Femoral nerve compression after migration of bone cement to the groin after hip arthroplasty.

Although often a benign complication of total hip arthroplasty, cement extrusion can cause nerve, vessel, and organ compression. We report the case of a 70-year-old male patient in whom an extruded cement mass migrated anteriorly and compressed the femoral nerve and impinged on the femoral artery producing acute, severe groin pain with neuralgia 9 years postoperatively. Paresthesia of the anterior and medial thigh was found on examination. Radiographic, ultrasound, and computed tomographic studies confirmed a 6 × 1.5-cm mass of bone cement in the right groin compressing the femoral nerve that was removed successfully at surgery. Six months postoperatively, the patient's pain had resolved, but hyperesthesia of the medial thigh remained.

The characteristics of gait in Charcot-Marie-Tooth disease types I and II.

Certain typical gait characteristics such as foot-drop and foot supination are well described in Charcot-Marie-Tooth disease. These are directly related to the primary disease and due to the weakness of ankle dorsiflexors and everters characteristic of this hereditary neuropathy. We analysed 16 subjects aged 8-52 years old (11 with type I, 5 with type II Charcot-Marie-Tooth disease) using three-dimensional gait analysis and identified kinematic features previously unreported. These patients showed a combination of tight tendo achillei, foot-drop, failure of plantar flexion and increased foot supination, but also presented with excessive internal rotation of the knee and/or tibia, knee hyperextension in stance, excessive external rotation at the hips and decreased hip adduction in stance (typical of a broad based gait). These proximal features could have been an adaptation to or consequence of the disrupted ankle and foot biomechanics, however a direct relation to the neuropathy is also possible since sub-normal muscle power was observed at the proximal levels in most subjects on both manual testing and kinetic analysis. Gait analysis is a useful tool in defining the characteristic gait of patients with Charcot-Marie-Tooth disease.

The effect of patient gait on the material properties of UHMWPE in hip replacements.

The wear of ultra-high molecular weight polyethylene (UHMWPE) acetabular components in total hip replacements (THRs) has been shown to be highly dependent on the direction of shear. Greatly reduced wear rates have been reported for unidirectional, compared to multidirectional, articulation in vitro. This work for the first time enables investigation of a relationship between clinical wear conditions, as determined by patient gait path, and the mechanical and structural changes that occur within the UHMWPE acetabular component. Individual patients' wear paths were determined prior to revision operation from hip joint kinematics measured by clinical gait analysis. The material properties of the acetabular components removed during the revision operation were subsequently analysed. A technique using Fourier transform infra- red analysis (FTIR) was developed to quantify the orientation of the individual UHMWPE lamellae. This study shows that there is a direct relationship between a patient's clinical gait path and the molecular properties of their UHMWPE acetabular socket. Patient kinematics are an important factor affecting the wear and long-term biocompatibility of UHMWPE used as a bearing surface in THR.