Clinical application of the mirror irradiation technique in photodynamic therapy for malignant glioma.

BACKGROUND: Intraoperative photodynamic therapy (PDT) using talaporfin sodium for malignant glioma is effective both in the experimental and in the clinical setting. Because the irradiation unit is fixed to the objective lens of the operating microscope, blind spots for irradiation exist. To overcome this problem, we developed a mirror reflecting system using a modified dental mirror. METHODS: The developed mirror is made of stainless steel, has a mirror-polished surface, and is rhodium coated on 1 side, which is the reflecting surface. The reflection rate was measured using He-Ne laser irradiation. The reflection intensity was measured using a laser power meter when the incident angle to the mirror was changed to 60°, 45°, and 30°, and the reflectance was calculated by the direct received light intensity from the laser. After confirming the safety of the fundamental experiment, PDT was performed with this developed mirror on 9 patients with malignant glioma (4 with recurrence and 5 newly diagnosed). RESULTS: The energy efficiency of the mirror was approximately 70 %, and apparent irregular reflection was not observed. Even during clinical use, apparent complications, such as irregular reflection, did not occur upon using the mirror in any of the patients. In all patients, recurrence did not occur in the site where mirror irradiation was performed, but in a deep site or a distant site to which sufficient laser irradiation did not reach. CONCLUSION: PDT using our newly developed mirror involves few instrumental changes compared with the conventional irradiation method, and is effective, safe, and inexpensive.

The Noninvasive Treatment for Sentinel Lymph Node Metastasis by Photodynamic Therapy Using Phospholipid Polymer as a Nanotransporter of Verteporfin.

Aim. The usefulness of photodynamic therapy (PDT) for treating sentinel lymph node (SLN) metastasis was evaluated. Materials and Methods. Verteporfin, a hydrophobic photosensitizer, forms a soluble aggregate with poly(2-methacryloyloxyethyl phosphorylcholine-co-n-butyl methacrylate) (PMB). The concentrations of verteporfin were determined by measuring the fluorescence emitted at 700 nm. Seven days after the inoculation of A431 cells at the forearm of BALB/c nude mice, PMB-verteporfin was injected at dorsum manus and 75 J of light energy was delivered for 1 minute. Fifty-three mice were randomly assigned to the combination of PMB-verteporfin injection and light exposure, light exposure alone, PMB-verteporfin injection alone, and no treatment groups. Ten days after PDT, brachial lymph nodes, which were considered as SLNs, were harvested and evaluated. Results. The concentration of verteporfin in SLN was significantly higher than other organs. The combination of PMB-verteporfin injection and light exposure group significantly reduced the SLN metastasis (13%) comparing with no treatment group (52%), light exposure alone group (57%), and PMB-verteporfin injection alone group (46%). Conclusions. These data suggested that PDT using PMB as a nanotransporter of verteporfin could be a minimally invasive treatment of SLN metastasis in breast cancer and represent a potential alternative procedure to SLNB.

Preliminary study of laser welding for aortic dissection in a porcine model using a diode laser with indocyanine green.

BACKGROUND AND OBJECTIVES: The objective of this study was to determine whether a dissected aorta could be welded by a diode laser with a solder using an in vitro porcine aortic dissection model. STUDY DESIGN/MATERIALS AND METHODS: Porcine aortic strips were dissected into two flaps and the dissected faces were immersed in a solution of indocyanine green. The two flaps were pressed at 0.2 kg/cm2 with contact between the two immersed faces. The pressed flaps were irradiated with a diode laser (810 nm) at intensities of 170-425 W/cm2 for 8 seconds. The welded flaps were studied by light microscopy and the adhesive strengths were measured. RESULTS: The irradiated flaps were successfully welded. The breaking stress, the maximum stress recorded in a stress-strain curve, increased with increase in irradiation intensity up to 396 W/cm2 (2.7 x 10(2) mmHg) and decreased when the intensity reached 425 W/cm2. In the specimen irradiated at 396 W/cm2, the welded faces showed continuous fusion of elastin layers, while some voids were seen between the welded faces in the specimen irradiated at 425 W/cm2. CONCLUSIONS: The dissected porcine aortas were successfully welded using a laser with solder. The results suggest that the welded aorta can bear physiological blood pressure.