Can Kinesio taping improve discomfort after mandibular third molar surgery? A systematic review and meta-analysis.

OBJECTIVE: The purpose of this study was to evaluate whether Kinesio taping (KT) can improve patient discomfort after mandibular third molar surgery. MATERIALS AND METHODS: This systematic review and meta-analysis was conducted according to the PICO strategy. We searched 4 databases for related articles. All controlled trials or randomized controlled trials that evaluated the application of KT after mandibular third molar surgery were included. Screening and article selection were carried out by two independent reviewers. The main evaluation indicators were facial swelling, pain, and trismus. All statistical analyses were conducted using Review Manager 5.3 software. RESULT: This analysis included 8 articles. The combined results showed that compared with the control group, the postoperative application of KT significantly reduced pain in the early (early stage mean difference (MD), - 2.00; 95% confidence interval (CI), - 2.40 to - 1.60; P < 0.00001) and late (late stage MD, - 1.18; 95% CI, - 2.26 to - 0.11; P = 0.03) postoperative periods and, thus, reduced the intake of painkillers. KT also reduced facial swelling in the early and late postoperative periods (early stage standardized mean difference (SMD), - 1.34; 95% CI, - 1.99 to - 0.68; P < 0.0001; late stage SMD, - 0.31; 95% CI, - 0.51 to - 0.11; P = 0.002). In addition, the postoperative application of KT improved restricted mouth opening in the early and late postoperative periods (early stage MD, - 5.03 mm; 95% CI, - 6.32 to - 3.74 mm; P < 0.00001; late stage MD, - 3.42 mm; 95% CI, - 5.31 to - 1.52 mm; P = 0.0004). CONCLUSION: KT can significantly reduce postoperative pain, swelling, and trismus after impacted mandibular tooth extraction. Additional high-quality and rigorously designed randomized controlled trials should be conducted to verify these conclusions. CLINICAL RELEVANCE: KT is a low-cost, simple, effective nondrug therapy for the postoperative management of mandibular third molar extraction and has broad prospects for clinical application.

Effects of lactoferrin on bone resorption of midpalatal suture during rapid expansion in rats.

INTRODUCTION: The aim of this study was to investigate the effect of lactoferrin (LF) on bone resorption of rats' midpalatal sutures during rapid palatal expansion. METHODS: Sixty male 5-week-old Wistar rats were randomly divided into 3 groups: expansion only (EO), expansion plus LF (E + LF), and sham device (control). RESULTS: Microcomputed tomography showed that the bone volume/tissue volume ratio and the relative bone mineral density of the suture bone were significantly increased in the E + LF group compared with the EO group. Histochemical staining suggested that the activity of osteoblast-like cells and the amount of new bone formation were stimulated in the E + LF group whereas the activity of osteoclasts showed no obvious difference between groups. On the other hand, the immunohistochemical and the real-time polymerase chain reaction results showed that the expressions of receptor activator of nuclear factor kappa B ligand and osteoprotegerin had no significant difference between the EO and E + LF groups. CONCLUSIONS: These findings demonstrated that LF could stimulate bone volume and bone density in midpalatal sutures during the suture remodeling process under tensile force. However, this enhancement effect was not caused by the reduction of bone resorption.

Constitutive model for shape memory polymer and its thermodynamic responses in finite element analysis.

BACKGROUND: As a new intelligent polymer material, shape memory polymer (SMP) was a potential orthodontic appliance material. OBJECTIVE: This study aimed to investigate the thermodynamic responses of SMP under different loads via finite element analysis (FEA). METHODS: FEA specimens with a specification of 0.1 × 0.1 × 1 mm were designed. One end of the specimen was fixed, and the other was subjected to displacement load. Different loading, cooling, and heating rates were separately exerted on the specimen in its shape recovery process and used to observe the responses of the SMP constitutive model. Furthermore, specimens with various tensile elongation and sectional areas were simulated and used to elucidate their effect on shape recovering force. RESULTS: The specimens obtained a similar stress of 0.5, 0.44, and 1.07 Mpa for different loading, cooling, and heating rates after a long time. The shape recovering force of specimen increased from 0.0102 to 0.0315 N when the elongation improved from 10% to 40% and to 0.0408 N when the sectional areas were expanded to 0.2 × 0.2 mm. CONCLUSION: The stiffness of SMP was small at a high temperature but large at a low temperature. The effects of the loading, cooling, and heating rates on SMP can be eliminated after a long time. Furthermore, it was possible to increase the recovering force by increasing the elongation or expanding the sectional area of the specimen. The force was quadratically dependent on the elongation ratio.

Enamel etching for bonding fixed orthodontic braces.

BACKGROUND: Acid etching of tooth surfaces to promote the bonding of orthodontic attachments to the enamel has been a routine procedure in orthodontic treatment since the 1960s. Various types of orthodontic etchants and etching techniques have been introduced in the past five decades. Although a large amount of information on this topic has been published, there is a significant lack of consensus regarding the clinical effects of different dental etchants and etching techniques. OBJECTIVES: To compare the effects of different dental etchants and different etching techniques for the bonding of fixed orthodontic appliances. SEARCH METHODS: We searched the following electronic databases: the Cochrane Oral Health Group's Trials Register (to 8 March 2013), the Cochrane Central Register of Controlled Trials (CENTRAL) (The Cochrane Library 2013, Issue 2), MEDLINE via OVID (to 8 March 2013), EMBASE via OVID (to 8 March 2013), Chinese Biomedical Literature Database (to 12 March 2011), the WHO International Clinical Trials Registry Platform (to 8 March 2013) and the National Institutes of Health Clinical Trials Registry (to 8 March 2013). A handsearching group updated the handsearching of journals, carried out as part of the Cochrane Worldwide Handsearching Programme, to the most current issue. There were no restrictions regarding language or date of publication. SELECTION CRITERIA: Randomized controlled trials (RCTs) comparing different etching materials, or different etching techniques using the same etchants, for the bonding of fixed orthodontic brackets to incisors, canines and premolars in children and adults. DATA COLLECTION AND ANALYSIS: Two review authors extracted data and assessed the risk of bias of included studies independently and in duplicate. We resolved disagreements by discussion among the review team. We contacted the corresponding authors of the included studies to obtain additional information, if necessary. MAIN RESULTS: We included 13 studies randomizing 417 participants with 7184 teeth/brackets. We assessed two studies (15%) as being at low risk of bias, 10 studies (77%) as being at high risk of bias and one study (8%) as being at unclear risk of bias. Self etching primers (SEPs) versus conventional etchantsEleven studies compared the effects of SEPs with conventional etchants. Only five of these studies (three of split-mouth design and two of parallel design) reported data at the participant level, with the remaining studies reporting at the tooth level, thus ignoring clustering/the paired nature of the data. A meta-analysis of these five studies, with follow-up ranging from 5 to 37 months, provided low-quality evidence that was insufficient to determine whether or not there is a difference in bond failure rate between SEPs and convention etchants (risk ratio 1.14; 95% confidence interval (CI) 0.75 to 1.73; 221 participants). The uncertainty in the CI includes both no effect and appreciable benefit and harm. Subgroup analysis did not show a difference between split-mouth and parallel studies.There were no data available to allow assessment of the outcomes: decalcification, participant satisfaction and cost-effectiveness. One study reported decalcification, but only at the tooth level. SEPs versus SEPsTwo studies compared two different SEPs. Both studies reported bond failure rate, with one of the studies also reporting decalcification. However, as both studies reported outcomes only at the tooth level, there were no data available to evaluate the superiority of any of the SEPs over the others investigated with regards to any of the outcomes of this review.We did not find any eligible studies evaluating different etching materials (e.g. phosphoric acid, polyacrylic acid, maleic acid), concentrations or etching times. AUTHORS' CONCLUSIONS: We found low-quality evidence that was insufficient to conclude whether or not there is a difference in bond failure rate between SEPs and conventional etching systems when bonding fixed orthodontic appliances over a 5- to 37-month follow-up. Insufficient data were also available to allow any conclusions to be formed regarding the superiority of SEPs or conventional etching for the outcomes: decalcification, participant satisfaction and cost-effectiveness, or regarding the superiority of different etching materials, concentrations or etching times, or of any one SEP over another. Further well-designed RCTs on this topic are needed to provide more evidence in order to answer these clinical questions.

Bioinspired Polyacrylic Acid-Based Dressing: Wet Adhesive, Self-Healing, and Multi-Biofunctional Coacervate Hydrogel Accelerates Wound Healing.

Polyacrylic acid (PAA) and its derivatives are commonly used as essential matrices in wound dressings, but their weak wet adhesion restricts the clinical application. To address this issue, a PAA-based coacervate hydrogel with strong wet adhesion capability is fabricated through a facile mixture of PAA copolymers with isoprenyl oxy poly(ethylene glycol) ether and tannic acid (TA). The poly(ethylene glycol) segments on PAA prevent the electrostatic repulsion among the ionized carboxyl groups and absorbed TA to form coacervates. The absorbed TA provides solid adhesion to dry and wet substrates via multifarious interactions, which endows the coacervate with an adhesive strength to skin of 23.4 kPa and 70% adhesion underwater. This coacervate achieves desirable self-healing and extensible properties suitable for frequently moving joints. These investigations prove that the coacervate has strong antibacterial activity, facilitates fibroblast migration, and modulates M1/M2 polarization of macrophages. In vivo hemorrhage experiments further confirm that the coacervate dramatically shortens the hemostatic time from hundreds to tens of seconds. In addition, full-thickness skin defect experiments demonstrate that the coacervate achieves the best therapeutic effect by significantly promoting collagen deposition, angiogenesis, and epithelialization. These results demonstrate that a PAA-based coacervate hydrogel is a promising wound dressing for medical translation.

Quantification of colloidal filtration of polystyrene micro-particles on glass substrate using a microfluidic device.

A microfluidic device was designed to investigate filtration of particles in an electrolyte in the presence of liquid flow. Polystyrene spheres in potassium chloride solution at concentrations of 3-100 mM were allowed to settle and adhere to a glass substrate. A particle free solution at the same concentration was then flushed through the microfluidic channel at 0.03-4.0 mL/h. As the hydrodynamic drag on the adhered particles exceeded the intersurface interaction with the substrate, "pull-off" occurred and the particles detached. Filtration efficiency, α, was shown to a function of both ionic concentration of the liquid medium and flow speed, consistent with a phenomenological model based on the classical DLVO theory. The results elucidates the underlying physics of filtration.

Expression of MMP-2 and TIMP-1 during rapid maxillary expansion in rats.

OBJECTIVE: The aim of this study was to investigate the expression of MMP-2 and TIMP-1 during midpalatal suture expansion in rats. DESIGN: 72 male Wistar rats were randomly divided into 2 groups: the experimental group and the control group. In the experimental group, opening loops were applied across the midpalatal suture with an initial force of 50g, whereas in the control group, rats were subjected to sham installation of opening loops without activation. On day 1, 4, 7 and 14, nine rats from each group were sacrificed, and the maxillae were dissected and prepared for Immunohistochemistry (IHC) and RT- PCR examination of MMP-2 and TIMP-1 expression. RESULTS: The results of IHC and Real Time PCR revealed that both protein and mRNA expression of MMP-2 and TIMP-1 were significantly increased after midpalatal expansion, and the ratio of MMP-2/TIMP-1 was also significantly enhanced. CONCLUSIONS: The data suggested that MMP-2 and TIMP-1 might play an important role during the mid-palatal suture remodeling process of maxillary expansion.