Disintegration of Waste Activated Sludge by Thermally-Activated Persulfates for Enhanced Dewaterability.

Oxidation by persulfates at elevated temperatures (thermally activated persulfates) disintegrates bacterial cells and extracellular polymeric substances (EPS) composing waste-activated sludge (WAS), facilitating the subsequent sludge dewatering. The WAS disintegration process by thermally activated persulfates exhibited different behaviors depending on the types of persulfates employed, that is, peroxymonosulfate (PMS) versus peroxydisulfate (PDS). The decomposition of PMS in WAS proceeded via a two-phase reaction, an instantaneous decomposition by the direct reaction with the WAS components followed by a gradual thermal decay. During the PMS treatment, the WAS filterability (measured by capillary suction time) increased in the initial stage but rapidly stagnated and even decreased as the reaction proceeded. In contrast, the decomposition of PDS exhibited pseudo first-order decay during the entire reaction, resulting in the greater and steadier increase in the WAS filterability compared to the case of PMS. The treatment by PMS produced a high portion of true colloidal solids (<1 µm) and eluted soluble and bound EPS, which is detrimental to the WAS filterability. However, the observations regarding the dissolved organic carbon, ammonium ions, and volatile suspended solids collectively indicated that the treatment by PMS more effectively disintegrated WAS compared to PDS, leading to higher weight (or volume) reduction by postcentrifugation.

Combination of cupric ion with hydroxylamine and hydrogen peroxide for the control of bacterial biofilms on RO membranes.

Combinations of Cu(II) with hydroxylamine (HA) and hydrogen peroxide (H2O2) (i.e., Cu(II)/HA, Cu(II)/H2O2, and Cu(II)/HA/H2O2 systems) were investigated for the control of P. aeruginosa biofilms on reverse osmosis (RO) membranes. These Cu(II)-based disinfection systems effectively inactivated P. aeruginosa cells, exhibiting different behaviors depending on the state of bacterial cells (planktonic or biofilm) and the condition of biofilm growth and treatment (normal or pressurized condition). The Cu(II)/HA and Cu(II)/HA/H2O2 systems were the most effective reagents for the inactivation of planktonic cells. However, these systems were not effective in inactivating cells in biofilms on the RO membranes possibly due to the interactions of Cu(I) with extracellular polymeric substances (EPS), where biofilms were grown and treated in center for disease control (CDC) reactors. Different from the results using CDC reactors, in a pressurized cross-flow RO filtration unit, the Cu(II)/HA/H2O2 treatment significantly inactivated biofilm cells formed on the RO membranes, successfully recovering the permeate flux reduced by the biofouling. The pretreatment of feed solutions by Cu(II)/HA and Cu(II)/HA/H2O2 systems (applied before the biofilm formation) effectively mitigated the permeate flux decline by preventing the biofilm growth on the RO membranes.