RESUMO
In this paper, chloramphenicol was selected as a model drug to prepare in situ gels. The intrinsic dissolution rate of chloramphenicol from in situ gel was evaluated using the surface dissolution imaging system. The results indicated that intrinsic dissolution rate of chloramphenicol thermosensitive in situ gel decreased significantly when the poloxamer concentration increased. The addition of the thickener reduced the intrinsic dissolution rate of chloramphenicol thermosensitive gel, wherein carbomer had the most impact. Different dilution ratios of simulated tear fluid greatly affected gel temperature, and had little influence on the intrinsic dissolution rate of chloramphenicol from the thermosensitive in situ gel. The pH of simulated tear fluid had little influence on the intrinsic dissolution rate of chloramphenicol thermosensitive in situ gel. For the pH sensitive in situ gel, the dissolution rates of chloramphenicol in weak acidic and neutral simulated tear fluids were slower than that in weak alkaline simulated tear fluid. In conclusion, the intrinsic dissolution of chloramphenicol from in situ gel was dependent on formulation and physiological factors. With advantages of small volume sample required and rapid detection, the UV imaging method can be an efficient tool for the evaluation of drug release characteristics of ophthalmic in situ gel.
Assuntos
Antibacterianos/química , Cloranfenicol/química , Sistemas de Liberação de Medicamentos , Soluções Oftálmicas/química , Resinas Acrílicas/química , Antibacterianos/administração & dosagem , Cloranfenicol/administração & dosagem , Géis/química , Concentração de Íons de Hidrogênio , Poloxâmero/química , Solubilidade , Espectrofotometria Ultravioleta , Temperatura , ViscosidadeRESUMO
In this study the traditional Chinese medicine compound recipe (TCMCR) Shuxiong sustained-release capsules (SXSRC) were prepared by multiparticulate time-controlled explosion technology. First, Shuxiong pellets were prepared with the refined medicinal materials containing in the recipe of Shuxiong tablets. Then, the pellets were coated sequentially with an inner swelling layer containing low-substituted hydroxypropylcellulose as the swelling agent and an outer rupturable layer of ethylcellulose. Finally, SXSRC were developed by encapsulating five kinds of pellets whose respective coating level of outer layer was 0%, 9%, 15%, 18% and 20% at equivalent ratio in hard gelatin capsules. Under the simulated gastrointestinal pH conditions, the in vitro release test of SXSRC was carried out. The value of similarity factor (f2) of hydroxysafflor yellow A and Panax notoginseng saponins, hydroxysafflor yellow A and ferulic acid, Panax notoginseng saponins and ferulic acid was 90.1, 77.3, 87.0, respectively. The release profiles of these three compositions from SXSRC showed a characteristic of obvious sustained-release and no significant difference between them. The results indicated that using multiparticulate time-controlled explosion technology various components in TCMCR with vastly different physicochemical properties could be released synchronously while sustained-releasing. That complies with the organic whole conception of compound compatibility of TCMCR.
Assuntos
Medicamentos de Ervas Chinesas/administração & dosagem , Cápsulas , Carthamus , Celulose/análogos & derivados , Celulose/química , Chalcona/análogos & derivados , Química Farmacêutica , Ácidos Cumáricos/análise , Preparações de Ação Retardada , Composição de Medicamentos , Medicamentos de Ervas Chinesas/química , Excipientes , Ligusticum , Panax notoginseng , Quinonas , Dodecilsulfato de Sódio , Solubilidade , Soluções , Comprimidos com Revestimento EntéricoRESUMO
OBJECTIVE: To evaluate the self-microemulsifying ability and dissolution behavior of pueraria lobata isoflavone in vitro and the pharmacokinetic behavior in rats. METHODS: The self-microemulsifying rate was evaluated by the self-microemulsifying time and the self-microemulsifying efficiency was evaluated by the particle size of resultant microemulsions. The plasma concentrations were evaluated by HPLC and dissolution and pharmacokinetic behavior of self-microemulsifying drug delivery systems were evaluated by comparison with commercial tablets. RESULTS: The system was self-microemulsified in 2 min and the particle size was less than 50 nm. The dis- solution of SMESC in distilled water was more than 90% at 10 min, while those of the commercial tablet were less than 50% at 120 min. 82% increase in the relative bioavailability was observed for the self microemulsifying drug delivery systems compared with Yufengningxin tablets. Tmax was smaller in the self-microemulsifying drug delivery systems compared with Yufengningxin tablets. CONCLUSION: The self-microemulsifying drug delivery systems can increase drug dissolution in vitro and absorption in vivo significantly.
Assuntos
Sistemas de Liberação de Medicamentos , Medicamentos de Ervas Chinesas/administração & dosagem , Isoflavonas/administração & dosagem , Pueraria/química , Administração Oral , Animais , Área Sob a Curva , Disponibilidade Biológica , Medicamentos de Ervas Chinesas/química , Medicamentos de Ervas Chinesas/farmacocinética , Emulsificantes/química , Emulsões , Isoflavonas/química , Isoflavonas/farmacocinética , Masculino , Tamanho da Partícula , Polissorbatos/química , Ratos , Ratos Wistar , Solubilidade , Fatores de TempoRESUMO
OBJECTIVE: To prepare a sustained-release formulation of traditional Chinese medicine compound recipe by adopting time-controlled release techniques. METHOD: Shuxiong tablets were chosen as model drug. The prescription and technique of core tablets were formulated with selecting disintegrating time and swelling volume of core tablets in water as index. The time-controlled release tablets were prepared by adopting press-coated techniques, using PEG6000, HCO and EVA as coating materials. The influences of compositions, preparation process and dissolution conditions in vitro on the lag time (T(lag)) of drug release were investigated. RESULT: The composition of core tablets was as follow: 30% of drug, 50% MCC and 20% CMS-Na. The T(lag) of time-controlled release tablets was altered remarkably by PEG6000 content of the outer layer, the amount of outer layer and hardness of tablet. The viscosity of dissolution media and basket rotation had less influence on the T(lag) but more on rate of drug release. CONCLUSION: The core tablets pressed with the optimized composition had preferable swelling and disintegrating properties. The shuxiong sustained-release formulations which contained core tablet and two kinds of time-controlled release tablets with 3 h and 6 h of T(lag) could release drug successively at 0 h, 3 h and 6 h in vitro. The technique made it possible that various components with extremely different physicochemical properties in these preparations could release synchronously.
Assuntos
Composição de Medicamentos/métodos , Medicamentos de Ervas Chinesas/administração & dosagem , Plantas Medicinais , Carthamus tinctorius/química , Óleo de Rícino/análogos & derivados , Preparações de Ação Retardada , Combinação de Medicamentos , Medicamentos de Ervas Chinesas/química , Medicamentos de Ervas Chinesas/isolamento & purificação , Dureza , Concentração de Íons de Hidrogênio , Ligusticum/química , Panax notoginseng/química , Plantas Medicinais/química , Polietilenoglicóis , Povidona/análogos & derivados , ComprimidosRESUMO
OBJECTIVE: To prepare shuxiong micropellets. METHOD: Shuxiong micropellets were prepared by using a centrifugal granulator. The formulation composition and process factors were optimized investigated by adopting several indices such as size distribution, repose angle, bulk density and friability as indexes. RESULT: The optimal process parameters were as follows. The ratio of fine intermediate product and MCC was 3:1 (w/w), the adhesive agent was 3% HMPC solution, the rotating rate of plate was 200 r x min(-1), the blower rate was 15 x 20 L x min(-1), the rate of air flow was 15 L x min(-1), the spray air pressure was 0.5 MPa, the rotating of spray solution pump was 5-25 r x min(-1) and the rotating rate of powder feed machine was 5-25 r x min(-1). CONCLUSION: Under the optimal conditions, micropellets prepared by using centrifugal granulator hadpossessed prefect shape and surface characteristics and the yield of shuxiong pellets was 90.5%.
Assuntos
Chalcona/análogos & derivados , Ginsenosídeos/administração & dosagem , Fenóis/administração & dosagem , Plantas Medicinais/química , Quinonas/administração & dosagem , Tecnologia Farmacêutica/métodos , Carthamus tinctorius/química , Celulose , Centrifugação/métodos , Chalcona/administração & dosagem , Chalcona/isolamento & purificação , Combinação de Medicamentos , Excipientes , Ginsenosídeos/isolamento & purificação , Derivados da Hipromelose , Ligusticum/química , Metilcelulose/análogos & derivados , Microesferas , Panax notoginseng/química , Tamanho da Partícula , Fenóis/isolamento & purificação , Quinonas/isolamento & purificaçãoRESUMO
AIM: To compare lipophilicity measuring scale stemmed from immobilized artificial membrane chromatography and n-octanol/buffer systems. METHODS: A test set consisted of 27 structurally diverse compounds. The lipophilicity of these were evaluated by both immobilized artificial membrane chromatography (IAMC) and n-octanol/buffer systems, which were expressed as lg kIAM and lg DO/W,7.4, respectively. RESULTS: With regard to each individual group, good correlation coefficient (r2) over 0.81 was obtained (0.82 for acid; 0.88 for neutral, 0.81 for base and 0.92 for ampholyte, respectively). However, a smaller r2 (0.62) was acquired for all compounds studied than that of each individual group. CONCLUSION: IAMC and n-octanol/buffer systems were shown to be different in lipophilicity.
Assuntos
Cromatografia Líquida de Alta Pressão/métodos , Lipídeos/química , Membranas Artificiais , Octanóis/química , Preparações Farmacêuticas/química , Soluções Tampão , Interações Hidrofóbicas e Hidrofílicas , Fosfolipídeos/químicaRESUMO
AIM: To investigate the interaction between drugs and ordered phospholipid membrane using immobilized artificial membrane chromatography (IAMC). METHODS: IAMC was used to determine the interaction drugs with phospholipid membrane, expressed as membrane affinity (lg kIAM). An n-octanol/buffer system was also employed as the reference hydrophobicity (lg Do/w,7.4). RESULTS: Within the range of used acetonitrile percentages (phi) 0-30% in mobile phase, retention index (lg kIAM) showed excellent correlation with phi. Intercepts of fitted straight lines between lg kIAM and phi were comparable but slopes were much different for the three organic modifiers (acetonitrile, ethanol and methanol). Effects by adding CH2 substituent on lipophilicity difference (delta lg kIAM and delta lg Do/w,7.4) were similar for p-hydroxyl benzoic methyl ester to butyl ester, whereas different for p-hydroxylbenzoic acid to methyl ester. CONCLUSION: IAMC system is a convenient, efficient and rapid tool for determining membrane interaction.
Assuntos
Membranas Artificiais , Preparações Farmacêuticas/química , Fosfolipídeos/química , Octanóis/químicaRESUMO
BACKGROUND: Nowadays, many cytotoxic anticancer drugs exhibit low solubility and poor tumor selectivity, which means that the drug formulation is very important. For example, in the case of paclitaxel (PTX), Cremophor EL(®) (BASF, Ludwigshafen, Germany) needs to be used as a solubilizer in its clinical formulation (Taxol(®), Bristol-Myers Squibb, New York, NY), although it can cause serious side effects. Nanomicellar systems are promising carriers to resolve the above problems, and the polymer chosen is the key element. METHODS: In this study, a novel amphiphilic chitosan/vitamin E succinate (CS-VES) copolymer was successfully synthesized for self-assembling polymeric micelles. Proton nuclear magnetic resonance spectroscopy and infrared were used to characterize the molecular structure of the copolymer. The PTX-loaded CS-VES polymeric micelles (PTX-micelles) were characterized by dynamic light scattering, transmission electron microscopy, X-ray diffraction, and differential scanning calorimetry. RESULTS: The critical micelle concentration of CS-VES was about 12.6 µg/mL, with the degree of amino group substitution being 20.4%. PTX-micelles were prepared by a nanoprecipitation/dispersion technique without any surfactant being involved. PTX-micelles exhibited a drug loading as high as 21.37% and an encapsulation efficiency of 81.12%, with a particle size ranging from 326.3 to 380.8 nm and a zeta potential of +20 mV. In vitro release study showed a near zero-order sustained release, with 51.06%, 50.88%, and 44.35% of the PTX in the micelles being released up to 168 hours at three drug loadings of 7.52%, 14.09%, and 21.37%, respectively. The cellular uptake experiments, conducted by confocal laser scanning microscopy, showed an enhanced cellular uptake efficiency of the CS-VES micelles in MCF-7 cells compared with Taxol. The PTX-micelles exhibited a comparable but delayed cytotoxic effect compared with Taxol against MCF-7 cells, due to the sustained-release characteristics of the nanomicelles. More interestingly, blank nanomicelles based on CS-VES copolymer demonstrated significant cytotoxicity against MCF-7 cells. CONCLUSION: The supramolecular micellar aggregates based on CS-VES copolymer is a promising nanocarrier and efficacy enhancer when used as an anticancer drug-delivery system.