Novel method for the rapid and specific extraction of multiple ß2 -agonist residues in food by tailor-made Monolith-MIPs extraction disks and detection by gas chromatography with mass spectrometry.

A quick and specific pretreatment method based on a series of extraction clean-up disks, consisting of molecularly imprinted polymer monoliths and C18 adsorbent, was developed for the specific enrichment of salbutamol and clenbuterol residues in food. The molecularly imprinted monolithic polymer disk was synthesized using salbutamol as a template through a one-step synthesis process. It can simultaneously and specifically recognize salbutamol and clenbuterol. The monolithic polymer disk and series of C18 disks were assembled with a syringe to form a set of tailor-made devices for the extraction of target molecules. In a single run, salbutamol and clenbuterol can be specifically extracted, cleaned, and eluted by methanol/acetic acid/H2 O. The target molecules, after a silylation derivatization reaction were detected by gas chromatography-mass spectrometry. The parameters including solvent desorption, sample pH, and the cycles of reloading were investigated and discussed. Under the optimized extraction and clean-up conditions, the limits of detection and quantitation were determined as 0.018-0.022 and 0.042-0.049 ng/g for salbutamol and clenbuterol, respectively. The assay described was convenient, rapid, and specific; thereby potentially efficient in the high-throughput analysis of ß2 -agonists residues in real food samples.

Constructing soybean protein isolate /bacterial cellulose co-assemblies by pH shifting treatment: Molecular conformation and physicochemical properties.

The study elucidates that the pH shifting treatment unfolds the conformation of soybean protein isolate (SPI), enabling it to intertwine with bacterial cellulose (BC) and form SPI/BC co-assemblies. Results from intrinsic fluorescence spectroscopy and surface hydrophobicity indicate that the SPI with pH shifting treatment shows a notable blue shift in maximum emission wavelength and increased surface hydrophobicity. It demonstrates that pH shifting treatment facilitates the unfolding of SPI's molecular conformation, promoting its entanglement with high aspect ratio BC. Particle size distribution and microstructural analysis further demonstrate that the pH shifting treatment facilitates the formation of SPI/BC co-assemblies. Evaluation of processing properties reveals that the SPI/BC co-assemblies exhibited exceptional gel and emulsification properties, with gel strength and emulsifying activity respectively six and two times higher than natural SPI. This enhancement is attributed to the thickening properties of BC with a high aspect ratio and the superior hydrophobicity of SPI in its molten globule state.

Selective dispersive solid phase extraction-chromatography tandem mass spectrometry based on aptamer-functionalized UiO-66-NH2 for determination of polychlorinated biphenyls.

In this paper, a novel dispersive solid phase extraction (dSPE) adsorbent based on aptamer-functionalized magnetic metal-organic framework material was developed for selective enrichment of the trace polychlorinated biphenyls (PCBs) from soil sample. Firstly, we developed a simple, versatile synthetic strategy to prepare highly reproducible magnetic amino-functionalized UiO-66 (Fe3O4@PDA@UiO-66-NH2) by using polydopamine (PDA) as covalent linker. Then amino-functionalized aptamers which can recognize 2,3',5,5'-tetrachlorobiphenyl (PCB72), 2',3',4',5,5'-pentachlorobiphenyl (PCB106) were covalent immobilized on UiO-66-NH2 through coupling reagent of glutaraldehyde. Aptamer-functionalized adsorbent (Fe3O4@PDA@UiO-66-Apt) can specifically capture PCBs from complex matrix with high adsorption capacity based on the specific affinity of aptamer towards target. Moreover, the adsorbent can be easily isolated from the solution through magnetic separation after extraction. Afterwards, the detection was carried out with gas chromatography tandem mass spectrometry (GC-MS). The selective dSPE pretreatment coupled with GC-MS possessed high selectivity, good binding capacity, stability, repeatability and reproducibility for the extraction of PCBs. Furthermore, the adsorbent possessed good mechanical stability which can be applied in replicate at least for 60 extraction cycles with recovery over 80%. It provided a linear range of 0.02-400ngmL(-1) with a good correlation coefficient (R(2)=0.9994-0.9996), and the limit of detection was found to be 0.010-0.015ngmL(-1). The method was successfully utilized for the determination of PCBs in soil samples.

A homogeneous and "off-on" fluorescence aptamer-based assay for chloramphenicol using vesicle quantum dot-gold colloid composite probes.

In this work, a novel homogeneous and signal "off-on" aptamer based fluorescence assay was successfully developed to detect chloramphenicol (CAP) residues in food based on the fluorescence resonance energy transfer (FRET). The vesicle nanotracer was prepared through labeling single stranded DNA binding protein (SSB) on limposome-CdSe/ZnS quantum dot (SSB/L-QD) complexes. It was worth mentioning that the signal tracer (SSB/L-QD) with vesicle shape, which was fabricated being encapsulated with a number of quantum dots and SSB. The nanotracer has excellent signal amplification effects. The vesicle composite probe was formed by combining aptamer labeled nano-gold (Au-Apt) and SSB/L-QD. Which based on SSB's specific affinity towards aptamer. This probe can't emit fluoresce which is in "off" state because the signal from SSB/L-QD as donor can be quenched by the Au-aptas acceptor. When CAP was added in the composite probe solution, the aptamer on the Au-Apt can be preferentially bounded with CAP then release from the composite probe, which can turn the "off" signal of SSB/L-QD tracer into "on" state. The assay indicates excellent linear response to CAP from 0.001 nM to 10 nM and detection limit down to 0.3 pM. The vesicle probes with size of 88 nm have strong signal amplification. Because a larger number of QDs can be labeled inside the double phosphorus lipid membrane. Besides, it was employed to detect CAP residues in the milk samples with results being agreed well with those from ELISA, verifying its accuracy and reliability.

Electro-deposited poly-luminol molecularly imprinted polymer coating on carboxyl graphene for stir bar sorptive extraction of estrogens in milk.

Electrochemical polymerization of luminol molecularly imprinted polymer on carboxyl graphene (MIP/CG) was developed as stir bar sorptive extraction (SBSE) coating for selective pre-concentration and specific recognition of bisphenol A (BPA), hexoestrol and diethylstilbestrol in milk samples. Luminol was employed as monomer and BPA as the template to prepare MIP under 0-0.6V electro-polymerization. Carboxyl graphene was modified on pencil lead as the substrate to increase extraction capacity. The preparation and extraction conditions affecting the extraction efficiency were optimized. Under the optimized conditions, a good linearity of three estrogens was obtained in the range of 4-1000ngmL(-1). The average recoveries at the three spiked levels of the three estrogens ranged from 83.4% to 96.3% with the relative standard deviations (RSD)≤7.1%. The limits of detection were in the range of 0.36-1.09ngmL(-1). The developed method with low cost, high selectivity and good reproducibility can be potentially applied for determining trace estrogens in complex food samples.