AnCMBR-AFB-integrated process for the treatment of high nitrogen and phosphorus wastewater.

Improving the nitrogen and phosphorus removal rates and efficiently controlling membrane fouling are the keys to fully exploiting the applicability of anaerobic membrane bioreactor (AnMBR) process in high-concentration wastewater treatment. To that purpose, an integrated reactor composed of an anaerobic ceramic membrane bioreactor and N anaerobic fluidized bed (AnCMBR-AFB) was built and pollutant removal efficiency, nitrogen and phosphorus recovery characteristics, and membrane pollution features of this integrated reactor were investigated. The results revealed that the integrated reactor had good pollutant removal efficiency, with turbidity, chromaticity, and UV254 average values of the effluent being 0.470 NTU, 0.011 A, and 0.057 cm-1, respectively, and the average CODCr removal rate was 80%. The nitrogen and phosphorus recoveries were significantly higher than the nitrogen and phosphorus removal rates of conventional AnMBR at 23.20 ± 1.17% and 43.34 ± 1.54%, respectively. Microscopic analysis revealed the formation of magnesium ammonium phosphate (MAP) crystals on the carrier's surface, and friction between the carrier and the membrane surface could delay membrane fouling while allowing the contaminated membrane surface to retain significant roughness. Membrane fouling was mostly brought on by amides and saturated hydrocarbons, and inorganic metal ions also played a role to some extent.

Fully Fibrous Large-Area Tailorable Triboelectric Nanogenerator Based on Solution Blow Spinning Technology for Energy Harvesting and Self-Powered Sensing.

An all-fibrous large-area (20 × 50 cm2 ) tailorable triboelectric nanogenerator (LT-TENG) is prepared using a one-step solution blow spinning technology, which has the advantages of easy operation, scale-up in the area, and high production efficiency. The prepared LT-TENG is composed of polyvinylidene fluoride (PVDF)/MXene (Ti3 C2 Tx ) nanofibers (NFs) and conductive textile. Benefiting from the fibrous materials and large-area properties, the LT-TENG possesses the merits of good tailorability, breathability, hydrophobicity, and washability. When optimized by mixing the MXene into PVDF NFs, the LT-TENG has a preferable output and sensing property, with a detection range over 16 kPa and a relatively high sensitivity of 12.33 V KPa-1 . At maximum applied pressure, the voltage, current, and charge are 108 V, 38 µA, and 35 nC, respectively. This LT-TENG can serve as a biomechanical energy harvester when used as wearable devices with an output power density of 12.6 mW m-2 at an external load resistance of 500 MΩ, and it also has the ability of self-powered tactile sensing for pressure mapping and slide sensing. Thus, this LT-TENG exhibits great potential prospects in wearable devices, intelligent robots, and human-machine interaction.