[Design and mechanical properties of biodegradable polymeric stent].

Biodegradable stents (BDSs) are the milestone in percutaneous coronary intervention(PCI). Biodegradable polymeric stents have received widespread attention due to their good biocompatibility, moderate degradation rate and degradation products without toxicity or side effects. However, due to the defects in mechanical properties of polymer materials, the clinical application of polymeric BDS has been affected. In this paper, the BDS geometric configuration design was analyzed to improve the radial strength, flexibility and reduce the shrinkage rate of biodegradable polymeric stents. And from the aspects of numerical simulation, in vitro experiment and animal experiment, the configuration design and mechanical properties of biodegradable polymeric stents were introduced in detail in order to provide further references for the development of biodegradable polymeric stents.

The differences between surface degradation and bulk degradation of FEM on the prediction of the degradation time for poly (lactic-co-glycolic acid) stent.

The degradation time is a crucial factor in evaluating the performance of poly (lactic-co-glycolic acid) (PLGA) stents. Bulk degradation mode was commonly used to analyze the stent degradation behavior by finite element approach. However, the PLGA stents may present surface degradation more than bulk degradation under certain conditions, which will greatly affect the degradation time after implantation. In this study, the degradation processes of the poly (lactic-co-glycolic acid) stent were reproduced utilizing finite element analysis. Both bulk degradation and surface degradation modes were considered. The correlation between tensile stress and degradation rate was investigated. The degradation time was analyzed selectively. The stress distribution, fracture, and mass loss were also compared between bulk degradation mode and surface degradation mode. The simulation results showed that, in both evolution modes, the degradation began at the 'peak-valley' region and fracture occurred at the cross of links and rings. Additionally, high levels of Von-Mises stress were observed in these two regions. Compared with bulk degradation, the fracture time of the stent was delayed by 63% in the surface degradation mode. In conclusion, the mass loss rate and scaffolding period showed great differences between surface degradation and bulk degradation. Based on this study, it is suggested that bulk degradation mode is not applicable to the case of inadequate water uptake mode, such as the tracheal stent degradation process. More experimental research should be carried out to accurately predict the scaffolding period after implantation. The mechanical properties of the fracture zone should be strengthened.

Impaired endothelial cell proliferative, migratory, and adhesive abilities are associated with the slow endothelialization of polycaprolactone vascular grafts implanted into a hypercholesterolemia rat model.

Most small diameter vascular grafts (inner diameter<6 mm) evaluation studies are performed in healthy animals that cannot represent the clinical situation. Herein, an hypercholesterolemia (HC) rat model with thickened intima and elevated expression of pro-inflammatory intercellular adhesion molecular-1 (ICAM-1) in the carotid branch is established. Electrospun polycaprolactone (PCL) vascular grafts (length: 1 cm; inner diameter: 2 mm) are implanted into the HC rat abdominal aortas in an end to end fashion and followed up to 43 days, showing a relative lower patency accompanied by significant neointima hyperplasia, abundant collagen deposition, and slower endothelialization than those implanted into healthy ones. Moreover, the proliferation, migration, and adhesion behavior of endothelial cells (ECs) isolated from the HC aortas are impaired as evaluated under both static and pulsatile flow conditions. DNA microarray studies of the HC aortic endothelium suggest genes involved in EC proliferation (Egr2), apoptosis (Zbtb16 and Mt1), and metabolism (Slc7a11 and Hamp) are down regulated. These results suggest the impaired proliferative, migratory, and adhesive abilities of ECs are associated with the bad performances of grafts in HC rat. Future pre-clinical evaluation of small diameter vascular grafts may concern more disease animal models with clinical complications. STATEMENT OF SIGNIFICANCE: During the development of small diameter vascular grafts (D<6 mm), young and healthy animal models from pigs, sheep, dogs, to rabbits and rats are preferred. However, it cannot represent the clinic situation, where most cardiovascular grafting procedures are performed in the elderly and age is the primary risk factor for disease development or death. Herein, the performance of electrospun polycaprolactone (PCL) vascular grafts implanted into hypercholesterolemia (HC) or healthy rats were evaluated. Results suggest the proliferative, migratory, and adhesive abilities of endothelial cells (ECs) are already impaired in HC rats, which contributes to the observed slower endothelialization of implanted PCL grafts. Future pre-clinical evaluation of small diameter vascular grafts may concern more disease animal models with clinical complications.

A New Feasible Technique for Polytetrafluoroethylene Suture Buttress-Reinforced Pancreaticojejunostomy (PBRP): Mechanical Analysis and a Prospective, Randomized Controlled Trial.

OBJECTIVES: Postoperative pancreatic fistula (POPF) is a major concern after pancreatoduodenectomy (PD). We recently designed a new anastomotic method to reduce the rate of pancreatic fistula: polytetrafluoroethylene suture buttress-reinforced pancreaticojejunostomy (PBRP). METHODS: An animal model and a computer simulation were used to measure the maximum stress and tensile strength of the pancreas with and without the suture buttresses. Then, a randomized controlled trial (RCT) was performed to compare the outcome of PD between patients who underwent PBRP vs traditional pancreaticojejunostomy (TP). RESULTS: The maximum load in the animal model was significantly higher with the suture buttresses than without (5.47 ± 1.67 N vs 3.72 ± 1.36 N, p < 0.01), and in the computer simulation, the peak stress was lower with the suture buttresses than without (54.86 vs 486.8 MPa). There were no significant differences between the two groups in the overall frequency of POPF, but the rate of clinically relevant POPF was significantly lower in the PBRP group (2.8 vs 22.8%, p = 0.028). The pancreaticojejunostomy time was significantly longer in the PBRP group (19.57 ± 3.31 vs 17.17 ± 4.83 min, p = 0.018), and the PBRP group showed a shorter drainage tube retention duration (10 vs 12 days, p = 0.006) and postoperative hospital stay (13 d vs 15 d, p = 0.031). CONCLUSIONS: PBRP is a feasible and reliable procedure for preventing clinically relevant POPF. Additional multi-institution randomized trials should be conducted to confirm these results.