In vivo Raman spectroscopic characteristics of different sites of the oral mucosa in healthy volunteers.

OBJECTIVES: Investigate the biochemistry of in vivo healthy oral tissues through Raman spectroscopy. We aimed to characterize the biochemical features of healthy condition in oral subsites (buccal mucosa, lip, tongue, and gingiva) of healthy subjects. More specifically, we investigated Raman spectral characteristics and biochemical content of in vivo healthy tissues on Brazilian population. This characterization can be used to better define normal tissue and improve the detection of oral premalignant conditions in future studies. MATERIALS AND METHODS: For spectroscopic analysis a Raman spectrometer (Kaiser Optical Systems imaging spectrograph Holospec, f / 1.8i-NIR) coupled with a laser 785 nm, 60 mW was used. Raman measurements were obtained by means of an optical fiber (EMVision fiber optic probe) coupled between the laser and the spectrometer. Three spectra per site were acquired from the lip, buccal mucosa, tongue, and gingiva of ten healthy volunteers. This resulted in 30 spectra per oral sub-site and in total 120 spectra. RESULTS: We report detailed biochemical information on these subsites and their relative composition based on deconvolution studies of their spectra. Finally, we also report classification efficiency of 61, 83, 41, and 93% for buccal, gingiva, lip, and tongue respectively after applying multivariate statistical tools. CONCLUSIONS: We quantitated the contribution of various biochemicals in terms of percentage, and this will enable comparison not only across anatomical sites but also across studies. Raman spectroscopy can rapidly probe tissue biochemistry of healthy oral regions. Moreover, the study suggests the possibility of using Raman spectroscopy combined with signal processing and multivariate analysis methods to differentiate the oral sites in healthy conditions and compare with pathological conditions in future studies. CLINICAL RELEVANCE: The spectral characterization of the healthy condition of oral tissues by a noninvasive, label-free, and real-time analytical techniques is important to create a spectral reference for future diagnosis of pathological conditions.

Effects of heating by steam autoclaving and Er:YAG laser etching on dentin components.

The simultaneous need for infection-control protocols in sample preparations and for safe laser irradiation parameters prompted this study about the effects of heat produced by both sample sterilization and laser etching on dentin components. The dentin was exposed on 30 bovine incisors, and then divided into two main groups: autoclaved (group A) or thymol treatment (group B). The surface of the dentin was schematically divided into four areas, with each one corresponding to a treatment subgroup. The specimens were either etched with phosphoric acid (control-CG) or irradiated with Er:YAG laser (subgroups: I-80 mJ, II-120 mJ, and III-180 mJ). Elemental distribution maps were done by energy-dispersive X-ray fluorescence (µ-EDXRF) on each treatment area. The dentin surface in depth was exposed and line-scan maps were performed. The B_CG treatment produced the best distribution of calcium (Ca) and phosphorus (P) content throughout the dentin surface. Er:YAG laser etching produced irregular patterns of elemental distribution in the dentin. Laser energies of 120 and 180 mJ produced the highest maximum calcium values. The Er:YAG laser energy of 180 mJ produced a localized increase in Ca and P content on the superficial layer of the dentin (∼ 0-0.10 mm). The autoclaving treatment of samples in experiments is not recommended since it produced damaging effects on dentin components. Er:YAG laser irradiation produced a heterogeneous Ca and P distribution throughout the dentin surface with areas of increased Ca concentration, and this may affect clinically the permeability, solubility, or adhesive characteristics of dental hard tissues with restorative procedures.

Adverse effects of respiratory disease medicaments and tooth brushing on teeth: A scanning electron microscopy, X-ray fluorescence and infrared spectroscopy study.

The present study aims to evaluate the effect of brushing with fluoride dentifrice on teeth severely affected by erosion due to respiratory medicaments. Enamel (n = 50) and dentin (n = 50) bovine specimens were prepared and treated with artificial saliva (S-control), acebrofilin hydrochloride (AC), ambroxol hydrochloride (AM), bromhexine hydrochloride (BR), and salbutamol sulfate (SS) and subjected to cycles of demineralization (immersing in 3 mL, 1 min, three times a day at intervals of 1 hr, for 5 days) followed by remineralization (saliva, 37°C, 1 hr). Simulated brushing with fluoridated toothpaste was performed using 810 strokes in a reciprocal-action brushing simulator. Scanning electron microscopy, micro energy dispersive X-ray fluorescence (µ-EDXRF) spectroscopy and attenuated total reflection Fourier transform infrared (ATR FTIR) spectroscopy were then performed. µ-EDXRF images showed extensive erosion after treatment with all medicaments. SEM images showed enamel erosion in order SS > BR > AC = AM > S after brushing and fluoridation. FTIR results were in agreement. In case of dentin, µ-EDXRF measurements showed significant difference in mineral content (percent weight of calcium and phosphate) in SS + brushing + fluoridation treated enamel compared to control, while µ-EDXRF images showed erosive effects in the order SS > AM>BR > AC = S post brushing + fluoridation. SEM images showed erosion in the order SS > AM = BR > AC > S post brushing + fluoridation. Again, FTIR multivariate results were in agreement. Overall, our study shows that proper oral care is critical when taking certain medication. The study also demonstrates the possible use of FTIR for rapid clinical monitoring of tooth erosion in clinics.

Effects of experimental bleaching agents on the mineral content of sound and demineralized enamels.

OBJECTIVE: High concentrations of hydrogen peroxide can cause adverse effects on composition and structure of teeth. However, the addition of calcium and fluoride in bleaching agents may reduce enamel demineralization. To evaluate chemical changes of sound and demineralized enamels submitted to high concentrations of hydrogen peroxide containing fluoride (F) or calcium (Ca). MATERIAL AND METHODS: Enamel blocks of bovine incisors with standard dimensions were obtained and half of them were submitted to pH-cycling to promote initial enamel caries lesions. Sound and demineralized enamel samples were divided into (n=10): (C) Control (no whitening treatment); (HP) 35% hydrogen peroxide; and two experimental groups: (HPF) 35% HP+0.2% F and (HPC) 35% HP+0.2% Ca. Experimental groups were submitted to two in-office bleaching sessions and agents were applied 3 times for 15 min to each session. The control group was kept in remineralizing solution at 37°C during the bleaching treatment. The surface mineral content of sound and demineralized enamels was determined through Fourier Transform Raman spectroscopy (FT-Raman), Energy dispersive Micro X-ray fluorescence spectroscopy (µ-EDXRF); and the subsurface, through cross-sectional microhardness (CSMH). In addition, polarized light microscopy (PLM) images of enamel subsurface were observed. RESULTS: According to three-way (FT-Raman and µ-EDXRF analyses) or two-way analysis of variance (ANOVA) (CSMH) and Tukey test (α=5%), the calcium or fluoride added to high-concentrated bleaching agents increased phosphate and carbonate concentrations on sound and demineralized enamels (p<0.05). However, HPC and HPF were unable to completely reverse the subsurface mineral loss promoted by bleaching on sound and demineralized enamels. The calcium/ phosphate (Ca/P) ratio of sound enamel decreased after HP treatment (p<0.001). CONCLUSION: Even though experimental bleaching agents with Ca or F reduced mineral loss for both sound and demineralized enamel surfaces, these agents were unable to reverse the enamel subsurface demineralization.

Effects of experimental bleaching agents on the mineral content of sound and demineralized enamels

Abstract High concentrations of hydrogen peroxide can cause adverse effects on composition and structure of teeth. However, the addition of calcium and fluoride in bleaching agents may reduce enamel demineralization. Objective: To evaluate chemical changes of sound and demineralized enamels submitted to high concentrations of hydrogen peroxide containing fluoride (F) or calcium (Ca). Material and Methods: Enamel blocks of bovine incisors with standard dimensions were obtained and half of them were submitted to pH-cycling to promote initial enamel caries lesions. Sound and demineralized enamel samples were divided into (n=10): (C) Control (no whitening treatment); (HP) 35% hydrogen peroxide; and two experimental groups: (HPF) 35% HP+0.2% F and (HPC) 35% HP+0.2% Ca. Experimental groups were submitted to two in-office bleaching sessions and agents were applied 3 times for 15 min to each session. The control group was kept in remineralizing solution at 37°C during the bleaching treatment. The surface mineral content of sound and demineralized enamels was determined through Fourier Transform Raman spectroscopy (FT-Raman), Energy dispersive Micro X-ray fluorescence spectroscopy (μ-EDXRF); and the subsurface, through cross-sectional microhardness (CSMH). In addition, polarized light microscopy (PLM) images of enamel subsurface were observed. Results: According to three-way (FT-Raman and μ-EDXRF analyses) or two-way analysis of variance (ANOVA) (CSMH) and Tukey test (α=5%), the calcium or fluoride added to high-concentrated bleaching agents increased phosphate and carbonate concentrations on sound and demineralized enamels (p<0.05). However, HPC and HPF were unable to completely reverse the subsurface mineral loss promoted by bleaching on sound and demineralized enamels. The calcium/ phosphate (Ca/P) ratio of sound enamel decreased after HP treatment (p<0.001). Conclusion: Even though experimental bleaching agents with Ca or F reduced mineral loss for both sound and demineralized enamel surfaces, these agents were unable to reverse the enamel subsurface demineralization.