Parameters Used With Diode Lasers (808-980 nm) in Dentin Hypersensitivity Management: A Systematic Review.

Introduction: The present study aimed to describe parameters used with 808- to 980-nm wavelength diode lasers for managing dentin hypersensitivity and analyze their results. Methods: The inclusion criteria were based on randomized controlled clinical trials using diode lasers at an 808-980 nm wavelength range in patients with dentine hypersensitivity with a minimum of 1-month follow-up. An electronic search for articles on Medline, PubMed and Cochrane databases was performed. The risk of bias was assessed with the Cochrane collaboration tool. Results: Our electronic search resulted in 130 papers, of which 11 articles met the inclusion criteria. A majority of the studies assessed dentine hypersensitivity using the Visual Analogue Scale, which ranged between 2.3 and 8.8 before treatment and significantly reduced to a mean value of 0.45-3.7 after diode laser application. The power settings ranged between 1.5 mW and 3 W with an emission mode of continuous wave, except for 2 authors who used chopped mode. The energy density varied from 2.5 to 128 J/cm2, and the exposure time was between 10 and 120 seconds. The authors applied a minimum of 1 to 4 treatment sessions with a 2-day to 1-week interval between them. Most of the studies mentioned the tooth surface as the treatment site but without describing the specific irradiation points. Conclusion: Despite the heterogeneity of the analyzed variables, a statistically significant improvement in all laser groups was described. However, they cannot be compared homogenously.

Photodynamic Therapy in Endodontics: A Helpful Tool to Combat Antibiotic Resistance? A Literature Review.

BACKGROUND: Antibiotic resistance has become a growing global problem where overprescription is a contributing factor for its development. In the endodontics field, complementary treatments, such as antimicrobial photodynamic therapy (aPDT), have been described to eliminate residual bacteria from the root canal space and reduce complications. The aim of this review is to describe the literature evidence up to now regarding the advantages, efficiency, and clinical outcomes of this therapy in endodontics as a possible tool to combat antibiotic resistance. METHODS: A review of the literature from 2010 to 2021 was carried out using the PubMed and Web of Science databases. Two steps were taken: First, articles were compiled through the terms and MeSH terms "Photochesdmotherapy" and "endodontics." Then, a second search was conducted using "photodynamic therapy" and "antibiotic resistance" or "drug resistance, microbial." RESULTS: A total of 51 articles were included for evaluation: 27 laboratory studies, 14 reviews, and 10 clinical studies. Laboratory studies show that aPDT achieves significant bacterial elimination, even against antibiotic-resistant species, and is also effective in biofilm disruption. Clinical studies suggest that aPDT can be considered a promising technique to reduce bacterial complications, and reviews about the issue confirm its advantages. CONCLUSION: The benefits of aPDT in reducing complications due to its antibacterial effects means a possible decrease in systemic antibiotic prescription in endodontics. In addition, it could be an alternative to local intracanal antibiotic therapy, avoiding the appearance of possible antibiotic resistance, as no bacterial resistance with aPDT has been described to date.

Aerosols generation using Er,Cr:YSGG laser compared to rotary instruments in conservative dentistry: A preliminary study.

BACKGROUND: In restorative dentistry, the use of high-speed air turbine, which generates aerosols, can be associated with the transmission of airborne diseases. New laser technologies could be useful in reducing the amount of aerosols, but there is a lack of scientific research on this topic. MATERIAL AND METHODS: This is a descriptive study to analyze the amount of aerosols produced after class I cavity preparation using high-speed air turbine (group 1) and Er,Cr:YSGG laser with two different parameters (groups 2 and 3). Fluorescein dye was incorporated into the coolant reservoir in order to visualize the production of aerosols during each procedure. Tooth preparation was performed in a typodont with human lower molar tooth under rubber dam isolation. The procedure was carried out in a transparent plastic box to avoid aerosols dispersion. Sixteen grade I cellulose filter discs were distributed along the surfaces of the box. The area contaminated with aerosols in the filters was measured using ultraviolet illumination. RESULTS: In group 1, the contaminated surface area covered with fluorescein dye reached 77.3% (1349 cm2) of the total; in group 2 (laser with 80% water) we observed 7.3% (128 cm2) and in group 3 (laser with 40% water) it was 3.8% (68 cm2). The reduction in water parameter from 80% to 40% coincided with 48% reduction of the contaminated area on the filter discs. Focusing on the surfaces of the box, we noted that the mean contamination on the left side was more than on the right side in all three experimental groups. In group 1 using air turbine, we measured a mean of 102.6[±7.5 SD]cm2 on the left side, compared to 70.6[±32.3 SD]cm2 on the right side. In laser groups 2 and 3, a mean of 12.8[±14.9 SD]cm2 and 6.8 [±5.7SD]cm2, respectively, was described on the left surface versus 0 cm2 of surface contamination on the right surface. CONCLUSIONS: The contaminated area during the procedure of class I cavity preparation, is reduced by 70% using Er,Cr:YSGG laser compared to high-speed turbine. A slightly higher contamination was observed between laser groups with 80% versus 40% water. The use of Er,Cr:YSGG laser in restorative dentistry can be a valid treatment alternative to reduce aerosols production compared to conventional high-speed rotary instruments. Key words:Er,Cr:YSGG laser, Aerosols, SARS-CoV-2, Rotary instruments, conservative dentistry.

Effect of Photobiomodulation (Diode 810 nm) on Long-Standing Neurosensory Alterations of the Inferior Alveolar Nerve: A Case Series Study.

Objective: To evaluate and describe the results of photobiomodulation (PBM) therapy on the treatment of long-standing neurosensory inferior alveolar nerve (IAN) alterations after third molar extraction. Background: The use of PBM is an acceptable alternative method to improve the therapeutic outcomes of neural lesions. Materials and methods: Longitudinal case study research. Patients with >6 months of inferior alveolar neurosensory disturbance after third molar extraction were included. Fifteen laser sessions were done, irradiating intra- and extraoral points along the distribution of this nerve area. A semiconductor Ga,Al,As diode laser (Thor laser®) was used. Before and after the treatment, variables such as Zuniga-Essick score, British Medical Research Council (BRC) scale, visual analog scale (VAS), and mapping of the affected area were described. Gender, age, and duration of the lesion were analyzed. Descriptive statistical study was carried out with SPSS 19.0. Results: Eleven patients with a mean age of 38.5 years [standard deviation (SD) ±15.22]. Average duration of the lesion was 13.2 (SD ±4) months. The results obtained with the Zuniga-Essick scale before treatment showed mild alteration in 36.3% (4), moderate in 18.2% (2), and severe in 45.4% (5). After treatment, the percentage score improved, obtaining normality in 54.5% (6) of the patients and mild degree in 27.2% (3). In the BRC score, before the treatment, 45.4% (5) of grade S2+ and 27% (3) of S3 and S3+ were obtained. The final percentage after treatment reached an improvement of S4 in a total of 36% (4) of cases and a recovery of S3+ in 54.5% (6). Reduction of the mapped altered area and an upturn of VAS were noted. Conclusions: The laser parameters and application protocol used result in subjective and objective improvement in mechanical sensory perception in long-standing neurosensory deficit in the IAN.