RESUMO
OBJECTIVE: The study addresses the long-standing challenge of insufficient length in vascularized fibular flaps when reconstructing large mandibular defects that require dual-barrel grafts. Employing personalized 3D-printed osteotomy guides, the study aims to optimize fibular utilization and minimize the required graft length. MATERIAL AND METHODS: Two reconstruction methods for distal bone defects were compared: a fold-down (FD) group that employed a specialized osteotomy guide for folding down a triangular bone segment, and a traditional double-barrel (DB) group. Metrics for comparison included defect and graft lengths, as well as the graft-to-defect length ratio. Postoperative quality of life was assessed using the University of Washington Quality of Life questionnaire (UW-QoL). RESULT: Both FD and DB groups achieved successful mandibular reconstruction. Despite larger defects in the FD group (117 ± 31.35 mm vs 84 ± 35.34 mm, p = 0.028), the used fibula length was not statistically longer in the FD group. The median ratio of graft-to-defect length was also lower in the FD group (1.327 vs 1.629, p = 0.024), suggesting that FD required only 82.47% of the graft length needed in the DB approach. Quality of life scores post-surgery were comparable between the groups. CONCLUSION: Personalized 3D-printed osteotomy guides enhance fibula graft efficacy for reconstructing larger mandibular defects, necessitating shorter graft lengths while preserving postoperative quality of life. CLINICAL RELEVANCE: This study confirms the utility of 3D printing technology as an effective and precise tool in orthopedic surgery, particularly for complex reconstructions like large mandibular defects. It suggests a viable alternative that could potentially revolutionize current practices in bone grafting.