Membrane fixation enhances guided bone regeneration in standardized calvarial defects: A pre-clinical study.

AIM: To determine whether collagen membrane (CM) fixation enhances guided bone regeneration in standardized defects. MATERIALS AND METHODS: Four 8-mm-diameter defects were surgically made in eight rabbit calvaria, and randomly allocated into four groups: control (empty), unfixed-CM, fixed-CM, and unfixed-CM with bone graft (BG + CM) (positive control). After 1- and 4-week healing periods, the animals were sacrificed and quantitative reverse transcription polymerase chain reaction, micro-computed tomography, and histological outcomes were assessed. RESULTS: At week 1, the expression levels of BMP-2, FGF-2, VEGF, and osteocalcin were significantly higher in the fixed-CM group than in the unfixed-CM and control groups (p < .05). Conversely, cathepsin-K was significantly expressed in the unfixed-CM group. No significant differences in expression markers were observed between the fixed-CM and BG + CM groups (p > .05). At week 4, new bone formation was significantly higher in the fixed-CM group than the unfixed-CM and control groups (p < .05), but similar to the BG + CM group (p > .05). CONCLUSIONS: CM fixation enhances the expression of osteogenic factors similar to BG + CM, leading to significantly more new bone formation. This suggests that the osteogenic potential is greater when membranes are fixed, thereby limiting the necessity of membrane-supporting materials to enhance bone formation.

Addition of autogenous bone chips to deproteinized bovine bone mineral does not have additional benefit in lateral ridge augmentation-A preclinical in vivo experimental study.

OBJECTIVE: To compare the outcome after extensive lateral guided bone regeneration using deproteinized bovine bone mineral (DBBM) with or without autogenous bone chips in a canine model of chronic horizontal alveolar ridge defect. MATERIALS AND METHODS: The second, third and fourth lower premolars of both sides were extracted, and the buccal bone walls were completely removed in five beagle dogs. After 4 weeks, DBBM particles mixed with autogenous bone chips at a ratio of 1:1 were grafted at one side (DBBM/Auto group), while DBBM particles alone were grafted at the contralateral side (DBBM group). The graft materials on both sides were covered by a resorbable collagen membrane and fixation pins. Microcomputed tomographic volume and histomorphometric analyses were performed at 16 weeks post-surgery. RESULTS: The ridges of both groups were recovered horizontally, but new bone formation beyond the original ridge contour at the defect site was not found. The DBBM group exhibited a larger total radiographic augmented volume and new bone volume compared with the DBBM/Auto group, but the differences were minimal (p > .05). Histologically, the regenerated area and new bone area were also slightly larger without any statistical significance in the DBBM group than in the DBBM/Auto group (p > .05). CONCLUSION: The addition of autogenous bone chips to DBBM for lateral ridge augmentation may confer no advantage over grafting DBBM alone with respect to both space maintenance and de novo bone formation in dogs.

Do periodontal defects affect periodontal inflammation and destruction? Histological/microbiological changes and gene expression profiles of a pilot study in beagle dogs.

BACKGROUND: The present study focused on the inflammatory disease progress after periodontal defect induction and aimed to specifically determine periodontal tissue responses following dental plaque accumulation by ligatures on a site with/without standardized periodontal defect induction. METHODS: After 1 month from extraction of the adjacent teeth, semi-circumferential defects were surgically created in the unilateral second and fourth premolars (test group), whereas no defects were being induced at the contralateral sites (control group). One week later, silk was used to ligate the tooth cervix at both sites to encourage the accumulation of dental plaque. Four weeks later, the tissue samples were collected for histological/histomorphometric and microarray analysis. Microbiological analysis was performed before defect induction and at ligatures, and after 4 weeks of dental plaque accumulation. RESULTS: Remarkable inflammation was clinically and histologically observed in both groups after plaque accumulation, and the intrabony type of periodontal defect exaggerated inflammatory cell infiltration into the connective tissue layer. Expression of genes related to inflammation such as IL-1 was highly up-regulated in test sites. However, these inflammatory infiltrations did not invade to a boundary of periodontal ligament and connective tissue attachment in both groups, and histomorphometric results corresponds to these observational results. Bacterial findings also showed no significant differences in detected microbiome compositions between control and test groups at three-time points. CONCLUSION: Intrabony defect might exaggerate the plaque-induced inflammation in the aspect of inflammatory cell infiltration and the related gene expression, but both dental plaque and the pre-existing periodontal defect negligibly disrupt periodontal attachment and the underlying alveolar bone.

Physiochemical properties and resorption progress of porcine skin-derived collagen membranes: In vitro and in vivo analysis.

The aim of the present study was to evaluate the physiochemical properties and resorption progress of two cross-linked, porcine skin-derived collagen membranes and compare their features with those of a membrane without cross-linking (Bio-Gide® [BG], Geistlich Biomaterials, Wolhusen, Switzerland). Three porcine skin-derived collagen membranes, dehydrothermally (DHT) cross-linked (experimental), DHT and 1-ethyl-3(3-dimethylaminopropyl)-carbodiimide (DHT/EDC) cross-linked (experimental) and BG were investigated for their morphology, enzyme resistance, and tensile strength in vitro and biodegradation in vivo. DHT and DHT/EDC membranes exhibited irregular, interconnected macro- and micropores that formed a 3D mesh, whereas BG exhibited individual collagen fibrils interlaced to form coarse collagen strands. In enzyme resistance and tensile strength tests, DHT and DHT/EDC membranes demonstrated good resistance and mechanical properties compared with BG. In vivo, all three membranes were well integrated into the surrounding connective tissue. Thus, the DHT membrane exhibited its potential as a barrier membrane for guided bone and tissue regeneration.

Surgical Treatment of Severe Peri-Implantitis Using a Round Titanium Brush for Implant Surface Decontamination: A Case Report With Clinical Reentry.

The most common cause of peri-implantitis is the accumulation of plaque and the formation of a biofilm on the implant surface. Terminating the development of the disease requires the biofilm to be removed from the implant surface. This paper describes 2 cases of severe peri-implantitis lesions treated through surgical approaches. Complete mechanical debridement with a round titanium brush was mainly performed to detoxify and modify the affected implant surface. A regenerative approach was then performed. In both cases, the surgical procedure was effective in arresting the peri-implantitis, and clinical reentry revealed uneventful healing of the existing bone defect. No further radiographic bone loss was observed over the 2-year follow-up period. This technique has the advantage of effective cleaning the contaminated implant surface, producing positive clinical and radiological results. However, further studies involving more cases are necessary to verify the reliability and validity of this technique.