Magnetically recoverable Fe3O4@polydopamine nanocomposite as an excellent co-catalyst for Fe3+ reduction in advanced oxidation processes.

Advanced oxidation processes are widely applied to removal of persistent toxic substances from wastewater by hydroxyl radicals (·OH), which is generated from hydrogen peroxide (H2O2) decomposition. However, their practical applications have been hampered by many strict conditions, such as iron sludge, rigid pH condition, large doses of hydrogen peroxide and Fe2+, etc. Herein, a magnetically recyclable Fe3O4@polydopamine (Fe3O4@PDA) core-shell nanocomposite was fabricated. As an excellent reducing agent, it can convert Fe3+ to Fe2+. Combined with the coordination of polydopamine and ferric ions, the production of iron sludge is inhibited. The minimum concentration of hydrogen peroxide (0.2 mmol/L and Fe2+ (0.18 mmol/L)) is 150-fold and 100-fold lower than that of previous reports, respectively. It also exhibits excellent degradation performance over a wide pH range from 3.0 to 9.0. Even after the tenth recycling, it still achieves over 99% degradation efficiency with the total organic carbon degradation rate of 80%, which is environmentally benign and has a large economic advantage. This discovery paves a way for extensive practical application of advanced oxidation processes, especially in environmental remediation.

Preparation and in vitro/in vivo evaluation of azilsartan osmotic pump tablets based on the preformulation investigation.

The objective of this study was to design and evaluate azilsartan osmotic pump tablets. Preformulation properties of azilsartan were investigated for formulation design. Azilsartan osmotic pump tablets were prepared by incorporation of drug in the core and subsequent coating with cellulose acetate and polyethylene glycol 4000 as semi-permeable membrane, then drilled an orifice at the center of one side. The influence of different cores, compositions of semipermeable membrane and orifice diameter on azilsartan release were evaluated. The formulation of core tablet was optimized by orthogonal design and the release profiles of various formulations were evaluated by similarity factor (f2). The optimal formulation achieved to deliver azilsartan at an approximate zero-order up to 14 h. The pharmacokinetic study was performed in beagle dogs. The azilsartan osmotic pump tablets exhibited less fluctuation in blood concentration and higher bioavailability compared to immediate-release tablets. Moreover, there was a good correlation between the in vitro dissolution and in vivo absorption of the tablets. In summary, azilsartan osmotic pump tablets presented controlled release in vitro, high bioavailability in vivo and a good in vitro-in vivo correlation.

Biosafe, self-adhesive, recyclable, tough, and conductive hydrogels for multifunctional sensors.

As a bioelectronic material used in personalized medicine, it is necessary to integrate excellent adhesion and stretchability in hydrogels for ensuring biosafety. Herein, a high-performance multifunctional hydrogel of polyvinyl alcohol-sodium alginate-g-dopamine-silver nanowire-borax (PSAB) is reported. It can not only easily adhere to the surface of various substrates, but also exhibit excellent mechanical properties. Its tensile strength, elongation at break and toughness are 0.286 MPa, 500% and 55.15 MJ m-3, respectively. The excellent mechanical properties and high conductivity guarantee that the PSAB hydrogel can successfully serve as a multifunctional sensor for detecting small activities and large-scale movements of the human body through strain and pressure changes. Meanwhile, the long-lasting potent and broad-spectrum antibacterial activity, combined with good in vitro biocompatibility, guarantees the biological safety and non-toxicity of the PSAB hydrogel. These compelling features, such as high flexibility and elasticity, high adhesion, multi-functional sensing and recyclability, as well as biological safety, pave the way for the application of PSAB hydrogel e-skin in biomedicine.

Antibacterial, Self-Adhesive, Recyclable, and Tough Conductive Composite Hydrogels for Ultrasensitive Strain Sensing.

Owing to the characteristics of mimicking human skin's function and transmitting sensory signals, electronic skin (e-skin), as an emerging and exciting research field, has inspired tremendous efforts in the biomedical field. However, it is frustrating that most e-skins are prone to bacterial infections, resulting a serious threat to human health. Therefore, the construction of e-skin with an integrated perceptual signal and antibacterial properties is highly desirable. Herein, the dynamic supramolecular hydrogel was prepared through a freezing/thawing method by cross-linking the conductive graphene (G), biocompatible polyvinyl alcohol (PVA), self-adhesive polydopamine (PDA), and in situ formation antibacterial silver nanoparticles (AgNPs). Having fabricated the hierarchical network structure, the PVA-G-PDA-AgNPs composite hydrogel with a tensile strength of 1.174 MPa and an elongation of 331% paves way for flexible e-skins. Notably, the PVA-G-PDA-AgNPs hydrogel exhibits outstanding antibacterial activity to typical pathogenic microbes (e.g., Gram-negative Escherichia coli and Gram-positive Staphylococcus aureus), which effectively prevents bacterial infections that harm human health. With self-adhesiveness to various surfaces and excellent conductivity, the PVA-G-PDA-AgNPs composite hydrogel was used as strain sensors to detect a variety of macroscale and microscale human motions successfully. Meanwhile, the excellent rehealing property allows the hydrogel to recycle as a new sensor to detect large-scale human activities or tiny movement. Based on these remarkable features, the antibacterial, self-adhesive, recyclable, and tough conductive composite hydrogels possess the great promising application in biomedical materials.

Accuracy assessment of a novel semiautomatic method evaluating bone grafts around the dental implant: an in vitro and ex vivo study.

The present study aimed to evaluate the accuracy and repeatability of morphological contour interpolation (MCI)-based semiautomatic segmentation method for volumetric measurements of bone grafts around dental implants. Three in vitro (one with a cylinder and two with a geometrically complex form) and four ex vivo models (peri-implant cylinder-shaped bone defect) were created for imitating implant placement with simultaneous guided bone regeneration (GBR) procedure. Cone beam computerized tomography (CBCT) scans of all models were obtained with the same parameters. For volumetric measurements, the actual volumes of bone grafts in models were assessed by computer-aided calculation and both manual and MCI-based methods were utilized as test methods. The accuracy of the methods was evaluated by comparing the measured value and the actual volume. The repeatability was assessed by calculating the coefficients of variation of repeated measurements. For the accuracy of three dimensional (3D) reconstructions, the computer-designed corresponding models were set as the reference and the morphological deviation of 3D surface renderings created by two methods were evaluated by comparing with reference. Besides, measurement time was recorded and a comparison between the two methods was performed. High accuracy of the MCI-based segmentation method was found with a discrepancy between the measured value and actual value never exceeding - 7.5%. The excellent repeatability was shown with coefficients of variation never exceeding 1.2%. The MCI-based method showed less measurement time than the manual method and its 3D surface rendering showed a lower deviation from the reference.

A promising cancer gene therapy agent based on the matrix protein of vesicular stomatitis virus.

The matrix (M) protein of vesicular stomatitis virus (VSV) plays a key role in inducing cell apoptosis during infection. To investigate whether M protein-mediated apoptosis could be used in cancer therapy, its cDNA was amplified and cloned into eukaryotic expression vector pcDNA3.1(+). The recombinant plasmid or the control empty plasmid pcDNA3.1(+) was mixed with cationic liposome and introduced into various tumor cell lines in vitro, including lung cancer cell LLC, A549, colon cancer cell CT26 and fibrosarcoma cell MethA. Our data showed that the M protein induced remarkable apoptosis of cancer cells in vitro compared with controls. Fifty micrograms of plasmid in a complex with 250 microg cationic liposome was injected intratumorally into mice bearing LLC or MethA tumor model every 3 days for 6 times. It was found that the tumors treated with M protein plasmid grew much more slowly, and the survival of the mice was significantly prolonged compared with the mice treated with the control plasmid. In MethA fibrosarcoma, the tumors treated with M protein plasmid were even completely regressed, and the mice acquired longtime protection against the same tumor cell in rechallenge experiments. Both apoptotic cells and CD8(+) T cells were widely distributed in M protein plasmid-treated tumor tissue. Activated cytotoxic T lymphocytes (CTLs) were further detected by means of (51)Cr release assay in the spleen of the treated mice. These results showed that M protein of VSV can act as both apoptosis inducer and immune response initiator, which may account for its extraordinary antitumor effect and warrant its further development in cancer gene therapy.

Molecular and biochemical evidence for phenylpropanoid synthesis and presence of wall-linked phenolics in cotton fibers.

The mature cotton (Gossypium hirsutum L.) fiber is a single cell with a typically thickened secondary cell wall. The aim of this research was to use molecular, spectroscopic and chemical techniques to investigate the possible occurrence of previously overlooked accumulation of phenolics during secondary cell wall formation in cotton fibers. Relative quantitative reverse transcription-polymerase chain reaction analysis showed that GhCAD6 and GhCAD1 were predominantly expressed among seven gene homologs, only GhCAD6 was up-regulated during secondary wall formation in cotton fibers. Phylogenic analysis revealed that GhCAD6 belonged to Class I and was proposed to have a major role in monolignol biosynthesis, and GhCAD1 belonged to Class III and was proposed to have a compensatory mechanism for monolignol biosynthesis. Amino acid sequence comparison showed that the cofactor binding sites of GhCADs were highly conserved with high similarity and identity to bona fide cinnamyl alcohol dehydrogenases. The substrate binding site of GhCAD1 is different from GhCAD6. This difference was confirmed by the different catalytic activities observed with the enzymes. Cell wall auto-fluorescence, Fourier transform infrared spectroscopy (FTIR), high-performance liquid chromatography (HPLC) and chemical analyses confirmed that phenolic compounds were bound to the cell walls of mature cotton fibers. Our findings may suggest a potential for genetic manipulation of cotton fiber properties, which are of central importance to agricultural, cotton processing and textile industries.

Vesicular stomatitis virus matrix protein gene enhances the antitumor effects of radiation via induction of apoptosis.

Vesicular stomatitis virus (VSV) matrix (M) protein can directly induce apoptosis by inhibiting host gene expression when it is expressed in the absence of other viral components. Previously, we found that the M protein gene complexed to DOTAP-cholesterol liposome (Lip-MP) can suppress malignant tumor growth in vitro and in vivo; however, little is known regarding the biological effect of Lip-MP combined with radiation. The present study was designed to determine whether Lip-MP could enhance the antitumor activity of radiation. LLC cells treated with a combination of Lip-MP and radiation displayed apparently increased apoptosis compared with those treated with Lip-MP or radiation alone. Mice bearing LLC or Meth A tumors were treated with intratumoral or intravenous injections of Lip-MP and radiation. The combined treatment significantly reduced mean tumor volumes compared with either treatment alone in both tumor models and prolonged the survival time in Meth A tumor models and the intravenous injection group of LLC tumor models. Moreover, the antitumor effects of Lip-MP combined with radiation were greater than their additive effects when compared with the expected effects of the combined treatment in vivo. This study suggests that Lip-MP enhanced the antitumor activity of radiation by increasing the induction of apoptosis.

Biodegradable balloon-expandable self-locking polycaprolactone stents as buckling explants for the treatment of retinal detachment: an in vitro and in vivo study.

The purpose of this report was to develop biodegradable balloon-expandable self-locking poly(ε-caprolactone) (PCL) stents for the treatment of retinal detachment. To create the biodegradable stents, polycaprolactone components were first fabricated by a laboratory-scale microinjection molding machine. The components were then assembled into mesh-like stents of 6 and 8 mm in diameter. A special geometry of the components was designed to self-lock the assembled stents after being expanded by balloons. Characterization of the biodegradable PCL stents was carried out. PCL stents exhibited comparable mechanical properties with that of silicone sponge. Neither significant amount of collapse pressure reduction nor weight loss of the stents was observed after being submerged in phosphate buffered saline for 30 days. In addition, the stents were also implanted in the episcleral space of 10 New Zealand white rabbits. The stents were placed in radial direction and left unsutured after balloon expansion. The stents achieved an efficient buckling effect in echographic and fundus photographic examinations. The ocular pressure was significantly elevated after stent implantation and gradually normalized after the second week. The computed tomography studies verified the hypothesis of minimal migration of the PCL stents. The in vivo result suggests that balloon-expandable biodegradable stents can potentially serve as an ideal indenting biomaterial in retinal detachment surgery.

Progressive inhibition by water deficit of cell wall extensibility and growth along the elongation zone of maize roots is related to increased lignin metabolism and progressive stelar accumulation of wall phenolics.

Water deficit caused by addition of polyethylene glycol 6000 at -0.5 MPa water potential to well-aerated nutrient solution for 48 h inhibited the elongation of maize (Zea mays) seedling primary roots. Segmental growth rates in the root elongation zone were maintained 0 to 3 mm behind the tip, but in comparison with well-watered control roots, progressive growth inhibition was initiated by water deficit as expanding cells crossed the region 3 to 9 mm behind the tip. The mechanical extensibility of the cell walls was also progressively inhibited. We investigated the possible involvement in root growth inhibition by water deficit of alterations in metabolism and accumulation of wall-linked phenolic substances. Water deficit increased expression in the root elongation zone of transcripts of two genes involved in lignin biosynthesis, cinnamoyl-CoA reductase 1 and 2, after only 1 h, i.e. before decreases in wall extensibility. Further increases in transcript expression and increased lignin staining were detected after 48 h. Progressive stress-induced increases in wall-linked phenolics at 3 to 6 and 6 to 9 mm behind the root tip were detected by comparing Fourier transform infrared spectra and UV-fluorescence images of isolated cell walls from water deficit and control roots. Increased UV fluorescence and lignin staining colocated to vascular tissues in the stele. Longitudinal bisection of the elongation zone resulted in inward curvature, suggesting that inner, stelar tissues were also rate limiting for root growth. We suggest that spatially localized changes in wall-phenolic metabolism are involved in the progressive inhibition of wall extensibility and root growth and may facilitate root acclimation to drying environments.