Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 3 de 3
Filtrar
Mais filtros

Base de dados
Tipo de documento
País de afiliação
Intervalo de ano de publicação
1.
J Anat ; 244(4): 628-638, 2024 04.
Artigo em Inglês | MEDLINE | ID: mdl-38168875

RESUMO

Odontocetes primarily rely on fish, cephalopods, and crustaceans as their main source of nutrition. In the digestive system, their polygastric complex exhibits similarities to that of their closest terrestrial relatives such as cows, sheep, and giraffes, while the entero-colic tract shares similarities with terrestrial carnivores. The morphology, caliber, and structure of the odontocete intestine are relatively constant, and, since there is no caecum, a distinction between the small and large intestine and their respective subdivisions is difficult. To address this issue, we used the intestinal vascularization pattern, specifically the course and branching of the celiac artery (CA) and the cranial and caudal mesenteric arteries (CrMA and CdMA). A series of pictures and dissections of 10 bottlenose dolphins (Tursiops truncatus) were analyzed. Additionally, we performed a cast by injecting colored polyurethane foam in both arteries and veins to measure the caliber of the arteries and clarify their monopodial or dichotomous branching. Our results showed the presence of multiple duodenal arteries (DAs) detaching from the CA. The CrMA gave origin to multiple jejunal arteries, an ileocolic artery (ICA), and, in six cases, a CdMA. In four specimens, the CdMA directly originated from the abdominal aorta. The ICA gave rise to the mesenteric ileal branches (MIB) and mesenteric anti-ileal branches and the right colic arteries (RCA) and the middle colic arteries. From the CdMA originated the left colic and cranial rectal arteries (LCA and CrRA). The measurements revealed a mixed monopodial and dichotomous branching scheme. The analysis of the arteries and their branching gave us an instrument, based on comparative anatomy, to distinguish between the different intestinal compartments. We used the midpoint of anastomoses between MIB and RCA to indicate the border between the small and the large intestine, and the midpoint of anastomoses between LCA and CrRA, to tell the colon from the rectum. This pattern suggested an elongation of the duodenum and a shortening of the colic tract that is still present in this species. These findings might be related to the crucial need to possess a long duodenal tract to digest prey ingested whole without chewing. A short aboral part is also functional to avoid gas-producing colic fermentation. The rare origin of the CdMA on the CrMA might instead be a consequence of the cranial thrust of the abdominopelvic organs related to the loss of the pelvic girdle that occurred during the evolution of cetaceans.


Assuntos
Golfinho Nariz-de-Garrafa , Cólica , Feminino , Animais , Bovinos , Ovinos , Intestinos , Artérias Mesentéricas/anatomia & histologia , Veias
2.
Surg Endosc ; 23(4): 885-9, 2009 Apr.
Artigo em Inglês | MEDLINE | ID: mdl-19116748

RESUMO

BACKGROUND: Endoscopic methods to prevent gastroesophageal reflux (GER) show scarce effectiveness and may narrow the esophageal lumen more or less stiffly, sometimes impairing bolus transit and leading to dysphagia. The aim of this study was to demonstrate the possibility of reinforcing lower esophageal sphincter (LES) tone by implanting endoluminally a magnetic device. MATERIALS AND METHODS: The device consists of two small magnetic plaques to be implanted in the submucosa close to LES with opposite polarities facing so that they attract one other, closing the esophageal lumen. The magnets were implanted by means of a special endoluminal device in five esophageal-gastric ex vivo specimens taken from swine. Variation in endoluminal pressure at the LES level was measured by means of slow pull-through of a thin side-hole manometric catheter in each specimen, before and after insertion of the magnets. RESULTS: The new high-pressure zone exhibited a length of about 2 cm and a pressure of 14.2+/-1.27 mmHg [mean +/- standard deviation (SD)], significantly (p<0.001) higher than that measured before insertion of the magnetic valve (1.5+/-0.26 mmHg). CONCLUSIONS: The present research demonstrates that it is possible to create at the LES level a dynamic closure of a value considered sufficient to prevent GER, by implanting in the esophageal submucosa of anatomical specimens a magnetic device by means of a special endoluminal probe. Once effectiveness and tolerability of magnets covered by a biocompatible sheath have been demonstrated in vivo, this device could become a simple and effective nonsurgical solution to GER.


Assuntos
Materiais Biocompatíveis , Endoscopia Gastrointestinal/métodos , Esfíncter Esofágico Inferior/cirurgia , Refluxo Gastroesofágico/prevenção & controle , Magnetismo/instrumentação , Implantação de Prótese/métodos , Animais , Modelos Animais de Doenças , Desenho de Equipamento , Esfíncter Esofágico Inferior/fisiopatologia , Pressão , Suínos , Resultado do Tratamento
3.
Anat Sci Int ; 89(4): 255-65, 2014 Sep.
Artigo em Inglês | MEDLINE | ID: mdl-24788383

RESUMO

The objective of the present study was to verify if polyurethane foam is a suitable material to make accurate casts of vessels and viscera, and to develop a method based on its use for anatomical studies. This new technique has been tested primarily on the lungs of different animals, but also on the renal, intestinal and equine digital vessels. It consisted of three steps: specimen preparation, injection of the foam and corrosion of the cast. All structures injected with foam were properly filled. The bronchial tree and the vessels could be observed up to their finer branches. The method is inexpensive, simple and requires no special equipment. The pre-casting procedure does not require perfusion of the specimens with formalin, or prolonged flushing with carbon dioxide gas or air for drying. The polyurethane foam does not need a catalyst. It is simply diluted with acetone, which does not cause shrinkage of the cast due to evaporation during hardening. The foam naturally expands into the cavities without high pressure of the inoculum, and hardens in just 2 or 3 h at room temperature. Only two drawbacks were observed. The first is the fact that multiple injections cannot be made in the same cavity since the foam solidifies quickly; the second is the slight brittleness of the cast, due to the low elasticity of polyurethane foam. In conclusion, polyurethane foam was a suitable material for producing accurate casts of vessels and viscera.


Assuntos
Molde por Corrosão/métodos , Modelos Anatômicos , Poliuretanos , Acetona , Animais , Gatos , Cães , Formaldeído , Cavalos , Fatores de Tempo
SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA