Enhanced Adhesion of Polydimethylsiloxane Using an Interlocked Finger Structure.

Silicone-based polymers have been widely used for many applications, but their extremely low surface energies and the resulting poor adhesion have been the cause for continuous problems. Herein, a novel adhesion improvement technique using an interlocked finger structure is demonstrated, which enables up to 24.8 and 7.3-fold increases in adhesion compared to the untreated and conventional plasma-treated cases, respectively. The interlocked finger structure is fabricated by surface-confined dissolution and subsequent directional melt crystallization of a solvent. After removing the solvent crystals, porous surfaces are prepared from polyurethane, polyvinyl alcohol, and polystyrene, and these are used to fabricate interfaces of interlocked finger structures with polydimethylsiloxane. The improvement in adhesion strength linearly depends on the pore depth of the prepared surfaces. This novel technique of surface adhesion could improve the performance of polymers with intrinsically poor adhesion in future applications.

Fabrication of 3D honeycomb-like porous polyurethane-functionalized reduced graphene oxide for detection of dopamine.

A three dimensional reduced graphene oxide/polyurethane (RGO-PU) porous material with connected pores was prepared by physical adsorption of RGO onto the surface of porous PU. The porous PU was prepared by directional melt crystallization of a solvent, which produced high pores with controlled orientation. The prepared RGO-PU was characterized by scanning electron microscopy, spectroscopy and electro-chemical methods. The RGO-PU porous material revealed better electrochemical performance, which might be attributed to the robust structure, superior conductivity, large surface area, and good flexibility. Differential pulse voltammetry (DPV) analysis of DA using the RGO-PU exhibited a linear response range over a wide DA concentration of 100-1150pM, with the detection limit of 1pM. This sensor exhibited outstanding anti-interference ability towards co-existing molecules with good stability, sensitivity, and reproducibility. Furthermore, the fabricated sensor was successfully applied for the quantitative analysis of DA in human serum and urine samples with acceptable recovery, which indicates its feasibility for practical application.