Toxicity evaluation of two dental composites: three-dimensional confocal laser scanning microscopy time-lapse imaging of cell behavior.

The purpose of this study was to investigate the in vitro biocompatibility of two dental composites (namely A and B) with similar chemical composition used for direct restoration using three-dimensional confocal laser scanning microscopy (CLSM) time-lapse imaging. Time-lapse imaging was performed on cultured human HGF-1 fibroblast-like cells after staining using Live/Dead®. Image analysis showed a higher mortality rate in the presence of composite A than composite B. The viability rate decreased in a time-dependent manner during the 5 h of exposure. Morphological alterations were associated with toxic effects; cells were enlarged and more rounded in the presence of composite A as shown by F-actin and cell nuclei staining. Resazurin assay was used to confirm the active potential of composites in cell metabolism; results showed severe cytotoxic effects in the presence of both no light-curing composites after 24 h of direct contact. However, extracts of polymerized composites induced a moderate decrease in cell metabolism after the same incubation period. Composite B was significantly better tolerated than composite A at all investigated end points and all time points. The finding confirmed that the used CLSM method was sufficiently sensitive to differentiate the biocompatibility behavior of two composites based on similar methacrylate monomers.

Confocal time lapse imaging as an efficient method for the cytocompatibility evaluation of dental composites.

It is generally accepted that in vitro cell material interaction is a useful criterion in the evaluation of dental material biocompatibility. The objective of this study was to use 3D CLSM time lapse confocal imaging to assess the in vitro biocompatibility of dental composites. This method provides an accurate and sensitive indication of viable cell rate in contact with dental composite extracts. The ELS extra low shrinkage, a dental composite used for direct restoration, has been taken as example. In vitro assessment was performed on cultured primary human gingival fibroblast cells using Live/Dead staining. Images were obtained with the FV10i confocal biological inverted system and analyzed with the FV10-ASW 3.1 Software. Image analysis showed a very slight cytotoxicity in the presence of the tested composite after 5 hours of time lapse. A slight decrease of cell viability was shown in contact with the tested composite extracts compared to control cells. The findings highlighted the use of 3D CLSM time lapse imaging as a sensitive method to qualitatively and quantitatively evaluate the biocompatibility behavior of dental composites.