attached to the medial impression of the process. According to the histological observations, the lateral pterygoid muscle mainly inserted to the condylar process. The micro-CT images indicated that the obvious bony ridge was lateral to the pterygoid fovea on the condylar process in all specimens. The midmedial muscle bundle of the temporalis was attached to the ridge. Based on the morphological observations, the ridge was situated on the lateral area of the condylar process. CONCLUSIONS: Since dysfunction of the temporomandibular joint is likely closely related to both the lateral pterygoid muscle and also the temporalis, further studies are necessary to evaluate the function of these muscles and consider jaw movement.

Maxillary movement in distraction osteogenesis using internal devices in cleft palate patients.

OBJECTIVE: The purpose of this cephalometric study was to compare the actual movement with the planned movement of the maxilla by using internal maxillary distraction in cleft lip and palate patients. PATIENTS: Twelve patients, including eight with unilateral and four with bilateral cleft lip and palate, underwent maxillary advancement with internal maxillary distractors. MAIN OUTCOME MEASURES: Lateral cephalometric radiographs obtained preoperatively, predistraction, and postdistraction were used for analysis. The movement of the maxilla, angular change of the internal devices and rotation of the mandible were measured at each stage, and the planned vector of advancement predicted from the placement vector of the distractors was compared with the actual vector. RESULTS: Internal maxillary distractors were rotated in a clockwise direction during the distraction period. The angular change of the distractors was 7.7°. The amount of actual advancement at anterior nasal spine with distraction was 6.3 mm, which represented about 70% of the distance of activation of distraction. The actual advanced vector at anterior nasal spine was 9.7° smaller than the planned vector. The mandible underwent a clockwise rotation of 3.5°. CONCLUSION: In the internal distraction technique, the maxilla was advanced inferiorly to the planned vector and with a slight clockwise rotation. These results are useful for surgical planning when using internal distractors.

Influence of orthodontic appliance-derived artifacts on 3-T MRI movies.

BACKGROUND: Magnetic resonance imaging (MRI) has been used to study configurations of speech organs in the resting state. However, MRI is sensitive to metals, and numerous types of metallic appliances, most of which have a large magnetic susceptibility, are used in orthodontic treatment and may cause severe artifacts on MRI. We have developed techniques for obtaining MRI movies of the oral region, to evaluate articulatory changes, especially movement of the tongue, palate, and teeth, pre- and post-orthodontic/orthognathic treatment. We evaluated the influence of artifacts caused by orthodontic appliances, including fixed retainers, metal brackets, and wires, on measurements in 3-T MRI movies. METHODS: Sixteen healthy young adults (nine males, seven females; average age, 27 years) with normal occlusion were recruited. Four types of customized maxillary and mandibular plates were prepared by incorporating one of the following into the plate: (a) nothing, (b) a fixed canine-to-canine retainer, (c) metal brackets for the anterior and molar teeth, or (d) clear brackets for the anterior teeth and metal brackets for molars. A 3-T MRI movie, in segmented cine mode, was generated for each plate condition while participants pronounced a vowel-consonant-vowel syllable (/asa/). The size of the artifact due to the metallic brackets was measured. The face size and orthodontically important anatomical structures, such as the velum, the hard palate, and the laryngeal ventricle, were also measured. RESULTS: A large artifact was observed over the entire oral region around orthodontic appliances, altering regional visibility. The velopharyngeal height was measured as significantly longer in the presence of metal brackets. The maximum artifact size due to a metallic bracket was > 8 cm. Our results show that even if it is possible to obtain the measurements of palate length, nasion to sella, and nasion to basion in individuals wearing metal brackets for molars, the measurements might be affected due to the presence of artifacts. CONCLUSIONS: Orthodontic appliances, including metallic materials, sometimes produce significant measurement error in speech evaluation using MRI movies, which often become invisible or distorted by metallic orthodontic appliances. When the distorted image is measured, caution should be exercised, as the measurement may be affected. Based on the study, it is concluded that orthodontists should not necessarily remove all metallic appliances before MRI examination because the influence varies among the appliances and should also know that a significant measurement error in speech evaluation using MRI movie may occur by image distortion caused by metallic artifacts.

Functional relationships between the masseter and sternocleidomastoid muscle activities during gum chewing:.

The purpose of this study was to investigate the functional relationship between masseter muscle (MM) and sternocleidomastoid muscle (SCM) activities and between mandibular and head movements during mastication, under experimental muscle fatigue. The sample consisted of 12 adults with individually normal occlusion. The subjects were asked to chew gum at three different times: before maximum clenching, immediately after maximum clenching, and 3 minutes after maximum clenching. At these times, we examined the activity of the MM and SCM as well as the movement of the mandible and head. The activity and movement were simultaneously measured using both electromyography and the motion capture system. The MM activity time after clenching was significantly shorter than that before clenching, whereas the SCM activity time was significantly longer after clenching. There was no significant difference in the changes of three-dimensional distance of the mandibular movement between the respective times. On the other hand, the changes in the three-dimensional distance of head movement after clenching increased when compared with before clenching. Furthermore, the difference in the time of MM and SCM activity onset and of mandibular and head movement onset after clenching was shorter than that before clenching. A functional relationship exists between the MM and SCM activities and between mandibular and head movements during mastication.

Differences in Velopharyngeal Structure during Speech among Asians Revealed by 3-Tesla Magnetic Resonance Imaging Movie Mode.

OBJECTIVE: Different bony structures can affect the function of the velopharyngeal muscles. Asian populations differ morphologically, including the morphologies of their bony structures. The purpose of this study was to compare the velopharyngeal structures during speech in two Asian populations: Japanese and Thai. METHODS: Ten healthy Japanese and Thai females (five each) were evaluated with a 3-Tesla (3 T) magnetic resonance imaging (MRI) scanner while they produced vowel-consonant-vowel syllable (/asa/). A gradient-echo sequence, fast low-angle shot with segmented cine and parallel imaging technique was used to obtain sagittal images of the velopharyngeal structures. RESULTS: MRI was carried out in real time during speech production, allowing investigations of the time-to-time changes in the velopharyngeal structures. Thai subjects had a significantly longer hard palate and produced shorter consonant than Japanese subjects. The velum of the Thai participants showed significant thickening during consonant production and their retroglossal space was significantly wider at rest, whereas the dimensional change during task performance was similar in the two populations. CONCLUSIONS: The 3 T MRI movie method can be used to investigate velopharyngeal function and diagnose velopharyngeal insufficiency. The racial differences may include differences in skeletal patterns and soft-tissue morphology that result in functional differences for the affected structures.

Use of an advanced 3-T MRI movie to investigate articulation.

OBJECTIVE: To develop a magnetic resonance imaging (MRI) movie to reveal the dynamic movement of articulators and teeth. STUDY DESIGN: Five healthy females with normal occlusion participated in this study. Various concentrations of MRI contrast media (ferric ammonium citrate [FAC]) were tested for visualization of teeth, according to facial markers and with the use of a gel. Custom-made circuitry was connected to synchronize pronunciation of fricative sounds (/asa/) with scans. Three gradient echo sequences (True fast imaging with steady state precession [true FISP], FISP, and fast low angle shot [FLASH]) with a segmented cine were tested with the use of repetition times (TRs) of 9 ms and 31.5 ms. The MRI movie images were superimposed over the boundaries of teeth. The images produced during pronunciation, using the two different TRs (9 ms and 31 ms), were compared to assess the position of the lips and the tongue. RESULTS: Images obtained using the FLASH sequence, with a TR of 9 ms or 31.5 ms, can be used for diagnostic purposes. A TR of 9 ms, with 161 continuous images acquired, produced the highest-quality images of teeth, with few artifacts present. Pronunciation of the consonant "s" was clearly discernable. CONCLUSIONS: Our 3-T MRI movie system, with a temporal resolution less than 9 ms, can provide detailed information pertaining to variations in speech or oropharyngeal function.

Severe unilateral scissor bite and bimaxillary protrusion treated by horseshoe Le Fort I osteotomy combined with mid-alveolar osteotomy.

This report describes an orthognathic surgical case employing horseshoe Le Fort I osteotomy (HLFO) combined with mid-alveolar osteotomy and bilateral sagittal split ramus osteotomy (BSSRO) for a patient with severe unilateral scissor bite and bimaxillary protrusion. A female patient (aged 26 years, 2 months) presented with a chief complaint of dysmasesis caused by scissor bite on the right side. The clinical examination revealed difficulty in lip closure and a convex profile. Overerupted right maxillary premolars and molars and lingual tipping of the right mandibular premolars and molars were indicated before treatment. After 3 months of presurgical orthodontic treatment, two-jaw surgery involving a combination of HLFO with mid-alveolar osteotomy and BSSRO was performed. A good interdigitation in the right side was established by superior-posterior-medial movement of the dento-alveolar segment of the maxilla. Next, both the maxilla and mandible were moved superiorly and posteriorly to correct the improper lip protrusion, thereby improving the patient's profile. Our results suggest that this new orthognathic surgery technique-achieved by combining HLFO with mid-alveolar osteotomy and BSSRO-is effective for adult patients exhibiting severe unilateral scissor bite and bimaxillary protrusion.