RESUMEN
Alumina- and zirconia-based ceramic dental restorations are designed to repair functionality as well as esthetics of the failed teeth. However, these materials exhibited several performance deficiencies such as fracture, poor esthetic properties of ceramic cores (particularly zirconia cores), and difficulty in accomplishing a strong ceramic-resin-based cement bond. Therefore, improving the mechanical properties of these ceramic materials is of great interest in a wide range of disciplines. Consequently, spatial gradients in surface composition and structure can improve the mechanical integrity of ceramic dental restorations. Thus, this article reviews the current status of the functionally graded dental prostheses inspired by the dentino-enamel junction (DEJ) structures and the linear gradation in Young's modulus of the DEJ, as a new material design approach, to improve the performance compared to traditional dental prostheses. This is a remarkable example of nature's ability to engineer functionally graded dental prostheses. The current article opens a new avenue for recent researches aimed at the further development of new ceramic dental restorations for improving their clinical durability.
RESUMEN
This study aimed to analyse and compare the stability of two dental posts cemented with four different luting agents by examining their shear stress transfer through the FEM. Eight three-dimensional finite element models of a maxillary central incisor restored with glass fiber and Ni-Cr alloy cast dental posts. Each dental post was luted with zinc phosphate, Panavia resin, super bond C&B resin and glass ionomer materials. Finite element models were constructed and oblique loading of 100 N was applied. The distribution of shear stress was investigated at posts and cement/dentine interfaces using ABAQUS/CAE software. The peak shear stress for glass fiber post models minimized approximately three to four times of those for Ni-Cr alloy cast post models. There was negligible difference in peak of shear stress when various cements were compared, irrespective of post materials. The shear stress had same trend for all cement materials. This study found that the glass fiber dental post reduced the shear stress concentration at interfacial of post and cement/dentine compared to Ni-Cr alloy cast dental post.
RESUMEN
AIM: To analyze and compare the tensile stress distribution in endodontically treated teeth restored with cast-made (Ni-Cr and gold) and prefabricated (titanium and glass fibre) dental posts. METHODOLOGY: Four threedimensional finite element (FE) models of a maxillary central incisor restored with Ni-Cr cast-made (Model Ni-Cr), gold cast-made (Model GO), prefabricated titanium (Model TI) and prefabricated glass fibre (Model FP) posts were constructed. An oblique loading of 100N was applied to each three-dimensional model. Tensile stress distribution within the root dentine and at the post and surrounding structure interfaces were analysed. RESULTS: In all the FE models studied, a higher magnitude of tensile stresses was observed on the palatal aspect of the cervical dentin as compared to the labial aspect and progressively decreases from the outer to the inner part of the root. The gold cast-made and glass fibre post models showed significantly less tensile stress concentration in the post-core component than the other experimental models. The maximum tensile stress was seen on the palatal aspect of the Ni-Cr compared to other posts. The higher magnitude interfacial tensile stress concentration was observed in a pulpless tooth restored with a Ni-Cr cast-made post, followed by titanium and gold castmade posts, respectively. However, the minimum interfacial tensile stress was noticed in a pulpless tooth restored with a glass fibre post. CONCLUSION: Glass fibre posts tend to transfer tensile stress more homogenously within the tooth and at interfaces than the other types of investigated posts.