Impact of molar teeth distalization by clear aligners on temporomandibular joint: a three-dimensional study.

BACKGROUND: Maxillary molar distalization is a common technique used in the non-extraction treatment of Angle Class II malocclusion that can effectively correct the molar relationship and create spaces for anterior teeth alignment. However, this approach may also impact the temporomandibular joint (TMJ) due to predictable changes in the posterior vertical dimension. Despite its widespread use, Class II malocclusions correction by molar distalization with clear aligners has not been investigated for their effects on the TMJ. Therefore, this study aimed to analyze the impact of sequential molar distalization using clear aligners on the TMJ. METHODS: Three-dimensional CBCT scans of 23 non-growing patients (7 males, 16 females; mean age 29.8 ± 4.6 years) with skeletal class I or II malocclusion and a bilateral molar class II relationship treated by sequential upper molars distalization with orthodontic clear aligners (Invisalign, Align Technology, San Josè, Ca, USA). A total of 46 joints were examined before and after molar distalization using Anatomage InvivoDental 6.0.3. Linear and angular measurements of the mandibular joint were measured, including joint parameters, inclination, position, and the dimension of the condyle and articular fossa. In addition, 3D volumetric spaces of the joint were analyzed. All data were statistically analyzed by paired T test to determine the differences between the pre-and post-orthodontic procedures. RESULTS: No statistically significant differences were found in all primary effects resulting from maxillary molars distalization by clear aligners on TMJ components measurements and joint spaces between T0 and T1. Meanwhile, statistically significant differences were observed in the linear position of the upper molars and the molar relationship parameter with at least P ≤ 0.05. CONCLUSION: Treatment by sequential upper molars distalization with clear aligners does not lead to significant TMJ parameters changes in condyle and fossa spaces, dimensions, and positions.

Correlation between the three-dimensional maxillomandibular complex parameters and pharyngeal airway dimensions in different sagittal and vertical malocclusions.

OBJECTIVES: This study aimed to determine the three-dimensional (3D) correlation between maxillomandibular complex parameters and pharyngeal airway dimensions in different sagittal and vertical malocclusions. METHODS: This retrospective cross-sectional study included the CBCT scans of 368 patients with a mean age of 23.81 ± 3.01 years. The patients were classified into three groups (skeletal Class I, II, and III). Each class group was divided into three subgroups based on vertical growth patterns (hypo-, normo-, and hyperdivergent). The maxillomandibular complex was evaluated in the three planes using 16 skeletal measurements. Naso-, oro-, hypo-, and total pharyngeal airway spaces were assessed in terms of width, volume, surface area, and minimum constricted area (MCA). Two-way ANOVA followed by the Bonferroni post-hoc test were used. RESULTS: The nasopharyngeal airway space was significantly lowest regarding sagittal and lateral widths in the skeletal Class III patients, the lowest volume and surface area were in hyperdivergent patients, and MCA was the highest in Class II and hypodivergent patients. The oro- and hypopharyngeal sagittal width, volume, surface area, and MCA were the lowest in the hyperdivergent patients, and oropharyngeal lateral width and hypopharyngeal sagittal width were the highest in skeletal Class III. The total pharyngeal volume, surface area, and MCA were the lowest in the hyperdivergent patients, and skeletal Class II patients had the lowest MCA. CONCLUSIONS: The pharyngeal airway dimensions differ with various sagittal and vertical malocclusions. These differences could apply to diagnosis, treatment planning, and possible changes following orthodontic/orthopedic or surgical treatment.