Visualization of photothermal therapy by semiconducting polymer dots mediated photoacoustic detection in NIR II.

Visualization of photothermal therapy mediated by photothermal transduction agents (PTAs) is important to promote individual treatment of patients with low side effects. Photoacoustic detection has emerged as a promising noninvasive method for the visualization of PTAs distribution but still has limitations in temperature measurement, including poor measurement accuracy and low tissue penetration depth. In this study, we developed biocompatible semiconducting polymer dots (SPD) for in situ coupling of photothermal and photoacoustic detection in the near-infrared II window. SPD has dual photostability under pulsed laser and continuous-wave laser irradiation with a photothermal conversion efficiency of 42.77%. Meanwhile, a strong correlation between the photoacoustic signal and the actual temperature of SPD can be observed. The standard deviation of SPD-mediated photoacoustic thermometry can reach 0.13 °C when the penetration depth of gelatin phantom is 9.49 mm. Preliminary experimental results in vivo show that SPD-mediated photoacoustic signal has a high signal-to-noise ratio, as well as good performance in temperature response and tumor enrichment. Such a study not only offers a new nanomaterial for the visualization of photothermal therapy but will also promote the theranostic platform for clinical applications.

NIR-II Absorbing Semiconducting Polymer-Triggered Gene-Directed Enzyme Prodrug Therapy for Cancer Treatment.

Exploration of facile strategies for precise regulation of target gene expression remains highly challenging in the development of gene therapies. Especially, a stimuli-responsive nanocarrier integrated with ability of noninvasive remote control for treating wide types of cancers is rarely developed. Herein, a NIR-II absorbing semiconducting polymer (PBDTQ) is employed to remotely activate the heat-inducible heat-shock protein 70 (HSP70) promoter under laser irradiation, further realizing regulation of gene-directed enzyme prodrug therapy (GDEPT) for cancer treatment in mild hyperthermia. In this multifunctional nanocomposite, the PBDTQ and double suicide gene plasmid (pSG) based on HSP70 promoter are incorporated into a lipid complex. Upon NIR-II laser excitation, the mild photothermal effect (≈43 °C) generated from PBDTQ can cause the release of pSG and activation of HSP70 promoter, and then upregulate suicide gene expression triggered by the HSP70 promoter which can further convert the nontoxic prodrug into its cytotoxic metabolites. Therefore, this work demonstrates a universal NIR-II laser-triggered GDEPT using semiconducting polymers as the photothermal generator for cancer treatment with minimized collateral damage and nontargeted side effects.

An Ester-Substituted Semiconducting Polymer with Efficient Nonradiative Decay Enhances NIR-II Photoacoustic Performance for Monitoring of Tumor Growth.

Photoacoustic agents have been of vital importance for improving the imaging contrast and reliability against self-interference from endogenous substances. Herein, we synthesized a series of thiadiazoloquinoxaline (TQ)-based semiconducting polymers (SPs) with a broad absorption covering from NIR-I to NIR-II regions. Among them, the excited s-BDT-TQE, a repeating unit of SPs, shows a large dihedral angle and narrow adiabatic energy as well as low radiative decay, attributing to its strongly electron-deficient ester-substituted TQ-segment. In addition, its more vigorous molecular motions trigger a higher reorganization energy that further yields an efficient photoinduced nonradiative decay, which has been carefully examined and understood by theoretical calculation. Thus, BDT-TQE SP-cored nanoparticles with twisted intramolecular charge transfer (TICT) feature exhibit a high NIR-II photothermal conversion efficiency (61.6 %) and preferable PA tracking of in situ hepatic tumor growth for more than 20 days. This study highlights a unique strategy for constructing efficient NIR-II photoacoustic agents via TICT-enhanced PNRD effect, advancing their applications for in vivo bioimaging.

Synthesis and application of lignin-based copolymer LSAA on controlling non-point source pollution resulted from surface runoff.

In this article, alkali lignin separated from paper pulp waste was grafted into a novel copolymer LSAA (a copolymer of lignin, starch, acrylamide, and acrylic acid). Its practical application effect and environmental safety were studied. The results of field simulation experiment indicated that the application of LSAA significantly affected the output of the runoff and pollutants. The runoff quantity was decreased by 16.67%-47.00% and the loads of total suspended solids (TSS), chemical oxygen demand (COD), total nitrogen (TN), and total phosphorus (TP) were reduced by 17.78%-62.14%, 26.32%-59.91%, 15.25%-47.42%, and 22.18%-52.78%, respectively. The tests on its environmental safety showed that LSAA did no harm the soil. Compared with polyacrylamide (PAM), a dominant product in this field, LSAA exhibited similar effects and cheap cost. Thus, this study not only created a new product for controlling runoff water quality but also offered a beneficial application for industrial paper waste.

Anti-fouling ultrafiltration membrane prepared from polysulfone-graft-methyl acrylate copolymers by UV-induced grafting method.

Membrane fouling is one of the most important challenges faced in membrane ultrafiltration operations. The copolymers of polysulfone-graft-methyl acrylate were synthesized by homogeneous photo-initiated graft copolymerization. The variables affecting the degree of grafting, such as the time of UV (Ultraviolet-visible) irradiation and the concentrations of the methyl acrylate and photoinitiator, were investigated. The graft copolymer membranes were prepared by the phase inversion method. The chemical and morphological changes were characterized by attenuated total reflection-Fourier transform infrared spectroscopy (ATR/FT-IR), scanning electron microscopy, and water contact angles measurements. Results revealed that methyl acrylate groups were present on the membranes and the graft degree of methyl acrylate had remarkable effect on the performance of membranes. Pure water contact angle on the membrane surface decreases with the increase of methyl acrylate graft degree, which indicated that the hydrophilicity of graft copolymer membranes was improved. The permeation fluxes of pure water and bovine serum albumin solution were measured to evaluate the antifouling property of graft copolymer membranes, the results of which have shown an enhancement of antifouling property for graft copolymer membranes.

Ultravilolet-radiation-induced graft polymerization of acrylamide onto the melt-blown polypropylene filter element by dynamic method.

By dynamic method under UV irradiation, commercial melt-blown polypropylene (PPMB) filter element was modified with acrylamide (AAm) using benzophenone (BP) as initiator. Attenuated total reflection-Fourier transform infrared spectroscopy and scanning electron microscope verified that polyacrylamide chain was grafted on the fiber surface of PPMB filter element. Elemental content analysis with energy dispersive X-ray of fibers revealed that the polymerization content in the inner part of filter element was relatively higher than that in the outer. Degree of grafting changed with initiator concentration, monomer concentration, reaction temperature and reached 2.6% at the reaction condition: CBP=0.06 mol/L, CAAm=2.0 mol/L, irradiation time: 80 min, temperature: 600 degrees C. Relative water flux altered with the hydrophilicity and pore size of filter element. In the antifouling test, the modified filter gave greater flux recovery (approximately 70%) after filtration of the water extract of Liuweidihuang, suggesting that the fouling layer was more easily reversible due to the hydrophilic nature of the modified filter.