Occlusion accuracy of restorations and removable partial dentures fabricated using the impression under occlusal force with functionally generated path recording.

To evaluate the occlusion accuracy of a novel impression technique, excessively high occlusion and the occlusal contact area during lateral movements were compared between metal restorations (restorations) and removable partial dentures (RPDs) fabricated using conventional and novel techniques. Both restorations and RPDs were fabricated on the simulation model with the precise displacement of the remaining teeth and soft tissue. For the novel technique, functionally generated path (FGP) recording and impression under occlusal force were simultaneously performed using a custom tray with an FGP table. For the two conventional techniques, definitive casts were mounted on an average value articulator and a semi-adjustable articulator in the typical manner. Prostheses were placed on the simulation models, and excessively high occlusion in the intercuspal position and occlusal contact areas during lateral movements were measured. Statistical analyses were performed using Kruskal-Wallis and Steel-Dwass tests (α = 0.05). For both prostheses, conventional techniques showed significantly higher occlusion in the intercuspal position than the novel technique. Moreover, the new technique demonstrated better guidance contact during lateral movements than conventional techniques. This novel technique can be recommended for the fabrication of highly accurate prostheses with appropriate occlusal contact without corrections at delivery.

A simple technique for impression taking of teeth and functionally generated paths.

The objective of this case report is to introduce a simple technique for simultaneously taking a closed-mouth impression and functionally generated path (FGP) for a full coverage crown restoration. A monolithic zirconia crown was the restoration of choice. An alginate impression of the abutment tooth was taken to fabricate a custom-made closed-mouth impression tray covering the abutment tooth and the adjacent teeth. The tray had an FGP table and an abutment tray in cameo and intaglio surfaces, respectively. The impression was taken with silicone impression material after adjusting the abutment tray and inscribing the FGP using self-curing acrylic resins. Plaster casts were made from the impression, and a zirconia crown was fabricated. The crown was cemented to the abutment tooth with minimal adjustments. This simple technique resulted in a well-fitting crown that accounted for mandibular movements. Using the custom closed-mouth impression tray incorporating an FGP table simultaneously aids in fabricating an accurately fitting restoration that incorporates harmonious mandibular movements using a single impression capture.

Titanium removable partial denture clasp repair using laser welding: a clinical report.

This clinical report describes repair of a fractured removable partial denture clasp using laser welding rather than a conventional torch soldering technique.