Twisting electrospun nanofiber fine strips into functional sutures for sustained co-delivery of gentamicin and silver.

Surgical site infections (SSIs) represent the most common nosocomial infection among surgical patients. In order to prevent SSIs in a sustained manner and lessen side effects, we developed a twisting method for generation of nanofiber-based sutures capable of simultaneous delivery of silver and gentamicin. The prepared sutures are composed of core-sheath nanofibers with gentamicin/pluronic F127 in the core and silver/PCL in the sheath produced by co-axial electrospinning. The diameters of obtained sutures range from ~80 µm to ~1.2 mm. The in vitro release profiles of silver and gentamicin exhibit an initial burst followed by a sustained release over 5 weeks. The co-encapsulated sutures were able to kill bacteria much more effectively than gentamicin or silver alone loaded nanofiber sutures, without showing obvious impact on proliferation and migration of dermal fibroblasts and keratinocytes. The gentamicin and silver co-loaded PCL nanofiber sutures may hold great potential for prevention of SSIs.

Slightly acidic electrolyzed water for reducing airborne microorganisms in a layer breeding house.

UNLABELLED: Reducing airborne microorganisms may potentially improve the environment in layer breeding houses. The effectiveness of slightly acidic electrolyzed water (SAEW; pH 5.29-6.30) in reducing airborne microorganisms was investigated in a commercial layer house in northern China. The building had a tunnel-ventilation system, with an evaporative cooling. The experimental area was divided into five zones along the length of the house, with zone 1 nearest to an evaporative cooling pad and zone 5 nearest to the fans. The air temperature, relative humidity, dust concentration, and microbial population were measured at the sampling points in the five zones during the study period. The SAEW was sprayed by workers in the whole house. A six-stage air microbial sampler was used to measure airborne microbial population. Results showed that the population of airborne bacteria and fungi were sharply reduced by 0.71 x 10(5) and 2.82 x 10(3) colony-forming units (CFU) m(-3) after 30 min exposure to SAEW, respectively. Compared with the benzalkonium chloride (BC) solution and povidone-iodine (PVP-I) solution treatments, the population reductions of airborne fungi treated by SAEW were significantly (P < 0.05) more, even though the three disinfectants can decrease both the airborne bacteria and fungi significantly (P < 0.05) 30 min after spraying. IMPLICATIONS: There are no effective methods for reducing airborne microbial levels in tunnel-ventilated layer breeding houses; additionally, there is limited information available on airborne microorganism distribution. This research investigated the spatial distribution of microbial population, and the effectiveness of spraying slightly acidic electrolyzed water in reducing microbial levels. The research revealed that slightly acidic electrolyzed water spray was a potential method for reducing microbial presence in layer houses. The knowledge gained in this research about the microbial population variations in the building may assist producers in managing the bird housing environment and engineers in designing poultry houses.

Diversity and host interaction of the gut microbiota in specific pathogen-free pigs.

Pigs are widely used as animal models in various studies related to humans. The interaction between the gut microbiota and the host has significant effects on the host's health and disease status. However, although there have been many studies investigating the pig gut microbiota, the findings have been inconsistent due to variations in rearing conditions. Interactions between the gut microbiota and host have not been fully explored in pigs. Specific pathogen-free (SPF) pigs are ideal non-primate large animals to study the interactions between the gut microbiota and the host. In this study, we performed high-throughput sequencing analysis of the gut microbiota and the gut tissue transcriptome of six SPF pigs to provide a systematic understanding of the composition, function, and spatial distribution of gut microbiota in SPF pigs. We identified significant differences in microbial diversity and functionality among different gastrointestinal tract sites. Metagenomics data analysis revealed significant differences in alpha diversity and beta diversity of microbiota in different gastrointestinal sites of SPF pigs. Additionally, transcriptomic data indicated significant differences in gene expression as well as KEGG and GO functional enrichment between the small intestine and large intestine. Furthermore, by combining microbial metagenomics and host transcriptomics analyses, specific correlations were found between gut microbiota and host genes. These included a negative correlation between the TCN1 gene and Prevotella dentalis, possibly related to bacterial metabolic pathways involving vitamin B12, and a positive correlation between the BDH1 gene and Roseburia hominis, possibly because both are involved in fatty acid metabolism. These findings lay the groundwork for further exploration of the co-evolution between the microbiota and the host, specifically in relation to nutrition, metabolism, and immunity. In conclusion, we have elucidated the diversity of the gut microbiota in SPF pigs and conducted a detailed investigation into the interactions between the gut microbiota and host gene expression. These results contribute to our understanding of the intricate dynamics between the gut microbiota and the host, offering important references for advancements in life science research, bioproduct production, and sustainable development in animal husbandry.

Porcine urinary bladder matrix-polypropylene mesh: a novel scaffold material reduces immunorejection in rat pelvic surgery.

INTRODUCTION AND HYPOTHESIS: The present study set out to modify polypropylene vaginal surgical material using porcine urinary bladder matrix (UBM) in order to improve biocompatibility. The aim was to develop a compound scaffold that induced less vaginal erosion and to evaluate host immunoreactivity to this material in vivo. METHODS: Forty-eight Sprague-Dawley rats were randomly divided into four equal groups. One group underwent a sham operation, and the other groups underwent vaginal implantation with different materials: UBM (U); UBM + polypropylene (UP); or polypropylene (P). The host tissue response was determined by macro-observation, and by histological and immunohistochemical methods at 7, 14, 21, or 28 days after surgery. RESULTS: The inflammation reaction was strongest throughout the entire observation time in Group P, but was weaker and had a tendency to decrease with time in Groups U and UP. The presence of the UBM material in the compound scaffold allowed the polypropylene to fuse with newly proliferating surrounding tissue and resulted in less rejection of the material by the host, as indicated by the reduced appearance of CD4-, and CD8-positive cells. CONCLUSIONS: Porcine UBM allowed mechanical isolation of polypropylene, and also reduced the immune reaction to polypropylene. This study suggests that the UBM + polypropylene compound scaffold may be a promising material for clinical use in pelvic reconstruction surgery.

[Development of an improved virus plaque assay based on avicel].

Avicel is made of a mixture of microcrystalline cellulose (MCC) and carboxymethyl cellulose (CMC), and used for virus plaque assay. The avicel in common use is produced by FMC Biopolymer. Due to the relatively fixed proportion of MCC and CMC, avicel in common use is not suitable for plaque determination experiment of all types of viruses. In this study, we evaluated the effect of avicel made of different proportions of MCC and CMC on virus plaque assay, and developed an improved avicel virus plaque assay featured with simple and convenient operation, good practicability and high stability. To generate avicel overlays with different proportions of MCC and CMC, twelve different 2×avicel solutions were prepared. Their overall viscosity and bottom viscosity were measured to evaluate the ease of operation. The results showed that most of the 2×avicel solutions (except the 4.8% MCC+1.4% CMC and 4.8% MCC+1.0% CMC group) were easy to absorb and prepare nutrient overlap than 2×CMC solution. In order to find the best scheme to detect the titer of porcine epidemic diarrhea virus (PEDV), these avicel overlay solutions with different proportion of MCC and CMC were used as a replacement in the standard plaque assay. By comparing the size, clarity, stability and titer accuracy of virus plaque, we identified that 0.6% MCC and 0.7% CMC was the most preferable composition of avicel overlay for PEDV plaque assay. In conclusion, we developed an improved virus plaque assay based on avicel, which may facilitate the research of virus etiology, antiviral drugs and vaccines.

Preparation of a small intestinal submucosa modified polypropylene hybrid mesh via a mussel-inspired polydopamine coating for pelvic reconstruction.

Pelvic organ prolapse (POP) is a serious health issue that affects many adult women. Surgical treatments for POP patients comprise a common strategy in which scaffold materials are used to reconstruct the prolapsed pelvic. However, the existing materials for pelvic reconstruction cannot meet clinical requirements in terms of biocompatibility, mechanics and immunological rejection. To address these concerns, polypropylene (PP) mesh was selected because of its strong mechanical properties. Small intestinal submucosa (SIS) was used to modify the PP mesh via a mussel-inspired polydopamine coating to enhance its biocompatibility. The scanning electron microscopy (SEM) and atomic force microscopy (AFM) results demonstrated that SIS was successfully conjugated on the surface of the PP mesh. Moreover, the cytotoxicity results indicated that the PP mesh and SIS-modified PP mesh were safe to use. Furthermore, in vivo tests demonstrated that the fibroplasia around the implanted site in the SIS-modified PP mesh group was significantly less than the fibroplasia around the PP mesh group. In addition, the immunohistochemistry staining results indicated that the expression of pro-inflammatory macrophages (M1) was substantially lower and that the expression of pro-healing macrophages (M2) was higher in the SIS-modified PP mesh group. Furthermore, ELISA detection indicated that the expression of IL-1ß and IL-6 in the SIS-modified PP mesh group was reduced compared with the PP mesh group. These findings suggest that a SIS-modified polypropylene hybrid mesh via a mussel-inspired polydopamine coating is a promising approach in pelvic reconstruction.

Magnetically Guided Fabrication of Multilayered Iron Oxide/Polycaprolactone/Gelatin Nanofibrous Structures for Tissue Engineering and Theranostic Application.

A persistent challenge in tissue engineering is the fabrication of manipulatable scaffolds for implantation in clinical treatments and use in disease models for drug screening. Electrospinning of nanofibrous membranes is an emerging technology in artificial extracellular matrix (ECM) design that can offer precisely tunable microenvironments upon assembly into three-dimensional (3D) scaffolds that mimic the in vivo ECM structure. In this study, we report a facile and versatile strategy for preparing 3D multilayered constructs from Fe3O4/polycaprolactone (PCL)/gelatin nanofibrous membranes. This method combines membrane assembly with noncontact magnetic force to preserve the mechanical integrity and interconnectivity of the 3D scaffolds. An ordered layer structure can be achieved using a magnetic control technique through the addition of magnetic nanoparticles into the PCL/gelatin nanofibers. We first verified the magnetic properties and structures of magnetic nanofibers according to X-ray diffraction, hysteresis, scanning electron microscopy, and transmission electron microscopy. We tested the potential toxicity and osteogenic differentiation of mesenchymal stem cells seeded on the layered scaffolds. To add further functionality to the scaffolds, the membranes were coated with silver nanoparticles and shown to inhibit the growth of Escherichia coli and Staphylococcus aureus, which are responsible for most cases of infection-related implant failure. Finally, we tested the utility of magnetic membranes implanted in an animal model as a contrast agent for magnetic resonance imaging. Scaffolds formed using the presented magnetically guided fabrication strategy have the potential to mimic the structure and function of human tissues and also may be applied in disease models to study cell-cell interactions.

Integration of nondegradable polystyrene and degradable gelatin in a core-sheath nanofibrous patch for pelvic reconstruction.

Pelvic organ prolapse (POP) is a serious health issue affecting many adult women. Complications of POP include pelvic pressure, pelvic pain, and problems in emptying their bowels or bladder. Sometimes, POP may even cause urinary outflow obstruction and lead to bladder or kidney infections. Currently, synthetic and naturally derived materials have been chosen for treatment of POP to reduce the high recurrence rates after surgical interventions. However, existing materials for POP treatment cannot meet the clinical requirements in terms of biocompatibility, mechanics, and minimal risk of rejection. Especially, erosion in synthetic polymers and rapid degradation in natural polymers limit their further applications in clinics. To address these concerns, we report a novel POP replacement using core-sheath polystyrene/gelatin electrospun nanofiber mesh. The outside gelatin sheath provides a hydrophilic surface and implantable integrity between host and guest, while the inner PS core offers the necessary mechanical support. The composite mesh shows graft accommodation in pelvic submucosa after implantation in vivo, as shown in hematoxylin-eosin staining and T helper cell phenotype and macrophage phenotype stainings. Qualitative analysis of inducible nitric oxide synthase, arginase, interferon-γ, and interleukin-10 gene expressions also indicates that the implanted composite mesh switches to accommodation mode 2 weeks postimplantation. Thus, these novel core-sheath polystyrene/gelatin nanofibrous membranes are promising in pelvic reconstruction.

Layer-by-layer paper-stacking nanofibrous membranes to deliver adipose-derived stem cells for bone regeneration.

Bone tissue engineering through seeding of stem cells in three-dimensional scaffolds has greatly improved bone regeneration technology, which historically has been a constant challenge. In this study, we researched the use of adipose-derived stem cell (ADSC)-laden layer-by-layer paper-stacking polycaprolactone/gelatin electrospinning nanofibrous membranes for bone regeneration. Using this novel paper-stacking method makes oxygen distribution, nutrition, and waste transportation work more efficiently. ADSCs can also secrete multiple growth factors required for osteogenesis. After the characterization of ADSC surface markers CD29, CD90, and CD49d using flow cytometry, we seeded ADSCs on the membranes and found cells differentiated, with significant expression of the osteogenic-related proteins osteopontin, osteocalcin, and osteoprotegerin. During 4 weeks in vitro, the ADSCs cultured on the paper-stacking membranes in the osteogenic medium exhibited the highest osteogenic-related gene expressions. In vivo, the paper-stacking scaffolds were implanted into the rat calvarial defects (5 mm diameter, one defect per parietal bone) for 12 weeks. Investigating with microcomputer tomography, the ADSC-laden paper-stacking membranes showed the most significant bone reconstruction, and from a morphological perspective, this group occupied 90% of the surface area of the defect, produced the highest bone regeneration volume, and showed the highest bone mineral density of 823.06 mg/cm(3). From hematoxylin and eosin and Masson staining, the new bone tissue was most evident in the ADSC-laden scaffold group. Using quantitative polymerase chain reaction analysis from collected tissues, we found that the ADSC-laden paper-stacking membrane group presented the highest osteogenic-related gene expressions of osteocalcin, osteopontin, osteoprotegerin, bone sialoprotein, runt-related transcription factor 2, and osterix (two to three times higher than the control group, and 1.5 times higher than the paper-stacking membrane group in all the genes). It is proposed that ADSC-laden layer-by-layer paper-stacking scaffolds could be used as a way of promoting bone defect treatment.