Simultaneous enantiospecific recognition of several ß-blocker enantiomers using molecularly imprinted polymer-based electrochemical sensor.

The development of a chiral electrochemical sensor using an electrogenerated molecularly imprinted polymer (MIP)-based ultrathin film using R(+)-atenolol (ATNL) as a template was reported. The proposed sensor exhibited distinctive enantiospecific oxidation peaks toward the R-antipodes of four ß-blocker representatives and additional oxidation peaks common to both enantiomers of each studied ß-blocker, allowing thus the simultaneous analysis of all of their enantiomers in a single analysis. The specific preconditioning of the polymer by alternative exposure to aqueous and nonaqueous medium was proven to be essential for the chiral recognition ability of the obtained sensor. The rebinding property of the MIP film was studied by using a well-known redox probe, a change in the morphology and diffusive permeability of the thin polymeric layer in the presence of its template being observed. The applicability of the optimized analytical procedure was demonstrated by the analysis of ATNL's enantiomers in the range of 1.88 × 10(-7)-1.88 × 10(-5) mol/L. The developed polymeric interface is the first reported transductor of a chiral electrochemical sensor able to exhibit simultaneous enantiospecificity toward several ß-blocker representatives extensively used in the pharmaceutical and biomedical fields, offering good prospects in the simple, cost-effective, and fast assessment of their enantiomeric ratio and total concentration.

Potentiometric propranolol-selective sensor based on molecularly imprinted polymer.

A novel potentiometric sensor based on molecularly imprinted polymer (MIP) for propranolol, an adrenergic-blocking drug, was designed. The influence of molecularly imprinted polymer particle content and sodium tetraphenylborate additives in polyvinylchloride membrane was shown. The electrodes show near-Nernstian responses down to 10(-4)-10(-5) M propranolol concentration. The potentiometric response of MIP-based sensor for propranolol in mixed nonaqueous medium was shown at first. Sensor selectivity relative to various inorganic cations, atenolol and metoprolol, was reported. Direct potentiometry was used to determine propranolol in aqueous modeling solutions and pharmaceutical preparations with good results.

Mucoadhesive liposomal delivery systems: the choice of coating material.

OBJECTIVE: Development of liposomal mucoadhesive drug delivery system, which is able to improve the bioavailability of poorly absorbed oral drugs by prolonging their gastric and intestinal residence time, through facilitating the intimate contact of the delivery system with the absorption membrane. MATERIALS AND METHODS: Liposomes containing model drug atenolol were prepared by the modified ethanol injection method. Liposomes containing atenolol were coated by different mucoadhesive polymers, for example, chitosan, Carbopol 974P, Eudragit L100, and Eudragit S100, to optimize the choice of coating material. The delivery systems were tested for their in vitro mucoadhesiveness. RESULTS: Liposomes prepared by the ethanol injection method were of satisfactory size (around 100 nm, before coating). Through the coating of liposomes in the presence of unentrapped material, the entrapment efficiency for drug was increased. In vitro mucoadhesive test confirmed the mucoadhesive properties of the coated layer for all tested polymers; however, Eudragit S100-coated liposomes were superior to other coating materials. DISCUSSION: Eudragit coating appeared to be an optimal polymer choice. These preliminary data indicate that polymer-coated mucoadhesive liposomes are able to carry sufficient amount of drug and to remain attached to the intestinal mucosa for a sufficient period of time to enable prolonged absorption of entrapped drug. CONCLUSION: While keeping in mind that the in vivo conditions may vary with the in vitro ones, we may recommend the system described in our work for possible oral delivery of peptides and phytochemicals.

Preparation and evaluation of propranolol molecularly imprinted solid-phase microextraction fiber for trace analysis of beta-blockers in urine and plasma samples.

An improved multiple co-polymerization technique was developed to prepare a novel molecularly imprinted polymer (MIP)-coated solid-phase microextraction (SPME) fiber with propranolol as template. Investigation was performed for the characteristics and application of the fibers. The MIP coating was highly crosslinked and porous with the average thickness of only 25.0 microm. Consequently, the adsorption and desorption of beta-blockers within the MIP coating could be achieved quickly. The specific selectivity was discovered with the MIP-coated fibers to propranolol and its structural analogues such as atenolol, pindolol, and alprenolol. In contrast, only non-specific adsorption could be shown with the non-imprinted polymer (NIP)-coated fibers, and the extraction efficiencies of propranolol and pindolol with the MIP-coated fibers were higher markedly than that with the commercial SPME fibers. A MIP-coated SPME coupled with high-performance liquid chromatography (HPLC) method for propranolol and pindolol determination was developed under the optimized extraction conditions. Linear ranges for propranolol and pindolol were 20-1000 microg L(-1) and detection limits were 3.8 and 6.9 microg L(-1), respectively. Propranolol and pindolol in the spiked human urine and plasma samples, extracted with organic solvent firstly, could be simultaneous monitored with satisfactory recoveries through this method.

Drug release from a porous ion-exchange membrane in vitro.

The effect of environmental ionic strength on the rate of drug release from a cation exchange membrane was evaluated. Cationic propranolol-HCl, timolol, sotalol-HCl, atenolol and dexmedetomidine-HCl and neutral diazepam were adsorbed onto a porous poly(vinylidene fluoride) (PVDF) membrane that was grafted with bioadhesive poly(acrylic acid) chains (PAA-PVDF). Despite its porosity, the PAA-PVDF membrane acted as a cation exchange membrane. The release of adsorbed drug from the PAA-PVDF membrane was investigated by using a USP rotating basket apparatus. Adsorption of cationic drugs onto the PAA-PVDF membrane tended to increase with increasing lipophilicity of the drug. A decrease in the ionic strength of the adsorption medium increased the amount of the cationic drugs adsorbed onto the membrane, but had no effect on diazepam adsorption. The release of cationic drugs from the PAA-PVDF membrane was greatly affected by the ionic strength of both the adsorption medium and the dissolution medium, while ionic strengths did not affect diazepam release. Our results suggest that the ionic strength of both the adsorption and dissolution media substantially affects the release rate of a drug that has been adsorbed onto the ion exchange membrane, primarily via electrostatic interactions, while ionic strength has no effect on the release of a drug which has been adsorbed onto the membrane via non-electrostatic forces.

Stabilized lipid film based biosensor for atenolol.

This work reports a technique for the stabilization after storage in air of a lipid film based biosensor for atenolol. Microporous filters composed of glass fibers (nominal pore sizes 0.7 and 1.0 microm) were used as supports for the formation and stabilization of these devices. The lipid film is formed on the filter by polymerization prior to its use. Methacrylic acid was the functional monomer, ethylene glycol dimethacrylate was the crosslinker and 2,2'-azobis-(2-methylpropionitrile) was the initiator. The method for preparation of stabilized lipid film biosensor is studied throughout this work. The response towards atenolol of these stabilized lipid membrane biosensor, for repetitive use, composed of phosphatidylcholine was compared with planar freely suspended bilayer lipid membranes (BLMs). The stabilized lipid membranes provided similar artificial ion gating events as BLMs in the form of transient signals and can function for repetitive uses after storage in air. This will allow the practical use of the techniques for chemical sensing based on lipid films and commercialization of these devices.

Evaluation of the immobilized artificial membrane phosphatidylcholine. Drug discovery column for high-performance liquid chromatographic screening of drug-membrane interactions.

Chromatographic retention factors (k') of a series of eight beta-adrenoceptor antagonist compounds (beta-adrenolytic drugs) were determined employing an immobilized artificial membrane column (IAM.PC.DD). The influence of mobile phase pH, ionic strength, and organic modifier composition was studied in order to examine column performance. After the IAM.PC.DD columns were exposed to approximately 7000 column volumes of a 0.01 M PBS mobile phase, five out of six columns tested showed significant peak broadening and decreased k' values indicative of premature column failure. The data suggested that the immobilized phospholipids stationary phase was removed by the 0.01 M PBS mobile phase. The beta-adrenolytic drug's log k'IAM values obtained with an IAM.PC.DD column were compared to an esterIAM.PC.MG column for predicting drug membrane interactions. For the linear regression analysis between log k'IAM and the logarithm of the n-octanol-water partition coefficients (rIAM.PC.DD = 0.8710 vs. rIAM.PC.MG = 0.9538), the C18 HPLC retention factors (rIAM.PC.DD = 0.8408 vs. rIAM.PC.MG = 0.9380), the liposome partition coefficients (rIAM.PC.DD = 0.8887 vs. rIAM.PC.MG = 0.9187), and various pharmacokinetic parameters, significantly better correlations were obtained with the esterIAM.PC.MG column than the IAM.PC.DD column.

A minisensor for the rapid screening of atenolol in pharmaceutical preparations based on surface-stabilized bilayer lipid membranes with incorporated DNA.

This work describes an electrochemical technique that is suitable for the rapid and sensitive screening of atenolol based on surface-stabilized bilayer lipid membranes (s-BLMs) composed from egg phosphatidylcholine (PC). The interactions of atenolol with s-BLMs produced electrochemical ion current increases that reproducible appeared within a few seconds after the exposure of the membranes to the drug. The current signal increase was related to the concentration of atenolol in bulk solution in the micromolar range. The present lipid film-based sensor provided fast response (i.e. on the order of a few seconds) to alterations of atenolol concentration (20 to 200 micro M) in electrolyte solution. ssDNA incorporated into s-BLMs can interact with atenolol, and decreased the detection limit of this drug by one order of magnitude. The oligomers used were single stranded deoxyribonucleic acids: thymidylic acid icosanucleotide terminated with a C-16 alkyl chain to assist incorporation into s-BLMs (5'-hexadecyl-deoxythymidylic acid icosanucleotide, dT(20)-C(16)). The electrochemical transduction of the interactions of atenolol with s-BLMs was applied in the determination of these compounds in pharmaceutical preparations by using the present minisensor.

Polymeric matrix membrane sensors for sensitive potentiometric determination of some beta-blockers in pharmaceutical preparations.

Five poly(vinyl chloride) matrix membrane sensors responsive to some beta-blockers (atenolol, bisoprolol, metoprolol, propranolol and timolol) are described and characterized. The sensors are based on the use of the ion-association complexes of the beta-blocker cations with tungstophosphate anion as electroactive materials. The performance characteristics of these sensors, evaluated according to IUPAC recommendations, reveal fast, stable and near-Nernstian response for 10(-2)-2 x 10(-7) mol l(-1) of different beta-blockers over the pH range 2-9. Many inorganic and organic cations as well as drug excipients and diluents normally used in drug formulations do not interfere. The sensors are used for direct potentiometry of beta-blockers in some pharmaceutical preparations. Validation of the method according to the quality assurance standards shows suitability of the proposed sensors for use in the quality control assessment of these drugs. Results with an average recovery of 99.1% and a mean standard deviation of +/- 1.3% of the nominal are obtained which compare fairly well with data obtained using the British Pharmacopoeia method.

Development and validation of a chiral liquid chromatographic method for the determination of atenolol and metoprolol enantiomers in tablet preparations.

Atenolol (AT) and metoprolol (MT) are predominantly used in the treatment of angina pectoris, certain arrhythmias, systemic hypertension, and several other cardiovascular disorders. Both compounds are produced commercially in the racemic form, although the S-form is responsible for the desired biological effect. This paper describes a simple, rapid, precise, and accurate method for separating the enantiomers of AT and MT. AT isomers are separated by using a Chiralcel OD column (250 x 4.6 mm, 10 microm), hexane-ethanoldiethylamine-acetic acid (60 + 40 + 0.2 + 0.2, v/v/v/v) as the mobile phase, and a flow rate of 1.0 mL/min. MT isomers are separated by using a mobile phase with the same components in the following proportions (40 + 60 + 0.2 + 0.2, v/v/v/v) and a flow rate of 0.8 mL/min. Ultraviolet detection was at 276 nm for both analytes. The coefficients of variation (CVs) and average recoveries (ARs) for the R-enantiomers in samples A, B, C, D, and E were 1.15 and 101.06%, 0.74 and 99.25%, 1.05 and 102.57%, 0.84 and 101.57%, and 0.86 and 98.62%, respectively. The CVs and ARs for the S-enantiomers in samples A, B, C, D, and E were 1.33 and 98.87%, 0.99 and 100.76%, 1.17 and 101.69%, 1.26 and 100.39%, and 1.40 and 99.39%, respectively. The standard curves of R-AT, S-AT, R-MT, and S-MT showed good linearity over the concentration range studied with correlation coefficients of 0.9991, 0.998, 0.9988, and 0.999, respectively.

Direct detection of analyte binding to single molecularly imprinted polymer particles by confocal Raman spectroscopy.

We describe the use of Raman spectroscopy to detect and quantify, for the first time, the presence of the imprinting template in single molecularly imprinted polymer microspheres. The polymers were imprinted with the beta-blocking drugs propranolol and atenolol, and precipitation polymerization was used to obtain spherical particles of diameters of 200 nm and 1.5microm. The size of the Raman laser spot being between 1microm and a few mum, the nanoparticles were used for bulk detection whereas with micrometer-sized particles, quantitative measurements on single particles were possible. The laser power, and consequently the acquisition times, needed to be adapted as a function of the polymer and template used in order to avoid burning. Analyte quantification from Raman spectra is straightforward by determining the peak height of a typical Raman band of the analyte, and by using a typical polymer peak for normalization. Relatively low detection limits down to 1microM have been reached for the detection of S-propranolol through bulk measurements on MIP nanoparticles.